Prediction of the shear strength of reinforced masonry walls using a large experimental database and artificial neural networks

This paper analyses the accuracy of a selection of expressions currently available to estimate the in-plane shear strength of reinforced masonry (RM) walls, including those presented in some international masonry codes. For this purpose, predictions of such expressions are compared with a set of xperimental results reported in the literature. The experimental database includes specimens built with ceramic bricks and concrete blocks tested in partially and fully grouted conditions, which typically present a shear failure mode. Based on the experimental data collected and using artificial neural networks (ANN), this paper presents alternative expressions to the different existing methods to predict the in-plane shear strength of RM walls. The wall aspect ratio, the axial pre-compression level on the wall, the compressive strength of masonry, as well as the amount and spacing of vertical and horizontal reinforcement throughout the wall are taken into consideration as the input parameters for the proposed expressions. The results obtained show that ANN-based proposals give good predictions and in general fit the experimental results better than other calculation methods.This work was supported by the Fondo Nacional de Ciencia y Tecnologia de Chile, (Fondecyt de Iniciacion) [grant number 11121161].Aguilar, V.; Sandoval, C.; Adam Martínez, JM.; Garzón-Roca, J.; Valdebenito, G. (2016). Prediction of the shear strength of reinforced masonry walls using a large experimental database and artificial neural networks. Structure and Infrastructure Engineering. 12(12):1661-1674. https://doi.org/10.1080/15732479.2016.1157824S16611674121

Systematic Review of Potential Health Risks Posed by Pharmaceutical, Occupational and Consumer Exposures to Metallic and Nanoscale Aluminum, Aluminum Oxides, Aluminum Hydroxide and Its Soluble Salts

Aluminum (Al) is a ubiquitous substance encountered both naturally (as the third most abundant element) and intentionally (used in water, foods, pharmaceuticals, and vaccines); it is also present in ambient and occupational airborne particulates. Existing data underscore the importance of Al physical and chemical forms in relation to its uptake, accumulation, and systemic bioavailability. The present review represents a systematic examination of the peer-reviewed literature on the adverse health effects of Al materials published since a previous critical evaluation compiled by Krewski et al. (2007). Challenges encountered in carrying out the present review reflected the experimental use of different physical and chemical Al forms, different routes of administration, and different target organs in relation to the magnitude, frequency, and duration of exposure. Wide variations in diet can result in Al intakes that are often higher than the World Health Organization provisional tolerable weekly intake (PTWI), which is based on studies with Al citrate. Comparing daily dietary Al exposures on the basis of “total Al”assumes that gastrointestinal bioavailability for all dietary Al forms is equivalent to that for Al citrate, an approach that requires validation. Current occupational exposure limits (OELs) for identical Al substances vary as much as 15-fold. The toxicity of different Al forms depends in large measure on their physical behavior and relative solubility in water. The toxicity of soluble Al forms depends upon the delivered dose of Al+ 3 to target tissues. Trivalent Al reacts with water to produce bidentate superoxide coordination spheres [Al(O2)(H2O4)+ 2 and Al(H2O)6 + 3] that after complexation with O2•−, generate Al superoxides [Al(O2•)](H2O5)]+ 2. Semireduced AlO2• radicals deplete mitochondrial Fe and promote generation of H2O2, O2 • − and OH•. Thus, it is the Al+ 3-induced formation of oxygen radicals that accounts for the oxidative damage that leads to intrinsic apoptosis. In contrast, the toxicity of the insoluble Al oxides depends primarily on their behavior as particulates. Aluminum has been held responsible for human morbidity and mortality, but there is no consistent and convincing evidence to associate the Al found in food and drinking water at the doses and chemical forms presently consumed by people living in North America and Western Europe with increased risk for Alzheimer\u27s disease (AD). Neither is there clear evidence to show use of Al-containing underarm antiperspirants or cosmetics increases the risk of AD or breast cancer. Metallic Al, its oxides, and common Al salts have not been shown to be either genotoxic or carcinogenic. Aluminum exposures during neonatal and pediatric parenteral nutrition (PN) can impair bone mineralization and delay neurological development. Adverse effects to vaccines with Al adjuvants have occurred; however, recent controlled trials found that the immunologic response to certain vaccines with Al adjuvants was no greater, and in some cases less than, that after identical vaccination without Al adjuvants. The scientific literature on the adverse health effects of Al is extensive. Health risk assessments for Al must take into account individual co-factors (e.g., age, renal function, diet, gastric pH). Conclusions from the current review point to the need for refinement of the PTWI, reduction of Al contamination in PN solutions, justification for routine addition of Al to vaccines, and harmonization of OELs for Al substances

Steel fibres effects on the flexural cracking behaviour of reinforced high strength concrete beams with particular reference to the major design codes crack width models

International audienc