Projection of holograms from photorefractive OASLMs

Liquid crystals doped with fullerenes and carbon nanotubes (CNTs) act as good optical nonlinear materials. We have used these materials to build optically-addressed spatial light modulators (OASLMs). The devices comprise a single layer of doped liquid crystal acting as an active layer. Undoped LC devices with surfaces coated with fullerenes are also studied. Such OASLMs allow recording of phase holograms, and we record by imaging pre-calculated pre-recorded holograms. Writing is performed at normal incidence and reading at 45° oblique incidence. Both transmission and reflection modes of operation are used. Experimental results as well as comparison with commercially available OASLMs are presented

Sub-mm free-free emission from the winds of massive stars in the age of ALMA

The thermal radio and sub-mm emission from the winds of massive stars is investigated and the contribution to the emission due to the stellar wind acceleration region and clumping of the wind is quantified. Building upon established theory, a method for calculating the thermal radio and sub-mm emission using results for a line-driven stellar outflow according to Castor, Abbott & Klein (1975) is presented. The results show strong variation of the spectral index for 10 2 GHz < {\nu} < 10 4 GHz. This corresponds both to the wind acceleration region and clumping of the wind, leading to a strong dependence on the wind velocity law and clumping parameters. The Atacama Large Millimeter/sub-mm Array (ALMA) is the first observatory to have both the spectral window and sensitivity to observe at the high frequencies required to probe the acceleration regions of massive stars. The deviations in the predicted flux levels as a result of the inclusion of the wind acceleration region and clumping are sufficient to be detected by ALMA, through deviations in the spectral index in different portions of the radio/sub-mm spectra of massive stars, for a range of reasonable mass-loss rates and distances. Consequently both mechanisms need to be included to fully understand the mass-loss rates of massive stars.Comment: 12 pages, 8 figure

An Optical Search for New Outbursting Low Mass X-Ray Binaries

Transient Low-Mass X-ray binaries (LMXBs) are discovered largely by X-ray and gamma-ray all-sky monitors. The X-ray outburst is also accompanied by an optical brightening, which empirically can precede detection of X-rays. Newly sensitive optical synoptic surveys may offer a complementary pathway for discovery, and potential for insight into the initial onset and propagation of the thermal instability that leads to the ionization of the accretion disk. We use the Zwicky Transient Facility (ZTF) alert stream to perform a comprehensive search at optical wavelengths for previously undiscovered outbursting LMXBs. Our pipeline first crossmatches the positions of the alerts to cataloged X-ray sources, and then analyzes the 30-day lightcurve of matched alerts by thresholding on differences with an 8-day exponentially weighted moving average. In addition to an nineteen month-long live search, we ran our pipeline over four years of ZTF archival data, recovering 4 known LMXBs. We also independently detected an outburst of MAXI J1957+032 in the live search and found the first outburst of Swift J1943.4+0228, an unclassified X-ray transient, in 10 years. Using Monte Carlo simulations of the Galactic LMXB population, we estimate that 29% of outbursting LMXBs are detectable by ZTF and that 4.4% of LMXBs would be present in the crossmatched X-ray catalogs, giving an estimated Galactic population of $3390^{+3980}_{-1930}$. We estimate that our current pipeline can detect 1.3% of all outbursting LMXBs, including those previously unknown, but that Rubin Observatory's Legacy Survey of Space and Time (LSST) will be able to detect 43% of outbursting LMXBs.Comment: 17 pages, 10 figures, Accepted for publication in Ap

Characterization of carbon nanotube–thermotropic nematic liquid crystal composites

Dispersions of carbon nanotubes (CNTs) in liquid crystals (LCs) have attracted attention due to their unique properties and possible applications in photonics and electronics. However, these are hard to stabilize, and the loading level in the equilibrium state in LC hosts is small. A practical way to monitor the quality and CNT incorporation in such equilibrium dispersions is required. Here, we compare different methods for characterising equilibrium CNT–LC composite materials

3D semiconducting nanostructures via inverse lipid cubic phases.

Well-ordered and highly interconnected 3D semiconducting nanostructures of bismuth sulphide were prepared from inverse cubic lipid mesophases. This route offers significant advantages in terms of mild conditions, ease of use and electrode architecture over other routes to nanomaterials synthesis for device applications. The resulting 3D bicontinous nanowire network films exhibited a single diamond topology of symmetry Fd3m (Q227) which was verified by Small angle X-ray scattering (SAXS) and Transmission electron microscopy (TEM) and holds great promise for potential applications in optoelectronics, photovoltaics and thermoelectrics

Illusory Stimuli Can Be Used to Identify Retinal Blind Spots

Background. Identification of visual field loss in people with retinal disease is not straightforward as people with eye disease are frequently unaware of substantial deficits in their visual field, as a consequence of perceptual completion ("filling-in'') of affected areas. Methodology. We attempted to induce a compelling visual illusion known as the induced twinkle after-effect (TwAE) in eight patients with retinal scotomas. Half of these patients experience filling-in of their scotomas such that they are unaware of the presence of their scotoma, and conventional campimetric techniques can not be used to identify their vision loss. The region of the TwAE was compared to microperimetry maps of the retinal lesion. Principal Findings. Six of our eight participants experienced the TwAE. This effect occurred in three of the four people who filled-in their scotoma. The boundary of the TwAE showed good agreement with the boundary of lesion, as determined by microperimetry. Conclusion. For the first time, we have determined vision loss by asking patients to report the presence of an illusory percept in blind areas, rather than the absence of a real stimulus. This illusory technique is quick, accurate and not subject to the effects of filling-in

Self-Assembly of Supramolecular Triblock Copolymer Complexes

Four different poly(tert-butoxystyrene)-b-polystyrene-b-poly(4-vinylpyridine) (PtBOS-b-PS-b-P4VP) linear triblock copolymers, with the P4VP weight fraction varying from 0.08 to 0.39, were synthesized via sequential anionic polymerization. The values of the unknown interaction parameters between styrene and tert-butoxystyrene and between tert-butoxystyrene and 4-vinylpyridine were determined from random copolymer blend miscibility studies and found to satisfy 0.031<χS,tBOS<0.034 and 0.39<χ4VP,tBOS<0.43, the latter being slightly larger than the known 0.30<χS,4VP≤0.35 value range. All triblock copolymers synthesized adopted a P4VP/PS core/shell cylindrical self-assembled morphology. From these four triblock copolymers supramolecular complexes were prepared by hydrogen bonding a stoichiometric amount of pentadecylphenol (PDP) to the P4VP blocks. Three of these complexes formed a triple lamellar ordered state with additional short length scale ordering inside the P4VP(PDP) layers. The self-assembled state of the supramolecular complex based on the triblock copolymer with the largest fraction of P4VP consisted of alternating layers of PtBOS and P4VP(PDP) layers with PS cylinders inside the latter layers. The difference in morphology between the triblock copolymers and the supramolecular complexes is due to two effects: (i) a change in effective composition and, (ii) a reduction in interfacial tension between the PS and P4VP containing domains. The small angle X-ray scattering patterns of the supramolecules systems are very temperature sensitive. A striking feature is the disappearance of the first order scattering peak of the triple lamellar state in certain temperature intervals, while the higher order peaks (including the third order) remain. This is argued to be due to the thermal sensitivity of the hydrogen bonding and thus directly related to the very nature of these systems.

Building social capital through breastfeeding peer support: Insights from an evaluation of a voluntary breastfeeding peer support service in North-West England

Background: Peer support is reported to be a key method to help build social capital in communities. To date there are no studies that describe how this can be achieved through a breastfeeding peer support service. In this paper we present findings from an evaluation of a voluntary model of breastfeeding peer support in North-West England to describe how the service was operationalized and embedded into the community. This study was undertaken from May, 2012 to May, 2013. Methods: Interviews (group or individual) were held with 87 participants: 24 breastfeeding women, 13 peer supporters and 50 health and community professionals. The data contained within 23 monthly monitoring reports (January, 2011 to February 2013) compiled by the voluntary peer support service were also extracted and analysed. Results: Thematic analysis was undertaken using social capital concepts as a theoretical lens. Key findings were identified to resonate with ’bonding’, ‘bridging’ and ‘linking’ forms of social capital. These insights illuminate how the peer support service facilitates ‘bonds’ with its members, and within and between women who access the service; how the service ‘bridges’ with individuals from different interests and backgrounds, and how ‘links’ were forged with those in authority to gain access and reach to women and to promote a breastfeeding culture. Some of the tensions highlighted within the social capital literature were also identified. Conclusions: Horizontal and vertical relationships forged between the peer support service and community members enabled peer support to be embedded into care pathways, helped to promote positive attitudes to breastfeeding and to disseminate knowledge and maximise reach for breastfeeding support across the community. Further effort to engage with those of different ethnic backgrounds and to resolve tensions between peer supporters and health professionals is warranted

Mesoporous monoliths of inverse bicontinuous cubic phases of block copolymer bilayers

Solution self-assembly of block copolymers into inverse bicontinuous cubic mesophases is a promising new approach for creating porous polymer films and monoliths with highly organized bicontinuous mesoporous networks. Here we report the direct self-assembly of block copolymers with branched hydrophilic blocks into large monoliths consisting of the inverse bicontinuous cubic structures of the block copolymer bilayer. We suggest a facile and scalable method of solution self-assembly by diffusion of water to the block copolymer solution, which results in the unperturbed formation of mesoporous monoliths with large-pore (&gt;25nm diameter) networks weaved in crystalline lattices. The surface functional groups of the internal large-pore networks are freely accessible for large guest molecules such as protein complexes of which the molecular weight exceeded 100kDa. The internal double-diamond (Pn3m) networks of large pores within the mesoporous monoliths could be replicated to self-supporting three-dimensional skeletal structures of crystalline titania and mesoporous silica.open2