1,007 research outputs found
Compaction dynamics in ductile granular media
Ductile compaction is common in many natural systems, but the temporal
evolution of such systems is rarely studied. We observe surprising oscillations
in the weight measured at the bottom of a self-compacting ensemble of ductile
grains. The oscillations develop during the first ten hours of the experiment,
and usually persist through the length of an experiment (one week). The weight
oscillations are connected to the grain--wall contacts, and are directly
correlated with the observed strain evolution and the dynamics of grain--wall
contacts during the compaction. Here, we present the experimental results and
characteristic time constants of the system, and discuss possible reasons for
the measured weight oscillations.Comment: 11 pages, 14 figure
Application of different models to the lactation curves of unimproved Awassi ewes in Turkey
The objective of this study was to investigate the use of four different mathematical functions (Wood, Inverse Polynomial, Quadratic and Cubic models) for describing the lactation curve of unimproved Awassi ewes. Data were collected from 136 ewes from the same flock raised on the State Farm of Gözlü in the Konya Province of Turkey. The differences in estimated total milk yields between the models were not statistically significant. All models were adequate in describing total milk yield, though total milk yield estimated using the Cubic model was very close to total milk yield calculated by the Fleischmann method. Age effects on model parameters were not significant. The Inverse Polynomial model overestimated the peak yield significantly. Estimated peak yields of the Wood and Cubic model were similar while that obtained from the Quadratic model was significantly lower than that of the other models. Day of peak yield estimated by the models varied between 10.2 and 56.4 days. The differences between days of peak yield estimated using the different models were significant. R2 values of the models ranged from 0.724 to 0.977. The Cubic model gave the best R2 value. The lowest mean square prediction error was found using the Cubic model. Correlation coefficients between total milk yield calculated by the Fleischmann method and estimated total milk yield from the other models ranged from 0.933 to 0.998. The highest correlation coefficient was found for the Cubic model. As a result, the Cubic model showed the best fit to the data collected from unimproved Awassi ewes and allowed a suitable description of the shape of the lactation curve. South African Journal of Animal Science Vol. 35(4) 2005: 238-24
The effect of anions of transition metal salts on the structure of modified mesostructured silica films and monoliths
Cataloged from PDF version of article.The structure of the preformed LC mesophase of water:transition metal salt ([M(H2O)6]X2):acid (HX):oligo(ethylene oxide) (or Pluronics):tetramethylorthosilicate (TMOS) mixture during hydrolysis and partial polymerization of the silica source is maintained upon further polymerization and condensation of the silica species in the solid state. The liquid mixture in early stage of the silica polymerization could be casted or dip coated to a surface of a glass or silicon wafer to produce mesostructured silica monoliths and films, respectively. The silica species and ions (metal ions and anions) influence the structure of the LC mesophases (as a result, the structure of silica) and the hydrophilic and hydrophobic balance in the reaction media. The silica structure can be changed from hexagonal to cubic by increasing, for example, the nitrate salt concentration in the nitrate salt systems. A similar transformation takes place in the presence of very low perchlorate salt concentration. The salt concentration in the mesostructured silica can be increased up to 1.1/1.0 salt/SiO2 w/w ratio, in mesostructured silica materials by maintaining its lamella structure in P123 and cubic in the CnEOm systems. However, the materials obtained from the P123 systems undergo transformation from lamella to 2D hexagonal upon calcinations. The method developed in this work can be used to modify the internal surface of the pores with various transition metal ions and metal oxides that may find application in catalysis. © 2006 Elsevier Inc. All rights reserved
Juncus Bulbosus Tissue Nutrient Concentrations and Stoichiometry in Oligotrophic Ecosystems: Variability with Seasons, Growth Forms, Organs and Habitats
Aquatic plant nutrient concentrations provide important information to characterise their role in nutrient retention and turnover in aquatic ecosystems. While large standing biomass of aquatic plants is typically found in nutrient-rich localities, it may also occur in oligotrophic ecosystems. Juncus bulbosus is able to form massive stands even in very nutrient-dilute waters. Here we show that this may be achieved by tissues with very high carbon-to-nutrient ratios combined with perennial (slow) growth and a poor food source for grazers inferred from plant stoichiometry and tissue nutrient thresholds. We also show that the C, N, P and C:N:P stoichiometric ratios of Juncus bulbosus vary with the time of year, habitats (lakes versus rivers) and organs (roots versus shoots). We found no differences between growth forms (notably in P, inferred as the most limiting nutrient) corresponding to small and large plant stands. The mass development of J. bulbosus requires C, N and P, whatever the ecosystem (lake or river), and not just CO2 and NH4, as suggested in previous studies. Since macrophytes inhabiting oligotrophic aquatic ecosystems are dominated by isoetids (perennial plants with a high root/shoot ratio), attention should be paid to quantifying the role of roots in aquatic plant stoichiometry, nutrient turnover and nutrient retention.publishedVersio
The impact of psychosocial and organizational working conditions on the mental health of female cleaning personnel in Norway
BACKGROUND: This study examined the association between psychosocial and organizational work conditions and mental health among women employed in the cleaning profession in Norway. METHODS: Self-report questionnaires were mailed to 661 cleaning staff personnel from seven cleaning organizations in seven different cities across Norway. The response rate was 64%, of which 374 (88%) respondents were women. The questionnaires assessed socio-demographic information and employment history, work organization, and psychosocial working conditions. The Hopkins Symptoms Checklist (HSCL-25) was included to assess mental health. RESULTS: On average, respondents were 43 years old and reported 10.8 years of experience working in the cleaning industry. The proportion of women scoring a HSCL-25 equal to or above 1.75 was 17.5%, which was higher than the average prevalence of mental health problems among working Norwegian women (8.4%). A factor analysis of the questions specific to the psychosocial work environment identified the following four underlying dimensions: leadership, co-workers, time pressure/control, and information/knowledge. Two of these, poor satisfaction with leadership (OR = 3.6) and poor satisfaction with co-workers (OR = 2.3), were significantly related to mental health. In addition, having contact with colleagues less than once a day (OR = 2.4) and not being ethnically Norwegian (OR = 3.0) increased the risk for mental health problems. CONCLUSION: Mental health problems are frequent among female cleaning professionals in Norway. Our results indicate that quality of leadership, collaboration with co-workers, and ethnicity were significantly associated with mental health
Comparative genomics of Enterococcus faecalis from healthy Norwegian infants
<p>Abstract</p> <p>Background</p> <p><it>Enterococcus faecalis</it>, traditionally considered a harmless commensal of the intestinal tract, is now ranked among the leading causes of nosocomial infections. In an attempt to gain insight into the genetic make-up of commensal <it>E. faecalis</it>, we have studied genomic variation in a collection of community-derived <it>E. faecalis </it>isolated from the feces of Norwegian infants.</p> <p>Results</p> <p>The <it>E. faecalis </it>isolates were first sequence typed by multilocus sequence typing (MLST) and characterized with respect to antibiotic resistance and properties associated with virulence. A subset of the isolates was compared to the vancomycin resistant strain <it>E. faecalis </it>V583 (V583) by whole genome microarray comparison (comparative genomic hybridization (CGH)). Several of the putative enterococcal virulence factors were found to be highly prevalent among the commensal baby isolates. The genomic variation as observed by CGH was less between isolates displaying the same MLST sequence type than between isolates belonging to different evolutionary lineages.</p> <p>Conclusion</p> <p>The variations in gene content observed among the investigated commensal <it>E. faecalis </it>is comparable to the genetic variation previously reported among strains of various origins thought to be representative of the major <it>E. faecalis </it>lineages. Previous MLST analysis of <it>E. faecalis </it>have identified so-called high-risk enterococcal clonal complexes (HiRECC), defined as genetically distinct subpopulations, epidemiologically associated with enterococcal infections. The observed correlation between CGH and MLST presented here, may offer a method for the identification of lineage-specific genes, and may therefore add clues on how to distinguish pathogenic from commensal <it>E. faecalis</it>. In this work, information on the core genome of <it>E. faecalis </it>is also substantially extended.</p
Noise properties of high-T-c superconducting flux transformers fabricated using chemical-mechanical polishing
Reproducible high-temperature superconducting multilayer flux transformers were fabricated using chemical mechanical polishing. The measured magnetic field noise of the flip-chip magnetometer based on one such flux transformer with a 9 x 9 mm(2) pickup loop coupled to a bicrystal dc SQUID was 15 fT/Hz(1/2) above 2 kHz. We present an investigation of excess 1/f noise observed at low frequencies and its relationship with the microstructure of the interlayer connections within the flux transformer. The developed high-T-c SQUID magnetometers may be advantageous in ultra-low field magnetic resonance imaging and, with improved low frequency noise, magnetoencephalography applications
Theoretical study of Ga-based nanowires and the interaction of Ga with single-wall carbon nanotubes
Gallium displays physical properties which can make it a potential element to
produce metallic nanowires and high-conducting interconnects in
nanoelectronics. Using first-principles pseudopotential plane method we showed
that Ga can form stable metallic linear and zigzag monatomic chain structures.
The interaction between individual Ga atom and single-wall carbon nanotube
(SWNT) leads to a chemisorption bond involving charge transfer. Doping of SWNT
with Ga atom gives rise to donor states. Owing to a significant interaction
between individual Ga atom and SWNT, continuous Ga coverage of the tube can be
achieved. Ga nanowires produced by the coating of carbon nanotube templates are
found to be stable and high conducting.Comment: 8 pages, 8 figure
On-scalp MEG sensor localization using magnetic dipole-like coils: A method for highly accurate co-registration
Source modelling in magnetoencephalography (MEG) requires precise co-registration of the sensor array and the anatomical structure of the measured individual\u27s head. In conventional MEG, the positions and orientations of the sensors relative to each other are fixed and known beforehand, requiring only localization of the head relative to the sensor array. Since the sensors in on-scalp MEG are positioned on the scalp, locations of the individual sensors depend on the subject\u27s head shape and size. The positions and orientations of on-scalp sensors must therefore be measured a every recording. This can be achieved by inverting conventional head localization, localizing the sensors relative to the head - rather than the other way around. In this study we present a practical method for localizing sensors using magnetic dipole-like coils attached to the subject\u27s head. We implement and evaluate the method in a set of on-scalp MEG recordings using a 7-channel on-scalp MEG system based on high critical temperature superconducting quantum interference devices (high-T-c SQUIDs). The method allows individually localizing the sensor positions, orientations, and responsivities with high accuracy using only a short averaging time (<= 2 mm, < 3 degrees and < 3%, respectively, with 1-s averaging), enabling continuous sensor localization. Calibrating and jointly localizing the sensor array can further improve the accuracy of position and orientation (< 1 mm and < 1 degrees, respectively, with 1-s coil recordings). We demonstrate source localization of on-scalp recorded somatosensory evoked activity based on coregistration with our method. Equivalent current dipole fits of the evoked responses corresponded well (within 4.2 mm) with those based on a commercial, whole-head MEG system
- …