15 research outputs found
The oxidation degradation of aromatic compounds
A series of experiments were conducted which focused on understanding the role that the O atom addition to aromatic rings plays in the oxidation of benzene and toluene. Flow reactor studies of the oxidation of toluene gave an indication of the amount of O atoms available during an oxidation and the degree to which the O atom adds to the ring. Flow reactor studies of the oxidation of toluene and benzene to which NO2 was added, have shown that NO2 appears to suppress the formation of O atoms and consequently reduce the amount of phenols and cresols formed by O atom addition. A high temperature pyrolysis study of phenol has confirmed that the major decomposition products are carbon monoxide and cyclopentadiene. A preliminary value for the overall decomposition rate constant was also obtained
VIBRATIONAL ENERGY TRANSFER IN PROPYNAL UNDER COLLISIONLESS
Research carried out at Brookhaven National Laboratory under contract with the U.S. Department of Energy and supported by its Office of Basic Energy Sciences.Author Institution:Investigations of vibrational energy redistribution in the polyatomic, propynal - , will be discussed. Dye laser-induced, visible fluorescence following low-level vibrational excitation with a laser is used to monitor the internal energy distribution under collisionless conditions ( to torr). Time resolved spectroscopic changes in (C-C Stretch), the pumped mode, show that increases in population in the v=1 level follow closely the shape of the excitation pulse and that decay is exponential to 10 . However, concomitant changes in hot bands of other modes, especially those of lower frequency, are not obvious. These results will be discussed in terms of intramolecular, V-V, and V-T energy transfer
High pressure effects on the mutual sensitization of the oxidation of NO and CH4–C2H6 blends
International audiencehe mutual sensitization of the oxidation of NO and a CH4–C2H6 (10 : 1) simulated natural gas (NG) blend was studied under fuel lean conditions (Φ = 0.5) at 50 atm and 1000–1500 K in the UIC high pressure shock tube (HPST). New experimental results were also obtained for the mutual sensitization of methane and the NG blend in the CNRS jet stirred reactor (JSR) at 10 atm. A detailed chemical kinetic model was assembled to describe the observed changes in reactivity in the CH4 and NG blends, with and without NO, in the HPST and the JSR. The data and the validated model (tested against a variety of targets) show a reduced difference of reactivity between methane and NG blends in the presence of NO at characteristic reaction times for the JSR (250–1000 µs). However the HPST data and subsequent simulations using the validated model have revealed that at higher pressures and in the millisecond time scale regime representative of the HPST experiments (and practical combustion devices) there still persists a significant difference in reactivity between methane and NG blends in the presence of NO. The experimental data, the model development and validations and its predictions and utility as a tool to probe the NO–hydrocarbon sensitization effects under practical combustion conditions is discussed
Chemical Kinetic Influences of Alkyl Chain Structure on the High Pressure and Temperature Oxidation of a Representative Unsaturated Biodiesel: Methyl Nonenoate
The
high pressure and temperature oxidation of methyl <i>trans</i>-2-nonenoate, methyl <i>trans</i>-3-nonenoate, 1-octene,
and <i>trans</i>-2-octene are investigated experimentally
to probe the influence of the double bond position on the chemical
kinetics of long esters and alkenes. Single pulse shock tube experiments
are performed in the ranges <i>p</i> = 3.8–6.2 MPa
and <i>T</i> = 850–1500 K, with an average reaction
time of 2 ms. Gas chromatographic measurements indicate increased
reactivity for <i>trans</i>-2-octene compared to 1-octene,
whereas both methyl nonenoate isomers have reactivities similar to
that of 1-octene. A difference in the yield of stable intermediates
is observed for the octenes when compared to the methyl nonenoates.
Chemical kinetic models are developed with the aid of the Reaction
Mechanism Generator to interpret the experimental results. The models
are created using two different base chemistry submodels to investigate
the influence of the foundational chemistry (i.e., C0–C4),
whereas Monte Carlo simulations are performed to examine the quality
of agreement with the experimental results. Significant uncertainties
are found in the chemistry of unsaturated esters with the double bonds
located close to the ester groups. This work highlights the importance
of the foundational chemistry in predictive chemical kinetics of biodiesel
combustion at engine relevant conditions
Single Pulse Shock Tube Study of Allyl Radical Recombination
The
recombination and disproportionation of allyl radicals has
been studied in a single pulse shock tube with gas chromatographic
measurements at 1–10 bar, 650–1300 K, and 1.4–2
ms reaction times. 1,5-Hexadiene and allyl iodide were used as precursors.
Simulation of the results using derived rate expressions from a complementary
diaphragmless shock tube/laser schlieren densitometry study provided
excellent agreement with precursor consumption and formation of all
major stable intermediates. No significant pressure dependence was
observed at the present conditions. It was found that under the conditions
of these experiments, reactions of allyl radicals in the cooling wave
had to be accounted for to accurately simulate the experimental results,
and this unusual situation is discussed. In the allyl iodide experiments,
higher amounts of allene, propene, and benzene were found at lower
temperatures than expected. Possible mechanisms are discussed and
suggest that iodine containing species are responsible for the low
temperature formation of allene, propene, and benzene
Low-Energy, Low-Yield Photoionization, and Production of 8-Oxo-2‘-deoxyguanosine and Guanine from 2‘-Deoxyguanosine
Elevated Pressure Thermal Experiments and Modeling Studies on the Water-Gas Shift Reaction
A physics-based approach to modeling real-fuel combustion chemistry - I. Evidence from experiments, and thermodynamic, chemical kinetic and statistical considerations
Real distillate fuels usually contain thousands of hydrocarbon components. Over a wide range of combustion conditions, large hydrocarbon molecules undergo thermal decomposition to form a small set of low molecular weight fragments. In the case of conventional petroleum-derived fuels, the composition variation of the decomposition products is washed out due to the principle of large component number in real, multicomponent fuels. From a joint consideration of elemental conservation, thermodynamics and chemical kinetics, it is shown that the composition of the thermal decomposition products is a weak function of the thermodynamic condition, the fuel-oxidizer ratio and the fuel composition within the range of temperatures of relevance to flames and high temperature ignition. Based on these findings, we explore a hybrid chemistry (HyChem) approach to modeling the high-temperature oxidation of real, distillate fuels. In this approach, the kinetics of thermal and oxidative pyrolysis of the fuel is modeled using lumped kinetic parameters derived from experiments, while the oxidation of the pyrolysis fragments is described by a detailed reaction model. Sample model results are provided to support the HyChem approach