30 research outputs found
Simultaneous measurement of optical and RF behavior under CW and pulsed Fully Active Harmonic Load-Pull
Hot-Electron Electroluminescence under RF Operation in GaN-HEMTs::A Comparison Among Operational Classes
Electroluminescence microscopy and spectroscopy are used to compare the average hot-electron concentration and temperature under radio frequency (RF) operation class A, class B, and class F modes. From the results obtained, class A results, on average, in the highest hot-electron concentration, while class F is the mode with the lowest concentration due to its “L”-shaped load line. The electron temperature extracted from the electroluminescence spectra is reduced with increasing RF power, reflecting the dominance of electroluminescence from the portion of the load line in the semi-on region. The electroluminescence method is not able to give substantial information on the portion of the load line with high field and low current density which will be responsible for the potentially damaging hottest electrons present in the channel
Electroluminescence of hot electrons in AlGaN/GaN high-electron-mobility transistors under radio frequency operation
Hot electrons in AlGaN/GaN high electron mobility transistors are studied during radio frequency (RF) and DC operation by means of electroluminescence (EL) microscopy and spectroscopy. The measured EL intensity is decreased under RF operation compared to DC at the same average current, indicating a lower hot electron density. This is explained by averaging the DC EL intensity over the measured load line used in RF measurements, giving reasonable agreement. In addition, the hot electron temperature is lower by up to 15% under RF compared to DC, again at least partially explainable by the weighted averaging along the specific load line. However, peak electron temperature under RF occurs at high VDS and low IDS where EL is insignificant suggesting that any wear-out differences between RF and DC stress of the devices will depend on the balance between hot-carrier and field driven degradation mechanisms
Study of Drain Injected Breakdown Mechanisms in AlGaN/GaN-on-SiC HEMTs
Breakdown mechanism in 0.25- ÎĽm gate length AlGaN/GaN-on-SiC iron doped high electron mobility transistors (HEMTs) with background carbon is investigated through the drain current injection technique. The measurement results reveal that it can be divided into two distinct stages according to the gate voltage levels. The first stage of the measured drain injected breakdown is mainly due to the initiation of the punchthrough process under the gate, and the second stage of breakdown is associated with the potential barrier between the unintentionally doped (UID) GaN and the Fe doped p-type GaN buffer layer which also has a higher carbon density. The electroluminescence (EL) results suggest that the first stage shows uniform punchthrough current flow, but localized leakage current flow associated with a snapback breakdown mechanism replaces the uniform punchthrough current flow and dominates the second stage. A 2D-TCAD simulation has been implemented and shows the current paths under uniform flow conditions
Study of hot electrons in AlGaN/GaN HEMTs under RF Class B and Class J operation using electroluminescence
Quantifying Temperature-dependent Substrate Loss in GaN-on-Si RF Technology
Intrinsic limits to temperature-dependent substrate loss for GaN-on-Si
technology, due to the change in resistivity of the substrate with temperature,
are evaluated using an experimentally validated device simulation framework.
Effect of room temperature substrate resistivity on temperature-dependent CPW
line loss at various operating frequency bands are then presented. CPW lines
for GaN-on-high resistivity Si are shown to have a pronounced
temperature-dependence for temperatures above 150{\deg}C and have lower
substrate losses for frequencies above the X-band. On the other hand,
GaN-on-low resistivity Si is shown to be more temperature-insensitive and have
lower substrate losses than even HR-Si for lower operating frequencies. The
effect of various CPW geometries on substrate loss is also presented to
generalize the discussion. These results are expected to act as a benchmark for
temperature dependent substrate loss in GaN-on-Si RF technology.Comment: 7 pages (double-column), 10 figure
Buffer Induced Current-Collapse in GaN HEMTs on Highly Resistive Si Substrates
We demonstrate that the highly resistive Si substrate in GaN-on-Si RF HEMTs does not act as an insulator, but instead behaves as a conductive ground plane for static operation and can cause significant back-gate-induced current collapse. Substrate ramp characterization of the buffer shows good agreement with device simulations and indicates that the current collapse is caused by charge-redistribution within the GaN layer. Potential solutions, which alter charge storage and leakage in the epitaxy to counter this effect, are then presented
Evaluation of pulsed I-V analysis as validation tool of nonlinear RF models of GaN-based HFETs
This paper evaluates the applicability of pulsed I-V measurements as a tool for accurately extracting nonlinear gallium nitride (GaN)-based heterojunction field-effect transistor (HFET) models. Two wafers with the identical layer structure but different growth conditions have been investigated. A series of I-V measurements was performed under dc and pulsed conditions demonstrating a dramatic difference in the kink effect and current collapse (knee walkout) suggesting different trapping behaviors. However, when radio frequency (RF) I-V waveform measurements, utilizing active harmonic load-pull, were used to study the impact of these traps on the RF performance, both wafers gave good overall RF performance with no significant difference observed. This absence of correlation between pulsed I-V measurement results and RF performance raises a question about the applicability of pulsed I-V measurements alone as a tool for extracting nonlinear device models in the case of GaN HFETs
Electroluminescence of hot electrons in AlGaN/GaN high-electron-mobility transistors under radio frequency operation
Pulsed Large Signal RF Performance of Field-Plated Ga2O3 MOSFETs
Comparison between pulsed and CW large signal RF performance of field-plated β-Ga 2 O 3 MOSFETs has been reported. Reduced self-heating when pulse resulted in a power added efficiency of 12%, drain efficiency of 22.4%, output power density of 0.13 W/mm, and maximum gain up to 4.8 dB at 1 GHz for a 2-μm gate length device. Increased power dissipation for higher VDS and IDS resulted in a degradation in performance, which, thermal simulation showed, could be entirely explained by self-heating. Buffer and surface trapping contributions have been evaluated using gate and drain lag measurements, showing minimal impact on device performance. These results suggest that β-Ga 2 O 3 is a good candidate for future RF applications