Searching for physics beyond the Standard Model in the decay B+ -> K+K+pi-

The observation potential of the decay B+ -> K+K+pi- with the ATLAS detector at LHC is described in this paper. In the Standard Model this decay mode is highly suppressed, while in models beyond the Standard Model it could be significantly enhanced. To improve the selection of the K+K+pi- final state, a charged hadron identification using Time-over-Threshold measurements in the ATLAS Transition Radiation Tracker was developed and used.Comment: 12 pages, 4 figures, 1 tabl

Audio Features Affected by Music Expressiveness

Within a Music Information Retrieval perspective, the goal of the study presented here is to investigate the impact on sound features of the musician's affective intention, namely when trying to intentionally convey emotional contents via expressiveness. A preliminary experiment has been performed involving $10$ tuba players. The recordings have been analysed by extracting a variety of features, which have been subsequently evaluated by combining both classic and machine learning statistical techniques. Results are reported and discussed.Comment: Submitted to ACM SIGIR Conference on Research and Development in Information Retrieval (SIGIR 2016), Pisa, Italy, July 17-21, 201

Information dynamics: patterns of expectation and surprise in the perception of music

This is a postprint of an article submitted for consideration in Connection Science © 2009 [copyright Taylor & Francis]; Connection Science is available online at:http://www.tandfonline.com/openurl?genre=article&issn=0954-0091&volume=21&issue=2-3&spage=8

CP violation in the inclusive b -> s g decay in the framework of multi Higgs doublet models

We study the decay width and CP asymmetry of the inclusive process b--> s g (g denotes gluon) in the multi Higgs doublet models with complex Yukawa couplings, including next to leading QCD corrections. We analyse the dependencies of the decay width and CP asymmetry on the scale \mu and CP violating parameter \theta. We observe that there exist an enhancement in the decay width and CP asymmetry is at the order of 10^{-2}.Comment: 11 pages, 8 Figure

P-Type Silicon Strip Sensors for the new CMS Tracker at HL-LHC

Peer reviewe

JNK1 controls adult hippocampal neurogenesis and imposes cell-autonomous control of anxiety behaviour from the neurogenic niche

Promoting adult hippocampal neurogenesis is expected to induce neuroplastic changes that improve mood and alleviate anxiety. However, the underlying mechanisms remain largely unknown and the hypothesis itself is controversial. Here we show that mice lacking Jnk1, or c-Jun N-terminal kinase (JNK) inhibitor-treated mice, display increased neurogenesis in adult hippocampus characterized by enhanced cell proliferation and survival, and increased maturation in the ventral region. Correspondingly, anxiety behaviour is reduced in a battery of tests, except when neurogenesis is prevented by AraC treatment. Using engineered retroviruses, we show that exclusive inhibition of JNK in adult-born granule cells alleviates anxiety and reduces depressive-like behaviour. These data validate the neurogenesis hypothesis of anxiety. Moreover, they establish a causal role for JNK in the hippocampal neurogenic niche and anxiety behaviour, and advocate targeting of JNK as an avenue for novel therapies against affective disorders.Peer reviewe

Comparative evaluation of analogue front-end designs for the CMS Inner Tracker at the High Luminosity LHC

Publisher Copyright: © 2021 CERN for the benefit of the CMS collaboration..The CMS Inner Tracker, made of silicon pixel modules, will be entirely replaced prior to the start of the High Luminosity LHC period. One of the crucial components of the new Inner Tracker system is the readout chip, being developed by the RD53 Collaboration, and in particular its analogue front-end, which receives the signal from the sensor and digitizes it. Three different analogue front-ends (Synchronous, Linear, and Differential) were designed and implemented in the RD53A demonstrator chip. A dedicated evaluation program was carried out to select the most suitable design to build a radiation tolerant pixel detector able to sustain high particle rates with high efficiency and a small fraction of spurious pixel hits. The test results showed that all three analogue front-ends presented strong points, but also limitations. The Differential front-end demonstrated very low noise, but the threshold tuning became problematic after irradiation. Moreover, a saturation in the preamplifier feedback loop affected the return of the signal to baseline and thus increased the dead time. The Synchronous front-end showed very good timing performance, but also higher noise. For the Linear front-end all of the parameters were within specification, although this design had the largest time walk. This limitation was addressed and mitigated in an improved design. The analysis of the advantages and disadvantages of the three front-ends in the context of the CMS Inner Tracker operation requirements led to the selection of the improved design Linear front-end for integration in the final CMS readout chip.Peer reviewe

Selection of the silicon sensor thickness for the Phase-2 upgrade of the CMS Outer Tracker

Publisher Copyright: © 2021 CERN.During the operation of the CMS experiment at the High-Luminosity LHC the silicon sensors of the Phase-2 Outer Tracker will be exposed to radiation levels that could potentially deteriorate their performance. Previous studies had determined that planar float zone silicon with n-doped strips on a p-doped substrate was preferred over p-doped strips on an n-doped substrate. The last step in evaluating the optimal design for the mass production of about 200 m2 of silicon sensors was to compare sensors of baseline thickness (about 300 μm) to thinned sensors (about 240 μm), which promised several benefits at high radiation levels because of the higher electric fields at the same bias voltage. This study provides a direct comparison of these two thicknesses in terms of sensor characteristics as well as charge collection and hit efficiency for fluences up to 1.5 × 1015 neq/cm2. The measurement results demonstrate that sensors with about 300 μm thickness will ensure excellent tracking performance even at the highest considered fluence levels expected for the Phase-2 Outer Tracker.Peer reviewe

Identification of Clostridium species and DNA fingerprinting of Clostridium perfringens by amplified fragment length polymorphism analysis

An amplified fragment length polymorphism (AFLP) method was applied to 129 strains representing 24 different Clostridium species, with special emphasis on pathogenic clostridia of medical or veterinary interest, to assess the potential of AFLP for identification of clostridia. In addition, the ability of the same AFLP protocol to type clostridia at the strain level was assessed by focusing on Clostridium perfringens strains. All strains were typeable by AFLP, so the method seemed to overcome the problem of extracellular DNase production. AFLP differentiated all Clostridium species tested, except for Clostridium ramosum and Clostridium limosum, which clustered together with a 45% similarity level. Other Clostridium species were divided into species-specific clusters or occupied separate positions. Wide genetic diversity was observed among Clostridium botulinum strains, which were divided into seven species-specific clusters. The same AFLP protocol was also suitable for typing C. perfringens at the strain level. A total of 29 different AFLP types were identified for 37 strains of C. perfringens; strains initially originating from the same isolate showed identical fingerprinting patterns and were distinguished from unrelated strains. AFLP proved to be a highly reproducible, easy-to-perform, and relatively fast method which enables high throughput of samples and can serve in the generation of identification libraries. These results indicate that the AFLP method provides a promising tool for the identification and characterization of Clostridium species