14 research outputs found
Advanced electron cyclotron heating and current drive experiments on the stellarator Wendelstein 7-X
During the first operational phase (OP 1.1) of Wendelstein 7-X (W7-X) electron cyclotron resonance heating (ECRH) was the exclusive heating method and provided plasma start-up, wall conditioning, heating and current drive. Six gyrotrons were commissioned for OP1.1 and used in parallel for plasma operation with a power of up to 4.3 MW. During standard X2-heating the spatially localized power deposition with high power density allowed controlling the radial profiles of the electron temperature and the rotational transform. Even though W7-X was not fully equipped with first wall tiles and operated with a graphite limiter instead of a divertor, electron densities of n e > 3·1019 m-3 could be achieved at electron temperatures of several keV and ion temperatures above 2 keV. These plasma parameters allowed the first demonstration of a multipath O2-heating scenario, which is envisaged for safe operation near the X-cutoff-density of 1.2·1020 m-3 after full commissioning of the ECRH system in the next operation phase OP1.2
First experiments on plasma production using field-aligned ICRF fast wave antennas in the large helical device
The results of the first experimental series to produce a plasma using the ion cyclotron range of frequency (ICRF) in the large helical device (LHD) within the minority scenario developed at Uragan-2M (U-2M) are presented. The motivation of this study is to provide plasma creation in conditions when an electron cyclotron resonance heating start-up is not possible, and in this way widen the operational frame of helical machines. The major constraint of the experiments is the low RF power to reduce the possibility of arcing. No dangerous voltage increase at the radio-frequency (RF) system elements and no arcing has been detected. As a result, a low plasma density is obtained and the antenna-plasma coupling is not optimal. However, such plasmas are sufficient to be used as targets for further neutral beam injection (NBI) heating. This will open possibilities to explore new regimes of operation at LHD and Wendelstein 7-X (W7-X) stellarator. The successful RF plasma production in LHD in this experimental series stimulates the planning of further studies of ICRF plasma production aimed at increasing plasma density and temperature within the ICRF minority scenario as well as investigating the plasma prolongation by NBI heating
Click to release:instantaneous doxorubicin elimination upon tetrazine ligation
\u3cp\u3eEliminated without a trace: The fastest click reaction, the highly selective inverse-electron-demand Diels-Alder reaction, has been modified to enable selective bioorthogonal release. Thus, the click reaction of a tetrazine with a drug-bound trans-cyclooctene caused the instantaneous release of the drug and CO\u3csub\u3e2\u3c/sub\u3e (see scheme). One possible application is the chemically triggered release, and thereby activation, of a drug from a tumor-bound antibody-drug conjugate.\u3c/p\u3
Wall conditioning throughout the first carbon divertor campaign on Wendelstein 7-X
Controlling the recycling of hydrogen and the release of impurities from the plasma facing components proved to be essential and challenging throughout the first divertor campaign on W7-X. This paper discusses the conditioning requirements throughout the first divertor campaign on Wendelstein 7-X. Baking at 150°C and glow discharge conditioning (GDC) in H2 is performed after the initial pump down of the vacuum vessel. Experimental programs in hydrogen are interlaced with He discharges to desaturate the wall from hydrogen, recover good recycling conditions and hence establish plasma density control. Optimized He ECRH wall conditioning procedures consisted of sequences of short discharges with fixed duty cycle. He-GDC remained however needed before each experimental day to fully offset the hydrogen inventory build-up. A significant increase in the divertor temperature is observed throughout an operational day, enhancing outgassing of CO and H2O. Preliminary recombination-diffusion modelling of hydrogen outgassing suggests enhanced diffusion to deeper surface layers with increasing wall temperature, which results in better wall pumping. This indicates that the experienced plasma performance degradation throughout an operational day results from increased impurity outgassing at higher wall temperature rather than hydrogen saturation of the wall
First experiments on plasma production using field-aligned ICRF fast wave antennas in the large helical device
Advanced electron cyclotron heating and current drive experiments on the stellarator Wendelstein 7-X
During the first operational phase (OP 1.1) of Wendelstein 7-X (W7-X) electron cyclotron resonance heating (ECRH) was the exclusive heating method and provided plasma start-up, wall conditioning, heating and current drive. Six gyrotrons were commissioned for OP1.1 and used in parallel for plasma operation with a power of up to 4.3 MW. During standard X2-heating the spatially localized power deposition with high power density allowed controlling the radial profiles of the electron temperature and the rotational transform. Even though W7-X was not fully equipped with first wall tiles and operated with a graphite limiter instead of a divertor, electron densities of n e > 3·1019 m-3 could be achieved at electron temperatures of several keV and ion temperatures above 2 keV. These plasma parameters allowed the first demonstration of a multipath O2-heating scenario, which is envisaged for safe operation near the X-cutoff-density of 1.2·1020 m-3 after full commissioning of the ECRH system in the next operation phase OP1.2
ICRF Plasma Production with the W7-X Like Antenna in the Uragan-2M Stellarator
The results of the plasma start-up with ICRH of U-2M RF discharges in H2+He mixture with newly implemented controlled gas H2 concentration are presented. The W7-X like ICRH antenna operated in monopole phasing with applied RF power of ∼ 100 kW. We investigated plasma start-up in the pressure range p = 6×10−4 - 9×10−2 Pa. Plasma production with an average density of up to Ne ∼ 1013 cm−3 was observed at frequencies the fundamental harmonic of the hydrogen cyclotron frequency