Humidity effects on adhesion of nickel-zinc ferrite in elastic contact with magnetic tape and itself

The effects of humidity on the adhesion of Ni-Zn ferrite and magnetic tape in elastic contact with a Ni-Zn ferrite hemispherical pin in moist nitrogen were studied. Adhesion was independent of normal load in dry, humid, and saturated nitrogen. Ferrites adhere to ferrites in a saturated atmosphere primarily from the surface tension effects of a thin film of water adsorbed on the ferrite surfaces. The surface tension of the water film calculated from the adhesion results was 48 times 0.00001 to 56 times 0.00001 N/cm; the accepted value for water is 72.7 x 0.00001 N/cm. The adhesion of ferrite-ferrite contacts increased gradually with increases in relative humidity to 80 percent, but rose rapidly above 80 percent. The adhesion at saturation was 30 times or more greater than that below 80 percent relative humidity. Although the adhesion of magnetic tape - ferrite contacts remained low below 40 percent relative humidity and the effect of humidity was small, the adhesion increased considerably with increasing relative humidity above 40 percent. The changes in adhesion of elastic contacts were reversible on humidifying and dehumidifying

Diagnosed Concussion History Is Associated With Increased Risk for Lower-Extremity Injury in R.O.T.C. Cadets

Click the PDF icon to download the abstract

Development of a forced-convection gas target for improved thermal performance

Introduction The internal pressure experienced by a gas tar-get during irradiation is dependent on the beam energy deposited in the target, the beam cur-rent, and the thermal behaviour of the target. [1] The maximum beam energy deposited is a function of the cyclotron capabilities and the gas inventory within the target. The maximum beam current is limited by the pressure produced in the target and the ability of the target assembly to remain intact. This is also a function of the thermal behaviour of the target, which is difficult to predict a priori since it is dependent on such things as convection currents that occur during irradiation. We conducted bench tests with model gas targets with and without forced convection currents to observe the effect on thermal behaviour. Based on those results we constructed a prototype gas target, suitable for irradiation, with an internal fan assembly that is rotated via external magnets. Material and Methods Bench tests were conducted with cylindrical and conical target bodies of aluminum. A nickel-chromium heater wire was inserted into the gas volume through the normal beam entrance port (FIGURE 1) to heat the gas while water cooling was applied to the target body. The voltage and current of the heater coil was monitored along with the pressure inside the target and the water inlet and outlet temperature. In the case of tests with a driven fan blade either the voltage applied to the electric motor was monitored or the fan speed itself was recorded. By assuming the ideal gas law, the pressure gives the average bulk temperature and a global heat transfer coefficient can be calculated between the target gas and the cooling water. [2] A cylindrical target body was constructed that incorporated a fan blade driven by an external motor. This assembly used a simple o-ring seal on the rotating shaft. This seal was not robust enough for any tests under beam conditions. A prototype design suitable for in-beam operation employs a propeller mounted on a rotating disc housing two samarium cobalt magnets and spinning on two micro-bearings which are constructed to operate in high temperature environments. The micro-bearings are mounted on a pin projecting from a plate welded to the back of the gas target to allow assembly of the fan mechanism prior to attachment to the body (FIGURE 2)

Hydrogen Desorption Properties of Bulk and Nanoconfined LiBH4-NaAlH4

Nanoconfinement of 2LiBH4-NaAlH4 into a mesoporous carbon aerogel scaffold with a pore size, BET surface area and total pore volume of Dmax = 30 nm, SBET = 689 m2/g and Vtot = 1.21 mL/g, respectively is investigated. Nanoconfinement of 2LiBH4-NaAlH4 facilitates a reduction in the temperature of the hydrogen release by 132 °C, compared to that of bulk 2LiBH4-NaAlH4 and the onset of hydrogen release is below 100 °C. The reversible hydrogen storage capacity is also significantly improved for the nanoconfined sample, maintaining 83% of the initial hydrogen content after three cycles compared to 47% for that of the bulk sample. During nanoconfinement, LiBH4 and NaAlH4 reacts to form LiAlH4 and NaBH4 and the final dehydrogenation products, obtained at 481 °C are LiH, LiAl, AlB2 and Al. After rehydrogenation of the nanoconfined sample at T = 400 °C and p(H2) = 126 bar, amorphous NaBH4 is recovered along with unreacted LiH, AlB2 and Al and suggests that NaBH4 is the main compound that can reversibly release and uptake hydrogen

On the accretion mode of the intermediate polar V1025 Centauri

The long white-dwarf spin periods in the magnetic cataclysmic variables EX Hya and V1025 Cen imply that if the systems possess accretion discs then they cannot be in equilibrium. It has been suggested that instead they are discless accretors in which the spin-up torques resulting from accretion are balanced by the ejection of part of the accretion flow back towards the secondary. We present phase-resolved spectroscopy of V1025 Cen aimed at deducing the nature of the accretion flow, and compare this with simulations of a discless accretor. We find that both the conventional disc-fed model and the discless-accretor model have strengths and weaknesses, and that further work is needed before we can decide which applies to V1025 Cen.Comment: 9 pages, 8 figures, To appear in MNRAS, includes low-res figures to reduce siz

Missing Momentum Reconstruction and Spin Measurements at Hadron Colliders

We study methods for reconstructing the momenta of invisible particles in cascade decay chains at hadron colliders. We focus on scenarios, such as SUSY and UED, in which new physics particles are pair produced. Their subsequent decays lead to two decay chains ending with neutral stable particles escaping detection. Assuming that the masses of the decaying particles are already measured, we obtain the momenta by imposing the mass-shell constraints. Using this information, we develop techniques of determining spins of particles in theories beyond the standard model. Unlike the methods relying on Lorentz invariant variables, this method can be used to determine the spin of the particle which initiates the decay chain. We present two complementary ways of applying our method by using more inclusive variables relying on kinematic information from one decay chain, as well as constructing correlation variables based on the kinematics of both decay chains in the same event.Comment: Version to appear in JHE

The estimation of neutrino fluxes produced by proton-proton collisions at s=14\sqrt{s}=14 TeV of the LHC

Intense and collimated neutrino beams are produced by charm and beauty particle decays from proton-proton collisions at the LHC. A neutrino experiment would be run parasitically without interrupting the LHC physics program during the collider run. We estimate the neutrino fluxes from proton-proton collisions at $\sqrt{s}=14$ TeV of the LHC with the designed luminosity, 10^{34} \lumi. By mounting about 200 tons of fiducial volume of a neutrino detector at 300 \m away from the interaction point, about 150,000 of charged current neutrino events per year can be observable.Comment: 8 pages, Accepted in JHE

Every partridge counts, successful techniques used in the captive conservation breeding programme for wild grey partridge in Ireland

Between 1998 and 2001 the last remaining wild grey partridge (Perdix perdix) population in Ireland faced imminent extinction with an estimated spring population of 4–6 pairs, and an autumn population of 22–24 birds. A captive breeding programme began in 2002 with two pairs of grey partridge. In the most successful year in 2010, 39 pairs produced a total of 510 chicks. Average chick survival rate was 65.13%. At 88.9 the highest chick survival rate was achieved in 2011. Chick survival of parent–reared birds in captivity is defined by the number of juveniles surviving at age six weeks: similar to estimations used for wild populations of grey partridge. Family coveys were released in late summer to early autumn. In most instances the entire family cohort was released as one unit. However, in coveys of twenty or above, an average of five parent–reared poults were held back as breeding stock for the following year. In early spring of the following year, birds held back were paired with single males or females trapped from the wild. The techniques we used were traditional and labour intensive but highly effective. We recommend that other grey partridge recovery projects should consider captive breeding using the methods employed in this programme to compliment other game management methods used

Dynamic compression can inhibit chondrogenesis of mesenchymal stem cells.

The objective of this study was to investigate the influence of dynamic compressive loading on chondrogenesis of mesenchymal stem cells (MSCs) in the presence of TGF-beta3. Isolated porcine MSCs were suspended in 2% agarose and subjected to intermittent dynamic compression (10% strain) for a period of 42 days in a dynamic compression bioreactor. After 42 days in culture, the free-swelling specimens exhibited more intense alcian blue staining for proteoglycans, while immunohistochemical analysis revealed increased collagen type II immunoreactivity. Glycosaminoglycan (GAG) content increased with time for both free-swelling and dynamically loaded constructs, and by day 42 it was significantly higher in both the core (2.5+/-0.21%w/w vs. 0.94+/-0.03%w/w) and annulus (1.09+/-0.09%w/w vs. 0.59+/-0.08%w/w) of free-swelling constructs compared to dynamically loaded constructs. This result suggests that further optimization is required in controlling the biomechanical and/or the biochemical environment if such stimuli are to have beneficial effects in generating functional cartilaginous tissue