661 research outputs found
The Beam Screen for the LHC Injection Kicker Magnets
The two LHC injection kicker magnet systems must each produce a kick of 1.2 T.m with a flattop duration variable up to 7.86 ìs, and rise and fall times of less than 0.9 ìs and 3 ìs, respectively. Each system is composed of four 5 Ù transmission line kicker magnets with matched terminating resistors and pulse forming networks (PFN). The LHC beam has a high intensity, hence a beam screen is required in the aperture of the magnets This screen consists of a ceramic tube with conducting ?stripes? on the inner wall. The stripes provide a path for the image current of the beam and screen the magnet ferrites against Wake fields. The stripes initially used gave adequately low beam impedance however stripe discharges occured during pulsing of the magnet: hence further development of the beam screen was undertaken. This paper presents options considered to meet the often conflicting needs for low beam impedance, shielding of the ferrite, fast field rise time and good electrical and vacuum behaviour
Raman spectroscopy of human teeth using integrated optical spectrometers
We have designed an arrayed-waveguide grating in silicon oxynitride technology for the detection of Raman signals from tooth enamel in the spectral region between 890 nm and 912 nm. The detected signals for both parallel and cross polarizations are used to distinguish between healthy and carious regions on the tooth surface of extracted human teeth. Our experimental results are in very good agreement with those achieved using conventional Raman spectrometers. Our results represent a step toward the realization of compact, hand-held, integrated spectrometers
Impedance measurements and simulations on the TCT and TDI LHC collimators
The LHC collimation system is a critical element for
the safe operation of the LHC machine and it is subject
to continuous performance monitoring, hardware upgrade
and optimization. In this work we will address the impact
on impedance of the upgrades performed on the injection
protection target dump (TDI), where the absorber material
has been changed to mitigate the device heating observed
in machine operation, and on selected secondary (TCS) and
tertiary (TCT) collimators, where beam position monitors
(BPM) have been embedded for faster jaw alignment. Con-
cerning the TDI, we will present the RF measurements per-
formed before and after the upgrade, comparing the result
to heating and tune shift beam measurements. For the TCTs,
we will study how the higher order modes (HOM) intro-
duced by the BPM addition have been cured by means of
ferrite placement in the device. The impedance mitigation
campaign has been supported by RF measurements whose
results are in good agreement with GdfidL and CST simula-
tions. The presence of undamped low frequency modes is
proved not to be detrimental to the safe LHC operation
Status of Schottky Diagnostics in the ANKA Storage Ring
The status of longitudinal and transverse Schottky observation systems for the synchrotron light source ANKA is presented. ANKA regularly operates in a dedicated low alpha mode with short bunches for the generation of coherent THz radiation. The Schottky measurement results are shown and compared with theoretical predictions for the regular as well as the different stages of the low alpha mode of operation. Special care had to be taken to control and mitigate the impact from strong coherent lines of the short bunches on the signal processing chain. The system setup is shown, expected and unexpected observations as well as applications are discussed
Fast switching devices and induction rf at CLIC
We survey possible applications of fast switching devices and induction rf at the Compact Linear Collider (CLIC). These applications include extraction kickers for the combiner rings, modulators for the drive-beam linac, fast intra-train feedback, induction crab cavities, halo kickers, emergency kickers, long-range beam-beam compensation, damping-ring barrier rf, pulsed linac wigglers, positron capture, and spent-beam handling
A non-Hermitian critical point and the correlation length of strongly correlated quantum systems
We study a non-Hermitian generalization of quantum systems in which an
imaginary vector potential is added to the momentum operator. In the
tight-binding approximation, we make the hopping energy asymmetric in the
Hermitian Hamiltonian. In a previous article, we conjectured that the
non-Hermitian critical point where the energy gap vanishes is equal to the
inverse correlation length of the Hermitian system and we confirmed the
conjecture for two exactly solvable systems. In this article, we present more
evidence for the conjecture. We also argue the basis of our conjecture by
noting the dispersion relation of the elementary excitation.Comment: 25 pages, 18 figure
Quantum-Mechanical Position Operator and Localization in Extended Systems
We introduce a fundamental complex quantity, , which allows us to
discriminate between a conducting and non-conducting thermodynamic phase in
extended quantum systems. Its phase can be related to the expectation value of
the position operator, while its modulus provides an appropriate definition of
a localization length. The expressions are valid for {\it any} fractional
particle filling. As an illustration we use to characterize insulator
to ``superconducting'' and Mott transitions in one-dimensional lattice models
with infinite on-site Coulomb repulsion at quarter filling.Comment: 4 pages, REVTEX, 1 ps figure
South Dakota Farm & Home Research Index: 1978 - 1994
South Dakota Farm &Home Research Index 1978-1994 aids researchers, extension personnel, historians, librarians, and others in locating information about the research of the state\u27s Agricultural Experiment Station. It facilitates the identification of articles describing relevant research and researchers. South Dakota Farm & Home Research has been published by the Agricultural Experiment Station, South Dakota State University, Brookings, since 1949. The quarterly journal features brief reports on a wide variety of experiment station and university research activities focusing on agriculture and home economics. This index supplements the previous index to South Dakota Farm & Home Research, compiled by Leon Raney and Jane Kinch, which covers 1949 through 1977. It provides subject and author indexing of the contents of the journal from 1978 (volume 29, number 1) through 1994 (volume 45, number 3). All articles published in the journal during those years are indexed, resulting in approximately 1,900 subject and author index entries. All subject headings were assigned by the indexers. Although some title words may have been assigned as subject headings, this is not a title-keyword index. Approximately 450 subject headings appear in the index, including many cross-references, i.e., SEE and SEE ALSO references. Most articles are listed under more than one subject heading to facilitate access. The author index lists articles under the names of all authors or coauthors. Therefore, an article written by five coauthors, is listed in the author index under each of the five names. Articles which do not identify the author(s) are not listed in the author index
Observation of microwave radiation using low-cost detectors at the anka storage ring
Synchrotron light sources emit Coherent Synchrotron Radiation (CSR) for wavelengths longer than or equal to the bunch length. At most storage rings CSR cannot be observed, because the vacuum chamber cuts off radiation with long wavelengths. There are different approaches for shifting the CSR to shorter wavelengths that can propagate through the beam pipe, e.g.: the accelerator optics can be optimized for a low momentum compaction factor, thus reducing the bunch length. Alternatively, laser slicing can modulate substructures on long bunches [1]. Both techniques extend the CSR spectrum to shorter wavelengths, so that CSR is emitted at wavelengths below the waveguide shielding cut off. Usually fast detectors, like superconducting bolometer detector systems or Schottky barrier diodes, are used for observation of dynamic processes in accelerator physics. In this paper, we present observations of microwave radiation at ANKA using an alternative detector, a LNB (Low Noise Block) system. These devices are usually used in standard TV-SAT-receivers and are very cheap. We determined the time response of LNBs to be below 100 ns. The sensitivity of LNBs is optimized to detect very low intensity ”noise-like” signals. This microwave radiation study shows the possibility to apply the LNB for bunch length monitoring
Arrayed waveguide grating for polarized Raman spectroscopy of human teeth
We designed an arrayed-waveguide grating spectrometer for the detection of early dental caries in teeth through polarized Raman spectroscopy. Measurement results on extracted human teeth demonstrate the feasibility of the approach
- …