Thermal switching rate of a ferromagnetic material with uniaxial anisotropy

The field dependence of the thermal switching rate of a ferromagnetic material with uniaxial anisotropy was studied by solving the Fokker-Planck equation. We derived the analytical expression of the thermal switching rate using the mean first-passage time approach, and found that Brown's formula [Phys. Rev. 130, 1677 (1963)] is applicable even in the low barrier limit by replacing the attempt frequency with the proper factor which is expressed by the error function.Comment: 5 pages, 2 figure

Raman spectroscopy on mechanically exfoliated pristine graphene ribbons

We present Raman spectroscopy measurements of non-etched graphene nanoribbons, with widths ranging from 15 to 160 nm, where the D-line intensity is strongly dependent on the polarization direction of the incident light. The extracted edge disorder correlation length is approximately one order of magnitude larger than on previously reported graphene ribbons fabricated by reactive ion etching techniques. This suggests a more regular crystallographic orientation of the non-etched graphene ribbons here presented. We further report on the ribbons width dependence of the line-width and frequency of the long-wavelength optical phonon mode (G-line) and the 2D-line of the studied graphene ribbons

Contact-less characterizations of encapsulated graphene p-n junctions

Accessing intrinsic properties of a graphene device can be hindered by the influence of contact electrodes. Here, we capacitively couple graphene devices to superconducting resonant circuits and observe clear changes in the resonance- frequency and -widths originating from the internal charge dynamics of graphene. This allows us to extract the density of states and charge relaxation resistance in graphene p-n junctions without the need of electrical contacts. The presented characterizations pave a fast, sensitive and non-invasive measurement of graphene nanocircuits.Comment: 4 figures, supplementary information on reques

Etched graphene quantum dots on hexagonal boron nitride

We report on the fabrication and characterization of etched graphene quantum dots (QDs) on hexagonal boron nitride (hBN) and SiO2 with different island diameters. We perform a statistical analysis of Coulomb peak spacings over a wide energy range. For graphene QDs on hBN, the standard deviation of the normalized peak spacing distribution decreases with increasing QD diameter, whereas for QDs on SiO2 no diameter dependency is observed. In addition, QDs on hBN are more stable under the influence of perpendicular magnetic fields up to 9T. Both results indicate a substantially reduced substrate induced disorder potential in graphene QDs on hBN

Even denominator fractional quantum Hall states in higher Landau levels of graphene

An important development in the field of the fractional quantum Hall effect has been the proposal that the 5/2 state observed in the Landau level with orbital index $n = 1$ of two dimensional electrons in a GaAs quantum well originates from a chiral $p$-wave paired state of composite fermions which are topological bound states of electrons and quantized vortices. This state is theoretically described by a "Pfaffian" wave function or its hole partner called the anti-Pfaffian, whose excitations are neither fermions nor bosons but Majorana quasiparticles obeying non-Abelian braid statistics. This has inspired ideas on fault-tolerant topological quantum computation and has also instigated a search for other states with exotic quasiparticles. Here we report experiments on monolayer graphene that show clear evidence for unexpected even-denominator fractional quantum Hall physics in the $n=3$ Landau level. We numerically investigate the known candidate states for the even-denominator fractional quantum Hall effect, including the Pfaffian, the particle-hole symmetric Pfaffian, and the 221-parton states, and conclude that, among these, the 221-parton appears a potentially suitable candidate to describe the experimentally observed state. Like the Pfaffian, this state is believed to harbour quasi-particles with non-Abelian braid statistic

Intermediate-mass-ratio-inspirals in the Einstein Telescope: I. Signal-to-noise ratio calculations

The Einstein Telescope (ET) is a proposed third generation ground-based interferometer, for which the target is a sensitivity that is a factor of ten better than Advanced LIGO and a frequency range that extends down to about 1Hz. ET will provide opportunities to test Einstein's theory of relativity in the strong field and will realize precision gravitational wave astronomy with a thousandfold increase in the expected number of events over the advanced ground-based detectors. A design study for ET is currently underway, so it is timely to assess the science that could be done with such an instrument. This paper is the first in a series that will carry out a detailed study of intermediate-mass-ratio inspirals (IMRIs) for ET. In the context of ET, an IMRI is the inspiral of a neutron star or stellar-mass black hole into an intermediate mass black hole (IMBH). In this paper we focus on the development of IMRI waveform models for circular and equatorial inspirals. We consider two approximations for the waveforms, which both incorporate the inspiral, merger and ringdown phases in a consistent way. One approximation, valid for IMBHs of arbitrary spin, uses the transition model of Ori and Thorne [1] to describe the merger, and this is then matched smoothly onto a ringdown waveform. The second approximation uses the Effective One Body (EOB) approach to model the merger phase of the waveform and is valid for non-spinning IMBHs. In this paper, we use both waveform models to compute signal-to-noise ratios (SNRs) for IMRI sources detectable by ET. At a redshift of z=1, we find typical SNRs for IMRI systems with masses 1.4+100 solar masses, 10+100 solar masses, 1.4+500 solar masses and 10+500 solar masses of about 10-25, 40-80, 3-15 and 10-60, respectively. We also find that the two models make predictions for non-spinning inspirals that are consistent to about ten percent.Comment: 27 pages, 9 figures, v3 has an updated reference for consistency with accepted versio