Concurrent enhancement of percolation and synchronization in adaptive networks

Co-evolutionary adaptive mechanisms are not only ubiquitous in nature, but also beneficial for the functioning of a variety of systems. We here consider an adaptive network of oscillators with a stochastic, fitness-based, rule of connectivity, and show that it self-organizes from fragmented and incoherent states to connected and synchronized ones. The synchronization and percolation are associated to abrupt transitions, and they are concurrently (and significantly) enhanced as compared to the non-adaptive case. Finally we provide evidence that only partial adaptation is sufficient to determine these enhancements. Our study, therefore, indicates that inclusion of simple adaptive mechanisms can efficiently describe some emergent features of networked systems' collective behaviors, and suggests also self-organized ways to control synchronization and percolation in natural and social systems

In-situ Magnesium Diboride Superconducting Thin Films grown by Pulsed Laser Deposition

Superconducting thin films of MgB2 were deposited by Pulsed Laser Deposition on magnesium oxide and sapphire substrates. Samples grown at 450C in an argon buffer pressure of about 10-2 mbar by using a magnesium enriched target resulted to be superconducting with a transition temperature of about 25 K. Film deposited from a MgB2 sintered pellet target in ultra high vacuum conditions showed poor metallic or weak semiconducting behavior and they became superconducting only after an ex-situ annealing in Mg vapor atmosphere. Up to now, no difference in the superconducting properties of the films obtained by these two procedures has been evidenced.Comment: 10 pages, 4 figure

Oxide two-dimensional electron gas with high mobility at room-temperature

The prospect of 2‐dimensional electron gases (2DEGs) possessing high mobility at room temperature in wide‐bandgap perovskite stannates is enticing for oxide electronics, particularly to realize transparent and high‐electron mobility transistors. Nonetheless only a small number of studies to date report 2DEGs in BaSnO(3)‐based heterostructures. Here, 2DEG formation at the LaScO(3)/BaSnO(3) (LSO/BSO) interface with a room‐temperature mobility of 60 cm(2) V(−1) s(−1) at a carrier concentration of 1.7 × 10(13) cm(–2) is reported. This is an order of magnitude higher mobility at room temperature than achieved in SrTiO(3)‐based 2DEGs. This is achieved by combining a thick BSO buffer layer with an ex situ high‐temperature treatment, which not only reduces the dislocation density but also produces a SnO(2)‐terminated atomically flat surface, followed by the growth of an overlying BSO/LSO interface. Using weak beam dark‐field transmission electron microscopy imaging and in‐line electron holography technique, a reduction of the threading dislocation density is revealed, and direct evidence for the spatial confinement of a 2DEG at the BSO/LSO interface is provided. This work opens a new pathway to explore the exciting physics of stannate‐based 2DEGs at application‐relevant temperatures for oxide nanoelectronics

Twitter-based analysis of the dynamics of collective attention to political parties

Large-scale data from social media have a significant potential to describe complex phenomena in the real world and to anticipate collective behaviors such as information spreading and social trends. One specific case of study is represented by the collective attention to the action of political parties. Not surprisingly, researchers and stakeholders tried to correlate parties' presence on social media with their performances in elections. Despite the many efforts, results are still inconclusive since this kind of data is often very noisy and significant signals could be covered by (largely unknown) statistical fluctuations. In this paper we consider the number of tweets (tweet volume) of a party as a proxy of collective attention to the party, identify the dynamics of the volume, and show that this quantity has some information on the election outcome. We find that the distribution of the tweet volume for each party follows a log-normal distribution with a positive autocorrelation of the volume over short terms, which indicates the volume has large fluctuations of the log-normal distribution yet with a short-term tendency. Furthermore, by measuring the ratio of two consecutive daily tweet volumes, we find that the evolution of the daily volume of a party can be described by means of a geometric Brownian motion (i.e., the logarithm of the volume moves randomly with a trend). Finally, we determine the optimal period of averaging tweet volume for reducing fluctuations and extracting short-term tendencies. We conclude that the tweet volume is a good indicator of parties' success in the elections when considered over an optimal time window. Our study identifies the statistical nature of collective attention to political issues and sheds light on how to model the dynamics of collective attention in social media

Correlation between the bath composition and nanoporosity of DC-electrodeposited Ni-Fe alloy

The outstanding mechanical strength of as-deposited DC-electrodeposited nanocrystalline (nc) Ni-Fe alloys has been the subject of numerous researches in view of their scientific and practical interest. However, recent studies have reported a dramatic drop in ductility upon annealing above 350°C, associated with a concomitant abnormal rapid grain growth. The inherent cause has been ascribed to the presence of a detrimental product or by product in the bath, which affects either the microstructure or causes defects in the concentration and/or distribution of the as-deposited films. The present work has been inspired by the observed abnormal behaviour of annealed electrodeposited nc Ni-Fe alloy, which has here been addressed by considering the relationship between the composition of the bath (iron-chloride, nickel-sulphate solution, saccharin and ascorbic acid) and deposition defects (e.g. grain boundary pores) in the case of an nc Ni-Fe (Fe 48 wt%) alloy. The current investigations have included X-ray photoelectron spectroscopy (XPS), field emission scanning electron microscopy (FESEM) and transmission electron microscopy (TEM) in both as-deposited and post-annealed conditions (300°C–400°C). XPS depth profiling with Ar ion sputtering showed a significant amount of C and O impurities entrapped in the foils during deposition. As such impurities are often overlooked in common analytical techniques, new scenarios may need to be rationalised to explain the observed drop in tensile ductility of the as-deposited Ni-Fe alloys

Phase Dependent Thermopower in Andreev Interferometers

We report measurements of the thermopower S of mesoscopic Andreev interferometers, which are hybrid loops with one arm fabricated from a superconductor (Al), and one arm from a normal metal (Au). S depends on the phase of electrons in the interferometer, oscillating as a function of magnetic flux with a period of one flux quantum (= h/2e). The magnitude of S increases as the temperature T is lowered, reaching a maximum around T = 0.14 K, and decreases at lower temperatures. The symmetry of S oscillations with respect to magnetic flux depends on the topology of the sample.Comment: 4 pages, 4 figure

Anisotropic Dirac fermions in a Bi square net of SrMnBi2

We report the highly anisotropic Dirac fermions in a Bi square net of SrMnBi2, based on a first principle calculation, angle resolved photoemission spectroscopy, and quantum oscillations for high-quality single crystals. We found that the Dirac dispersion is generally induced in the (SrBi)+ layer containing a double-sized Bi square net. In contrast to the commonly observed isotropic Dirac cone, the Dirac cone in SrMnBi2 is highly anisotropic with a large momentum-dependent disparity of Fermi velocities of ~ 8. These findings demonstrate that a Bi square net, a common building block of various layered pnictides, provide a new platform that hosts highly anisotropic Dirac fermions.Comment: 5 pages, 4 figure

Polarity control of carrier injection at ferroelectric/metal interfaces for electrically switchable diode and photovoltaic effects

We investigated a switchable ferroelectric diode effect and its physical mechanism in Pt/BiFeO3/SrRuO3 thin-film capacitors. Our results of electrical measurements support that, near the Pt/BiFeO3 interface of as-grown samples, a defective layer (possibly, an oxygen-vacancy-rich layer) becomes formed and disturbs carrier injection. We therefore used an electrical training process to obtain ferroelectric control of the diode polarity where, by changing the polarization direction using an external bias, we could switch the transport characteristics between forward and reverse diodes. Our system is characterized with a rectangular polarization hysteresis loop, with which we confirmed that the diode polarity switching occurred at the ferroelectric coercive voltage. Moreover, we observed a simultaneous switching of the diode polarity and the associated photovoltaic response dependent on the ferroelectric domain configurations. Our detailed study suggests that the polarization charge can affect the Schottky barrier at the ferroelectric/metal interfaces, resulting in a modulation of the interfacial carrier injection. The amount of polarization-modulated carrier injection can affect the transition voltage value at which a space-charge-limited bulk current-voltage (J-V) behavior is changed from Ohmic (i.e., J ~ V) to nonlinear (i.e., J ~ V^n with n \geq 2). This combination of bulk conduction and polarization-modulated carrier injection explains the detailed physical mechanism underlying the switchable diode effect in ferroelectric capacitors.Comment: Accepted for publication in Phys. Rev.