Workshop on Cosmogenic Nuclides

Abstracts of papers presented at the Workshop on Cosmogenic Nuclides are compiled. The major topic areas covered include: new techniques for measuring nuclides such as tandem accelerator and resonance mass spectrometry; solar modulation of cosmic rays; pre-irradiation histories of extraterrestrial materials; terrestrial studies; simulations and cross sections; nuclide production rate calculations; and meteoritic nuclides

Simulation of cosmic irradiation conditions in thick target arrangements

One approach to simulate 2-pi irradiation conditions of planetary surfaces which has been widely applied in the past are bombardments of so called thick targets. A very large thick target was exposed recently to 2.1 GeV protons at the Bevatron-Bevalac in Berkeley. In a 100x100x180 cm steel-surrounded granodiorite target radioactive medium and high energy spallation products of the incident primary and of secondary particles were analyzed along the beam axis down to depths of 140 g/cm(2) in targets such as Cu, Ni, Co, Fe, T, Si, SiO2 and Al. Activities of these nuclides were exclusively determined via instrumental gamma-ray spectroscopy. Relative yields of neutron capture and spallation products induced in Co and Cu targets during the thick target bombardment are shown as a function of depth. The majority of the medium energy products such as Co-58 from Co targets exhibit a maximum at shallow depths of 40-60 g/cm(2) and then decrease exponentially. In a comparable 600 MeV proton bombarded thick target such a slight maximum for medium energy products was not observed. Rather, Co-58 activities in Co decreased steadily with the highest activity at the surface. The activities of the n-capture product Co-60 increase steadily starting at the surface. This indicates the rapidly growing flux of low energy neutrons within the target

Simulation experiments for gamma-ray mapping of planetary surfaces: Scattering of high-energy neutrons

The concentration and distribution of certain elements in surface layers of planetary objects specify constraints on models of their origin and evolution. This information can be obtained by means of remote sensing gamma-ray spectroscopy, as planned for a number of future space missions, i.e., Mars, Moon, asteroids, and comets. To investigate the gamma-rays made by interactions of neutrons with matter, thin targets of different composition were placed between a neutron-source and a high-resolution germanium spectrometer. Gamma-rays in the range of 0.1 to 8 MeV were accumulated. In one set of experiments a 14-MeV neutron generator using the T(d,n) reaction as neutron-source was placed in a small room. Scattering in surrounding walls produced a spectrum of neutron energies from 14 MeV down to thermal. This complex neutron-source induced mainly neutron-capture lines and only a few scattering lines. As a result of the set-up, there was a considerable background of discrete lines from surrounding materials. A similar situation exists under planetary exploration conditions: gamma-rays are induced in the planetary surface as well as in the spacecraft. To investigate the contribution of neutrons with higher energies, an experiment for the measurement of prompt gamma radiation was set up at the end of a beam-line of an isochronous cyclotron

Cosmogenic nuclides in cometary materials: Implications for rate of mass loss and exposure history

As planned, the Rosetta mission will return to earth with a 10-kg core and a 1-kg surface sample from a comet. The selection of a comet with low current activity will maximize the chance of obtaining material altered as little as possible. Current temperature and level of activity, however, may not reliably indicate previous values. Fortunately, from measurements of the cosmogenic nuclide contents of cometary material, one may estimate a rate of mass loss in the past and perhaps learn something about the exposure history of the comet. Perhaps the simplest way to estimate the rate of mass loss is to compare the total inventories of several long-lived cosmogenic radionuclides with the values expected on the basis of model calculations. Although model calculations have become steadily more reliable, application to bodies with the composition of comets will require some extension beyond the normal range of use. In particular, the influence of light elements on the secondary particle cascade will need study, in part through laboratory irradiations of volatile-rich materials. In the analysis of cometary data, it would be valuable to test calculations against measurements of short-lived isotopes

Анализ социальных медиа

The experimental electron-density distributions in crystals of five chain polymers [M(μ-X)2(py)2] (M = Zn, Cd; X = Cl, Br; py = 3,5-substituted pyridine) have been obtained from high-resolution X-ray diffraction data sets (sin θ/λ > 1.1 Å−1) at 100 K. Topological analyses following Bader's `Atoms in Molecules' approach not only confirmed the existence of (3, −1) critical points for the chemically reasonable and presumably strong covalent and coordinative bonds, but also for four different secondary interactions which are expected to play a role in stabilizing the polymeric structures which are unusual for Zn as the metal center. These weaker contacts comprise intra- and inter-strand C—H⋯X—M hydrogen bonds on the one hand and C—X⋯X—C interhalogen contacts on the other hand. According to the experimental electron-density studies, the non-classical hydrogen bonds are associated with higher electron density in the (3, −1) critical points than the halogen bonds and hence are the dominant interactions both with respect to intra- and inter-chain contacts

Minimal qubit tomography

We present, and analyze thoroughly, a highly symmetric and efficient scheme for the determination of a single-qubit state, such as the polarization properties of photons emitted by a single-photon source. In our scheme there are only four measured probabilities, just enough for the determination of the three parameters that specify the qubit state, whereas the standard procedure would measure six probabilities.Comment: 14 pages, 10 figures; final versio

The density matrix in the de Broglie-Bohm approach

If the density matrix is treated as an objective description of individual systems, it may become possible to attribute the same objective significance to statistical mechanical properties, such as entropy or temperature, as to properties such as mass or energy. It is shown that the de Broglie-Bohm interpretation of quantum theory can be consistently applied to density matrices as a description of individual systems. The resultant trajectories are examined for the case of the delayed choice interferometer, for which Bell appears to suggest that such an interpretation is not possible. Bell's argument is shown to be based upon a different understanding of the density matrix to that proposed here.Comment: 15 pages, 4 figure

ЯКІВ ДМИТРОВИЧ ГРАХОВ – ДІЯЧ КУЛЬТУРИ ТА ОСВІТИ В КАТЕРИНОСЛАВСЬКІЙ ГУБЕРНІЇ

Розглянуто життєвий шлях, освітянську, наукову та музеєзнавчу діяльність директора Катеринославської гімназії та училищ краю Якова Дмитровича Грахова в середині ХІХ ст.The article covers life, scientific and museum activities of Yakiv Dmitrovych Grakhov, a director of Katerinoslav schools in the middle of the 19th centuary

Measurement of Particle Parameters in Thermal Spray Systems

Particle parameters are important in the optimization of plasma and flame spray processes that involve fine powders. Such processes include plasma and flame spraying, spheroidizing, and chemical processes in which the material is introduced in the form of fine powders or the final product is in the form of a fine powder, e.g. plasma synthesis of ceramics. To fully characterize the particle flow field, it is necessary to measure the particle size, velocity, and number density. In many cases, it is necessary to measure simultaneously several parameters that are strongly coupled such as particle size and temperature, or size and velocity. In this paper we will describe a laser based measurement technique for simultaneously obtaining the in-flight size, velocity, and temperature of small particles entrained in a flow field

Quantitative complementarity in two-path interferometry

The quantitative formulation of Bohr's complementarity proposed by Greenberger and Yasin is applied to some physical situations for which analytical expressions are available. This includes a variety of conventional double-slit experiments, but also particle oscillations, as in the case of the neutral-kaon system, and Mott scattering of identical nuclei. For all these cases, a unified description can be achieved including a new parameter, $\nu$, which quantifies the effective number of fringes one can observe in each specific interferometric set-up.Comment: 11 RevTex pages, 5 figure