DC-conductivity of a suspension of insulating particles with internal rotation

We analyse the consequences of Quincke rotation on the conductivity of a suspension. Quincke rotation refers to the spontaneous rotation of insulating particles dispersed in a slightly conducting liquid and subject to a high DC electric field: above a critical field, each particle rotates continuously around itself with an axis pointing in any direction perpendicular to the DC field. When the suspension is subject to an electric field lower than the threshold one, the presence of insulating particles in the host liquid decreases the bulk conductivity since the particles form obstacles to ion migration. But for electric fields higher than the critical one, the particles rotate and facilitate ion migration: the effective conductivity of the suspension is increased. We provide a theoretical analysis of the impact of Quincke rotation on the apparent conductivity of a suspension and we present experimental results obtained with a suspension of PMMA particles dispersed in weakly conducting liquids

Local transient rheological behavior of concentrated suspensions

This paper reports experiments on the shear transient response of concentrated non-Brownian suspensions. The shear viscosity of the suspensions is measured using a wide-gap Couette rheometer equipped with a Particle Image Velocimetry (PIV) device that allows measuring the velocity field. The suspensions made of PMMA particles (31$\mu$m in diameter) suspended in a Newtonian index- and density-matched liquid are transparent enough to allow an accurate measurement of the local velocity for particle concentrations as high as 50%. In the wide-gap Couette cell, the shear induced particle migration is evidenced by the measurement of the time evolution of the flow profile. A peculiar radial zone in the gap is identified where the viscosity remains constant. At this special location, the local particle volume fraction is taken to be the mean particle concentration. The local shear transient response of the suspensions when the shear flow is reversed is measured at this point where the particle volume fraction is well defined. The local rheological measurements presented here confirm the macroscopic measurements of Gadala-Maria and Acrivos (1980). After shear reversal, the viscosity undergoes a step-like reduction, decreases slower and passes through a minimum before increasing again to reach a plateau. Upon varying the particle concentration, we have been able to show that the minimum and the plateau viscosities do not obey the same scaling law with respect to the particle volume fraction. These experimental results are consistent with the scaling predicted by Mills and Snabre (2009) and with the results of numerical simulation performed on random suspensions [Sierou and Brady (2001)]. The minimum seems to be associated with the viscosity of an isotropic suspension, or at least of a suspension whose particles do not interact through non-hydrodynamic forces, while the plateau value would correspond to the viscosity of a suspension structured by the shear where the non-hydrodynamic forces play a crucial role

The Warehouse Information System (WINS): An Architectural Design for an Information System Employing the World Wide Web to Enhance Foreign Military Sales (FMS) Excess Inventory Management

The United States Government has long provided security assistance to foreign countries. Each year, billions of dollars of military hardware and equipment are sold through a process known as Foreign Military Sales (FMS). Unfortunately, most countries are now reporting that they are holding many items, sometimes billions of dollars worth, that are excess for their needs. At the same time, there are many countries in need of these items. Countries currently have two options for getting rid of the items they can write them off or try to return them. Countries encounter problems with both of these choices. Naturally, if countries write off the items and destroy them, they lose the potential for selling the items. The two current return programs, Third Country Transfers and FMS Excess Materiel Return, have not provided a sufficient means for reducing and redistributing this excess. In response, the Air Force Security Assistance Center (AFSAC) has developed a program, the Worldwide Warehouse, specifically aimed at helping countries reduce their excess materiel. AFSAC wants to automate the features of the Worldwide Warehouse. This thesis provides an architectural design for an information system capable of automating the features of the Worldwide Warehouse

Room temperature soft ferromagnetism in the nanocrystalline form of YCo2 - a well-known bulk Pauli paramagnet

The Laves phase compound, YCo2, is a well-known exchange-enahnced Pauli paramagnet. We report here that, in the nanocrystalline form, this compound interestingly is an itinerant ferromagnet at room temperature with a low coercive-field. The magnitude of the saturation moment (about 1 Bohr-magneton per formula unit) is large enough to infer that the ferromagnetism is not a surface phenomenon in these nanocrystallites. Since these ferromagnetic nanocrystallines are easy to synthesize with a stable form in air, one can explore applications, particularly where hysteresis is a disadvantage

Normal stress differences in non-Brownian fiber suspensions

International audienceIn this paper, we present an experimental study of the normal stress differences that arise in non-Brownian rigid fiber suspensions subject to a shear flow. While early measurements of the normal stress in fiber suspensions in Newtonian fluids measured only N 1 − N 2 , the recent work of Snook et al. J. Fluid Mech. 758 486 (2014) and the present paper provide the first measurements of N 1 and N 2 separately. Snook et al perform such measurements with a gap that is very wide compared with the fiber length, whereas the present paper explores the effects of confinement when the gap is 4-10 times the fiber length. The first and the second normal stress differences are measured using a single experiment which consists of determining the radial profile of the second normal stress, along the velocity gradient direction, Σ 22 , in a torsional flow between two parallel discs. Suspensions are made of monodisperse fibers immersed in a neutrally buoyant Newtonian fluid. Two fiber lengths and three aspect ratios a r = L/d, and a wide range of concentrations have been tested. N 1 is found to be positive while N 2 is negative and the magnitude of both normal stress differences increases when nL 2 d increases, n being the number fraction of fibers. The magnitude of N 2 is found to be much smaller than N 1 only for high aspect ratios and low fiber concentrations

Effect of Hydrodynamic Force on Microcantilever Vibrations: Applications to Liquid-Phase Chemical Sensing

At the microscale, cantilever vibrations depend not only on the microstructure’s properties and geometry but also on the properties of the surrounding medium. In fact, when a microcantilever vibrates in a fluid, the fluid offers resistance to the motion of the beam. The study of the influence of the hydrodynamic force on the microcantilever’s vibrational spectrum can be used to either (1) optimize the use of microcantilevers for chemical detection in liquid media or (2) extract the mechanical properties of the fluid. The classical method for application (1) in gas is to operate the microcantilever in the dynamic transverse bending mode for chemical detection. However, the performance of microcantilevers excited in this standard out-of-plane dynamic mode drastically decreases in viscous liquid media. When immersed in liquids, in order to limit the decrease of both the resonant frequency and the quality factor, and improve sensitivity in sensing applications, alternative vibration modes that primarily shear the fluid (rather than involving motion normal to the fluid/beam interface) have been studied and tested: these include in-plane vibration modes (lateral bending mode and elongation mode). For application (2), the classical method to measure the rheological properties of fluids is to use a rheometer. However, such systems require sampling (no in-situ measurements) and a relatively large sample volume (a few milliliters). Moreover, the frequency range is limited to low frequencies (less than 200Hz). To overcome the limitations of this classical method, an alternative method based on the use of silicon microcantilevers is presented. The method, which is based on the use of analytical equations for the hydrodynamic force, permits the measurement of the complex shear modulus of viscoelastic fluids over a wide frequency range

Influence of Fluid-Structure Interaction on Microcantilever Vibrations: Applications to Rheological Fluid Measurement and Chemical Detection

At the microscale, cantilever vibrations depend not only on the microstructure’s properties and geometry but also on the properties of the surrounding medium. In fact, when a microcantilever vibrates in a fluid, the fluid offers resistance to the motion of the beam. The study of the influence of the hydrodynamic force on the microcantilever’s vibrational spectrum can be used to either (1) optimize the use of microcantilevers for chemical detection in liquid media or (2) extract the mechanical properties of the fluid. The classical method for application (1) in gas is to operate the microcantilever in the dynamic transverse bending mode for chemical detection. However, the performance of microcantilevers excited in this standard out-of-plane dynamic mode drastically decreases in viscous liquid media. When immersed in liquids, in order to limit the decrease of both the resonant frequency and the quality factor, alternative vibration modes that primarily shear the fluid (rather than involving motion normal to the fluid/beam interface) have been studied and tested: these include inplane vibration modes (lateral bending mode and elongation mode). For application (2), the classical method to measure the rheological properties of fluids is to use a rheometer. To overcome the limitations of this classical method, an alternative method based on the use of silicon microcantilevers is presented. The method, which is based on the use of analytical equations for the hydrodynamic force, permits the measurement of the complex shear modulus of viscoelastic fluids over a wide frequency range

The generation and gender shifts in medicine: an exploratory survey of internal medicine physicians

BACKGROUND: Two striking demographic shifts evident in today's workforce are also apparent in the medical profession. One is the entry of a new generation of physicians, Gen Xers, and the other is the influx of women. Both shifts are argued to have significant implications for recruitment and retention because of assumptions regarding the younger generation's and women's attitudes towards work and patient care. This paper explores two questions regarding the generations: (1) How do Baby Boomer and Generation X physicians perceive the generation shift in work attitudes and behaviours? and (2) Do Baby Boomer and Generation X physicians differ significantly in their work hours and work attitudes regarding patient care and life balance? Gen Xers include those born between 1965 and 1980; Baby Boomers are those born between 1945 and 1964. We also ask: Do female and male Generation X physicians differ significantly in their work hours and work attitudes regarding patient care and life balance? METHODS: We conducted exploratory interviews with 54 physicians and residents from the Department of Medicine (response rate 91%) and asked about their perceptions regarding the generation and gender shifts in medicine. We limit the analyses to interview responses of 34 Baby Boomers and 18 Generation Xers. We also sent questionnaires to Department members (response rate 66%), and this analysis is limited to 87 Baby Boomers' and 65 Generation Xers' responses. RESULTS: The qualitative interview data suggest significant generation and gender shifts in physicians' attitudes. Baby Boomers generally view Gen Xer physicians as less committed to their medical careers. The quantitative questionnaire data suggest that there are few significant differences in the generations' and genders' reports of work-life balance, work hours and attitudes towards patient care. CONCLUSION: A combined qualitative and quantitative approach to the generation shift and gender shift in medicine is helpful in revealing that the widely held assumptions are not necessarily reflective of any significant differences in actual work attitudes or behaviours of Boomer and Gen X physicians or of the younger generation of women entering medicine