Nevus sebaceus with syringocystadenoma papilliferum, prurigo nodularis, apocrine cystadenoma, basaloid follicular proliferation, and sebaceoma: case report and review of nevus sebaceus-associated conditions

Nevus sebaceus is a benign skin hamartoma of congenital onset that grows during puberty, and in adulthood can develop secondary benign and malignant neoplasms. The most common benign neoplasms occurring in nevus sebaceus are believed to be syringocystadenoma papilliferum, trichilemmoma, and trichoblastoma. A patient with nevus sebaceus developed not only syringocystadenoma papilliferum but also prurigo nodularis within her hamartomatous lesion; multiple biopsies were necessary to establish the diagnoses. Excision of the residual nevus sebaceus also revealed an apocrine cystadenoma, basaloid follicular proliferation, and sebaceoma. Also, it is important to select the appropriate biopsy site and size when evaluating a patient for secondary neoplasms within their nevus sebaceous. Indeed, more than one biopsy may be required if additional diagnoses are suspected

Novel 3D PZT thin film structure for micromechanics

In this work, fabrication and properties of 3-dimensional structures coated with piezoelectric Pb(Zr,Ti)O3 (PZT) thin films have been studied in order to improve the piezoelectric coupling into the third dimension. Calotte layers have been chosen as demonstration devices. The base diameters range from 40 to 120μm, the height varies between 10 to 40μm. A dynamic, in-situ co-sputtering process allowing for in-situ growth was applied. Micromoulds were formed by wet etching in silicon. The etchant was a HNA solution (HF, HNO3, CH3COOH) on a silicon dioxide mask. Calottes were obtained with the desired geometry and smooth surface state after few minutes etching time, and the use of chemical mechanical polishing (CMP). After deposition of the PZT membrane, deep silicon dry etching was then used to liberate the calotte layer. The dielectric constant and loss tangent of the calotte capacitors amounted to 830 and 5%, respectively (10kHz). The fundamental resonance frequencies varied between 2.5 and 16.5MHz, and were found to be inversely proportional to the base area of the calotte, the proportionality factor being 0.08Hz m

Efficient operation of a high-power X-band gyroklystron

Experimental studies of amplification in a two-cavity X-band gyroklystron are reported. The system utilizes a thermionic magnetron injection gun at voltages up to 440 kV and currents up to 190 A in 1-μs pulses. Optimum performance is achieved by tapering the magnetic-field profile. Peak powers of 20 MW in the TE01 mode at 9.87 GHz are measured with calibrated crystals and with methanol calorimetry. Resultant efficiencies are in excess of 31% and large-signal gains surpass 26 dB. The experimental results are in good agreement with simulated results from a partially self-consistent, nonlinear, steady-state code

High-power operation of a K-band second harmonic gyroklystron

Amplification studies of a two-cavity second-harmonic gyroklystron are reported. A magnetron injection gun produces a 440 kV, 200–245 A, 1 μs beam with an average perpendicular-to-parallel velocity ratio slightly less than 1. The TE011 input cavity is driven near 9.88 GHz and the TE021 output cavity resonates near 19.76 GHz. Peak powers exceeding 21 MW are achieved with an efficiency near 21% and a large signal gain above 25 dB. This performance represents the current state of the art for gyroklystrons in terms of the peak power normalized to the output wavelength squared

One-loop corrections to the Drell--Yan process in SANC (II). The neutral current case

Radiative corrections to the neutral current Drell--Yan-like processes are considered. Complete one-loop electroweak corrections are calculated within the SANC system. Theoretical uncertainties are discussed. Numerical results are presented for typical conditions of LHC experiments.Comment: 17 pages, 9 figures, 3 table

Osteoma Cutis Associated with Nevus Sebaceus: Case Report and Review of Cutaneous Osteoma-associated Skin Tumors (COASTs)

Osteoma cutis is a benign cutaneous lesion characterized by the presence of bone within the dermis or subcutaneous fat. It most often develops in association with other skin lesions such as cutaneous tumors. Nevus sebaceus is a benign hamartoma of the skin that is composed of epidermal and dermal components. It most commonly appears on the scalp and may give rise to either benign or malignant secondary neoplasms. The clinical and pathologic features of a 36-year-old man with a nevus sebaceus and associated osteoma cutis are described. In addition, osteoma cutis-associated neoplasms are reviewed. Secondary osteoma cutis has been observed with both benign and malignant neoplasms as well as various non-neoplastic skin conditions. However, to the best of our knowledge, osteoma cutis has not previously been described in association with nevus sebaceus. Nevus sebaceus can now be added to the list of cutaneous osteoma-associated skin tumors (COASTs)

Controlled formation of metallic nanowires via Au nanoparticle ac trapping

Applying ac voltages, we trapped gold nanoparticles between microfabricated electrodes under well-defined conditions. We demonstrate that the nanoparticles can be controllably fused together to form homogeneous gold nanowires with pre-defined diameters and conductance values. Whereas electromigration is known to form a gap when a dc voltage is applied, this ac technique achieves the opposite, thereby completing the toolkit for the fabrication of nanoscale junctions.Comment: Nanotechnology 18, 235202 (2007