28 research outputs found
Limited clinical efficacy of azacitidine in transfusion-dependent, growth factor-resistant, low- and Int-1-risk MDS:Results from the nordic NMDSG08A phase II trial
This prospective phase II study evaluated the efficacy of azacitidine (Aza) + erythropoietin (Epo) in transfusion-dependent patients with lower-risk myelodysplastic syndrome (MDS). Patients ineligible for or refractory to full-dose Epo + granulocyte colony stimulation factors for 48 weeks and a transfusion need of ≥ 4 units over 8 weeks were included. Aza 75mgm -2 d-1, 5/28 days, was given for six cycles; non-responding patients received another three cycles combined with Epo 60 000 units per week. Primary end point was transfusion independence (TI). All patients underwent targeted mutational screen for 42 candidate genes. Thirty enrolled patients received ≥ one cycle of Aza. Ten patients discontinued the study early, 7 due to adverse events including 2 deaths. Thirty-eight serious adverse events were reported, the most common being infection. Five patients achieved TI after six cycles and one after Aza + Epo, giving a total response rate of 20%. Mutational screening revealed a high frequency of recurrent mutations. Although no single mutation predicted for response, SF3A1 (n = 3) and DNMT3A (n = 4) were only observed in nonresponders. We conclude that Aza can induce TI in severely anemic MDS patients, but efficacy is limited, toxicity substantial and most responses of short duration. This treatment cannot be generally recommended in lower-risk MDS. Mutational screening revealed a high frequency of mutations
A novel concept of redox oxides-based dual-bed thermochemical energy storage for exploiting the potential of Concentrated Solar Power (CSP) technology
Recycling manure as cow bedding: potential benefits and risks for UK dairy farms
Material obtained from physical separation of slurry (recycled manure solids; RMS) has been used as bedding for dairy cows in dry climates in the US since the 1970s. Relatively recently, the technical ability to produce drier material has led to adoption of the practice in Europe under different climatic conditions. This review collates the evidence available on benefits and risks of using RMS bedding on dairy farms, with a European context in mind. There was less evidence than expected for anecdotal claims of improved cow comfort. Among animal health risks, only udder health has received appreciable attention. There are some circumstantial reports of difficulties of maintaining udder health on RMS, but no large scale or long term studies of effects on clinical and subclinical mastitis have been published. Existing reports do not give consistent evidence of inevitable problems, nor is there any information on clinical implications for other diseases. The scientific basis for guidelines on management of RMS bedding is limited. Decisions on optimum treatment and management may present conflicts between control of different groups of organisms. There is no information on the influence that such 'recycling' of manure may have on pathogen virulence. The possibility of influence on genetic material conveying antimicrobial resistance is a concern, but little understood. Should UK or other non-US farmers adopt RMS, they are advised to do so with caution, apply the required strategies for risk mitigation, maintain strict hygiene of bed management and milking practices and closely monitor the effects on herd health
A comparative analysis of body psychotherapy and dance movement psychotherapy from a European perspective
A decentralized and pull-based control loop for on-demand delivery in eto construction supply chains
Engineer-To-Order (ETO) process chain types with a successive installation on-site are common in plant building and the construction industry. Usually, the core processes Engineering, Fabrication and Installation are disconnected, which creates high levels of Work in Progress (WIP) and long lead-Times. Furthermore, up to date information about the construction progress, as prerequisite for an on-demand delivery of ETO-components is always difficult to obtain. Usually, to prevent a lack of material on-site, costly intermediate storages are used, which extend the delivery time. Well-known approaches in research, like the Last Planner System (LPS) or the Location Based Management System (LBMS), increase collaboration on-site and improve the reliability of construction schedules, but have a limited impact on synchronizing the supply chain to the construction progress. The approach presented in the paper describes how off-site and on-site production can be coupled, to reach short construction lead-Times without wastefully intermediate storages. A first IT-prototype, based on "Industry 4.0" principles, was implemented and tested in an Italian medium-sized ETO construction supplier