22 research outputs found
Precision control of thermal transport in cryogenic single-crystal silicon devices
We report on the diffusive-ballistic thermal conductance of multi-moded
single-crystal silicon beams measured below 1 K. It is shown that the phonon
mean-free-path is a strong function of the surface roughness
characteristics of the beams. This effect is enhanced in diffuse beams with
lengths much larger than , even when the surface is fairly smooth, 5-10
nm rms, and the peak thermal wavelength is 0.6 m. Resonant phonon
scattering has been observed in beams with a pitted surface morphology and
characteristic pit depth of 30 nm. Hence, if the surface roughness is not
adequately controlled, the thermal conductance can vary significantly for
diffuse beams fabricated across a wafer. In contrast, when the beam length is
of order , the conductance is dominated by ballistic transport and is
effectively set by the beam area. We have demonstrated a uniformity of 8%
in fractional deviation for ballistic beams, and this deviation is largely set
by the thermal conductance of diffuse beams that support the
micro-electro-mechanical device and electrical leads. In addition, we have
found no evidence for excess specific heat in single-crystal silicon membranes.
This allows for the precise control of the device heat capacity with normal
metal films. We discuss the results in the context of the design and
fabrication of large-format arrays of far-infrared and millimeter wavelength
cryogenic detectors
Scalable background-limited polarization-sensitive detectors for mm-wave applications
We report on the status and development of polarization-sensitive detectors
for millimeter-wave applications. The detectors are fabricated on
single-crystal silicon, which functions as a low-loss dielectric substrate for
the microwave circuitry as well as the supporting membrane for the
Transition-Edge Sensor (TES) bolometers. The orthomode transducer (OMT) is
realized as a symmetric structure and on-chip filters are employed to define
the detection bandwidth. A hybridized integrated enclosure reduces the
high-frequency THz mode set that can couple to the TES bolometers. An
implementation of the detector architecture at Q-band achieves 90% efficiency
in each polarization. The design is scalable in both frequency coverage, 30-300
GHz, and in number of detectors with uniform characteristics. Hence, the
detectors are desirable for ground-based or space-borne instruments that
require large arrays of efficient background-limited cryogenic detectors.Comment: 7 pages, 3 figures, Presented at SPIE Astronomical Telescopes and
Instrumentation 2014: Millimeter, Submillimeter, and Far-Infrared Detectors
and Instrumentation for Astronomy VII. To be published in Proceedings of SPIE
Volume 915
Silicon-Based Antenna-Coupled Polarization-Sensitive Millimeter-Wave Bolometer Arrays for Cosmic Microwave Background Instruments
We describe feedhorn-coupled polarization-sensitive detector arrays that
utilize monocrystalline silicon as the dielectric substrate material.
Monocrystalline silicon has a low-loss tangent and repeatable dielectric
constant, characteristics that are critical for realizing efficient and uniform
superconducting microwave circuits. An additional advantage of this material is
its low specific heat. In a detector pixel, two Transition-Edge Sensor (TES)
bolometers are antenna-coupled to in-band radiation via a symmetric planar
orthomode transducer (OMT). Each orthogonal linear polarization is coupled to a
separate superconducting microstrip transmission line circuit. On-chip
filtering is employed to both reject out-of-band radiation from the upper band
edge to the gap frequency of the niobium superconductor, and to flexibly define
the bandwidth for each TES to meet the requirements of the application. The
microwave circuit is compatible with multi-chroic operation. Metalized silicon
platelets are used to define the backshort for the waveguide probes. This
micro-machined structure is also used to mitigate the coupling of out-of-band
radiation to the microwave circuit. At 40 GHz, the detectors have a measured
efficiency of 90%. In this paper, we describe the development of the 90 GHz
detector arrays that will be demonstrated using the Cosmology Large Angular
Scale Surveyor (CLASS) ground-based telescope
The Cosmology Large Angular Scale Surveyor
The Cosmology Large Angular Scale Surveyor (CLASS) is a four telescope array
designed to characterize relic primordial gravitational waves from inflation
and the optical depth to reionization through a measurement of the polarized
cosmic microwave background (CMB) on the largest angular scales. The
frequencies of the four CLASS telescopes, one at 38 GHz, two at 93 GHz, and one
dichroic system at 145/217 GHz, are chosen to avoid spectral regions of high
atmospheric emission and span the minimum of the polarized Galactic
foregrounds: synchrotron emission at lower frequencies and dust emission at
higher frequencies. Low-noise transition edge sensor detectors and a rapid
front-end polarization modulator provide a unique combination of high
sensitivity, stability, and control of systematics. The CLASS site, at 5200 m
in the Chilean Atacama desert, allows for daily mapping of up to 70\% of the
sky and enables the characterization of CMB polarization at the largest angular
scales. Using this combination of a broad frequency range, large sky coverage,
control over systematics, and high sensitivity, CLASS will observe the
reionization and recombination peaks of the CMB E- and B-mode power spectra.
CLASS will make a cosmic variance limited measurement of the optical depth to
reionization and will measure or place upper limits on the tensor-to-scalar
ratio, , down to a level of 0.01 (95\% C.L.)
Gemini multi-conjugate adaptive optics system review II: Commissioning, operation and overall performance
The Gemini Multi-conjugate Adaptive Optics System - GeMS, a facility
instrument mounted on the Gemini South telescope, delivers a uniform, near
diffraction limited images at near infrared wavelengths (0.95 microns- 2.5
microns) over a field of view of 120 arc seconds. GeMS is the first sodium
layer based multi laser guide star adaptive optics system used in astronomy. It
uses five laser guide stars distributed on a 60 arc seconds square
constellation to measure for atmospheric distortions and two deformable mirrors
to compensate for it. In this paper, the second devoted to describe the GeMS
project, we present the commissioning, overall performance and operational
scheme of GeMS. Performance of each sub-system is derived from the
commissioning results. The typical image quality, expressed in full with half
maximum, Strehl ratios and variations over the field delivered by the system
are then described. A discussion of the main contributor to performance
limitation is carried-out. Finally, overheads and future system upgrades are
described.Comment: 20 pages, 11 figures, accepted for publication in MNRA
CLASS: The Cosmology Large Angular Scale Surveyor
The Cosmology Large Angular Scale Surveyor (CLASS) is an experiment to measure the signature of a gravitational wave background from inflation in the polarization of the cosmic microwave background (CMB). CLASS is a multi-frequency array of four telescopes operating from a high-altitude site in the Atacama Desert in Chile. CLASS will survey 70% of the sky in four frequency bands centered at 38, 93, 148, and 217 GHz, which are chosen to straddle the Galactic-foreground minimum while avoiding strong atmospheric emission lines. This broad frequency coverage ensures that CLASS can distinguish Galactic emission from the CMB. The sky fraction of the CLASS survey will allow the full shape of the primordial B-mode power spectrum to be characterized, including the signal from reionization at low-length. Its unique combination of large sky coverage, control of systematic errors, and high sensitivity will allow CLASS to measure or place upper limits on the tensor-to-scalar ratio at a level of r = 0:01 and make a cosmic-variance-limited measurement of the optical depth to the surface of last scattering, tau. (c) (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only