temporary implementation and testing of a confocal sr μxrf system for bone analysis at the x ray fluorescence beamline at elettra

Abstract The confocal μ XRF spectrometer of Atominstitut (ATI) was transported and set up at the X-ray Fluorescence beamline at Elettra - Sincrotrone Trieste. It was successfully adjusted to the incoming beam (9.2 keV). Test measurements on a free-standing Cu wire were performed to determine the size of the focused micro-beam (non-confocal mode, 56 × 35 μ m 2 ) and the size of the confocal volume (confocal mode, 41 × 24 × 34 μ m 2 ) for the Cu–K α emission. In order to test the setup's capabilities, two areas on different human bone samples were measured in confocal scanning mode. For one of the samples the comparison with a previous μ XRF measurement, obtained with a low power X-ray tube in the lab, is presented

Fast, multi-band photon detectors based on quantum well devices for beam-monitoring in new generation light sources

In order to monitor the photon-beam position for both diagnostics and calibration purposes, we have investigated the possibility to use InGaAs/InAlAs Quantum Well (QW) devices as position-sensitive photon detectors for Free-Electron Laser (FEL) or Synchrotron Radiation (SR). Owing to their direct, low-energy band gap and high electron mobility, such QW devices may be used also at Room Temperature (RT) as fast multi-band sensors for photons ranging from visible light to hard X-rays. Moreover, internal charge-amplification mechanism can be applied for very low signal levels, while the high carrier mobility allows the design of very fast photon detectors with sub-nanosecond response times. Segmented QW sensors have been preliminary tested with 100-fs-wide 400 nm laser pulses and X-ray SR. The reported results indicate that these devices respond with 100 ps rise-times to such ultra-fast laser pulses. Besides, linear scan on the back-pixelated device has shown that these detectors are sensitive to the position of each ultrashort beam bunch

Development of criteria und procedures for the evaluation of the European Action Plan of Organic Food and Farming

Within the EU funded project ORGAP a toolbox for the evaluation of the European as well as national action plans for organic food and farming has been developed (www.orgap.org). This toolbox was based on a comparative analysis of national action plans in eight countries (CH, UK, DE, IT, DK, SI, CZ, NL, ES), a meta-evaluation of existing evaluations of national action plans, workshops with national stakeholders and a European Advisory Committee, interviews with experts. Furthermore synergies and conflicts between national and the European Action Plan were identified

Lessons learnt from ORGAP Project – planning, implementation and evaluation of Action Plans for Organic Food and Farming

Within the EU funded project ORGAP, a toolbox was developed for the evaluation of the European as well as national action plans for organic food and farming. Also recommendations and a resource manual for policy makers and stakeholders were developed. These were based on the analysis of national Organic Action Plans as well as stakeholder and expert consultation. The analysis showed that several EU member states have emphasised the need to balance supply-push policies with more market-focused demand-pull policies. An integrated approach is required and this has been to differing degrees through the formulation of multi-functional Organic Action Plans (OAPs), which also adress the dual roles of organic farming (from a policy perspective) to provide public goods and satisfy consumer demand. Eight Organic Action Plans, reviewed in the ORGAP project, vary with regard to the elaboration process, targets, objectives and the emphasis of measures on certain areas (e.g. market versus environment orientation). This variation is due to quite different political and socio-economic framework conditions for organic farming in these countries. It revealed that the weaknesses identified in the status quo analysis of the organic sector have only partly been translated to the targets and measures included in the action plan documents. Definition of the priorities for development of organic agriculture must be agreed by all relevant stakeholders. The priorities, and hence the programmes, will depend on correct analysis of the issues (and conflicts) that need to be addressed and clear objectives with measurable outcomes (for effective evaluation). For more information on the project, on the practical project manual and the evaluation toolbox for Organic Action Plans see project website www.orgap.or

Foliar lead uptake by lettuce exposed to atmospheric fallouts

Metal uptake by plants occurs by soil−root transfer but also by direct transfer of contaminants from the atmosphere to the shoots. This second pathway may be particularly important in kitchen gardens near industrial plants. The mechanisms of foliar uptake of lead by lettuce (Lactuca sativa) exposed to the atmospheric fallouts of a lead-recycling plant were studied. After 43 days of exposure, the thoroughly washed leaves contained 335 ± 50 mg Pb kg−1 (dry weight). Micro-X-ray fluorescence mappings evidenced Pb-rich spots of a few hundreds of micrometers in diameter located in necrotic zones. These spots were more abundant at the base of the central nervure. Environmental scanning electron microscopy coupled with energy dispersive X-ray microanalysis showed that smaller particles (a few micrometers in diameter) were also present in other regions of the leaves, often located beneath the leaf surface. In addition, submicrometric particles were observed inside stomatal openings. Raman microspectrometry analyses of the leaves identified smelter-originated Pb minerals but also secondary phases likely resulting from the weathering of original particles. On the basis of these observations, several pathways for foliar lead uptake are discussed. A better understanding of these mechanisms may be of interest for risk assessment of population exposure to atmospheric metal contamination

Interaction between a bisphosphonate, tiludronate, and biomimetic nanocrystalline apatites.

Bisphosphonates (BPs) are well established as successful antiresorptive agents for the prevention and treatment of bone diseases such as osteoporosis and Paget's disease. The aim of this work was to clarify the reaction mechanisms between a BP molecule, tiludronate, and the nanocrystalline apatite surface. The adsorption of tiludronate on well characterized synthetic biomimetic nanocrystalline apatites with homogeneous but different compositions and surface characteristics was investigated to determine the effect of the nanocrystalline apatite substrate on the adsorption behavior. The results show that the adsorption of tiludronate on nanocrystalline biomimetic apatite surfaces varies over a large range. The most immature apatitic samples exhibited the highest affinity and the greatest amount adsorbed at saturation. Maturation of the nanocrystals induces a decrease of these values. The amount of phosphate ion released per adsorbed BP molecule varied, depending on the nanocrystalline substrate considered. The adsorption mechanism, although associated with a release of phosphate ions, cannot be considered as a simple ion exchange process involving one or two phosphate ions on the surface. A two-step process is proposed consisting of a surface binding of BP groups to calcium ions associated with a proton release inducing the protonation of surface orthophosphate ions and their eventual solubilization

Study of ultrathin Pt/Co/Pt trilayers modified by nanosecond XUV pulses from laser-driven plasma source

We have studied the structural mechanisms responsible for the magnetic reorientation between in-plane and out-of-plane magnetization in the (25 nm Pt)/(3 and 10 nm Co)/(3 nm Pt) trilayer systems irradiated with nanosecond XUV pulses generated with laser-driven gas-puff target plasma source of a narrow continuous spectrum peaked at wavelength of 11 nm. The thickness of individual layers, their density, chemical composition and irradiation-induced lateral strain were deduced from symmetric and asymmetric X-ray diffraction (XRD) patterns, grazing-incidence X-ray reflectometry (GIXR), grazing incidence X-ray fluorescence (GIXRF), extended X-ray absorption fine structure (EXAFS) and transmission electron microscopy (TEM) measurements. In the as grown samples we found, that the Pt buffer layers are relaxed and that the layer interfaces are sharp. As a result of a quasi-uniform irradiation of the samples, the XRD, EXAFS, GIXR and GIXRF data reveal the formation of two distinct layers composed of Pt1-xCox alloys with different Co concentrations, dependent on the thickness of the as grown magnetic Co film but with similar ∼1% lateral tensile residual strain. For smaller exposure dose (lower number of accumulated pulses) only partial interdiffusion at the interfaces takes place with the formation of a tri-layer composed of Co-Pt alloy sandwiched between thinned Pt layers, as revealed by TEM. The structural modifications are accompanied by magnetization changes, evidenced by means of magneto-optical microscopy. The difference in magnetic properties of the irradiated samples can be related to their modification in Pt1-xCox alloy composition, as the other parameters (lateral strain and alloy thickness) remain almost unchanged. The out-of-plane magnetization observed for the sample with initially 3 nm Co layer can be due to a significant reduction of demagnetization factor resulting from a lower Co concentration

A multipurpose experimental facility for advanced X-ray Spectrometry applications

Ponencia presentada en la European Conference on X-Ray Spectrometry (EXRS). 2014Motivation, Ultra High Vacuum Chamber (UHVC) project: To support/enhance the training of scientists/engineers from developing countries in the operation of synchrotron radiation instrumentation; To provide beam time access for R&D projects and hands-on training in SR-XRS based techniques; To promote networking and knowledge sharing; To increase the quality and the competitiveness of the developing countries to apply beam time proposals at SR facilities; To contribute in the further development of XRS techniques in applications with socioeconomicalrelevance (characterization of energy storage/conversion materials, environmental, biological and biomedical applications)Fil: Leani, Juan José. Universidad Nacional de Córdoba. Facultad de Matemática, Astronomía y Física; Argentina.Fil: Leani, Juan José. Nuclear Science and Instrumentation Laboratory, IAEA Laboratories; Austria.Física Atómica, Molecular y Química (física de átomos y moléculas incluyendo colisión, interacción con radiación, resonancia magnética, Moessbauer Efecto.

Reassessing associations between white matter and behaviour with multimodal microstructural imaging

Several studies have established specific relationships between White Matter (WM) and behaviour. However, these studies have typically focussed on fractional anisotropy (FA), a neuroimaging metric that is sensitive to multiple tissue properties, making it difficult to identify what biological aspects of WM may drive such relationships. Here, we carry out a pre-registered assessment of WM-behaviour relationships in 50 healthy individuals across multiple behavioural and anatomical domains, and complementing FA with myelin-sensitive quantitative MR modalities (MT, R1, R2∗). Surprisingly, we only find support for predicted relationships between FA and behaviour in one of three pre-registered tests. For one behavioural domain, where we failed to detect an FA-behaviour correlation, we instead find evidence for a correlation between behaviour and R1. This hints that multimodal approaches are able to identify a wider range of WM-behaviour relationships than focusing on FA alone. To test whether a common biological substrate such as myelin underlies WM-behaviour relationships, we then ran joint multimodal analyses, combining across all MRI parameters considered. No significant multimodal signatures were found and power analyses suggested that sample sizes of 40-200 may be required to detect such joint multimodal effects, depending on the task being considered. These results demonstrate that FA-behaviour relationships from the literature can be replicated, but may not be easily generalisable across domains. Instead, multimodal microstructural imaging may be best placed to detect a wider range of WM-behaviour relationships, as different MRI modalities provide distinct biological sensitivities. Our findings highlight a broad heterogeneity in WM's relationship with behaviour, suggesting that variable biological effects may be shaping their interaction