State scaling of continuous-time sigma-delta modulators

In this paper, the common method of scaling the feedback coefficients of continuous time sigma delta modulators in order to stabilize the system is enhanced. The presented approach scales the different states of the system instead of the coefficients. The new corresponding coefficients are then calculated from the solution of the state space description. Therewith, it is possible to tune the maximum out-of-band gain directly in continuous time. In addition, the input amplitude distribution between each quantization level of multi bit sigma-delta modulator can be adapted

STF Optimierung von single-bit CT ΣΔ Modulatoren basierend auf skalierten Filterkoeffizienten

Die vorliegende Arbeit beschäftigt sich mit dem Signalübertragungsverhalten von single-bit continuous-time (CT) ΣΔ Modulatoren. Dabei liegt der Fokus der Untersuchung auf dem Peaking der Signaltransferfunktion (STF). Dieser Effekt kann die Performance und die Stabilität des Gesamtsystems negativ beeinflussen, da bei auftretendem STF-Peaking Signale außerhalb des Signalbands verstärkt werden. In dieser Arbeit wird ein neuer Ansatz zur Reduktion des Peakings vorgestellt, der auf der Optimierung der Systemdynamik basiert. Dabei werden die Filterkoeffizienten des Modulators systematisch angepasst. Anhand eines Beispielsystems wird gezeigt, dass der Ansatz genutzt werden kann, um das Übertragungsverhalten des Modulators abhängig vom Ausgangssystem zu verändern. So kann entweder die Systemsperformance verbessert werden, ohne Peaking in der STF zu erzeugen, oder das STF-Peaking reduziert werden, ohne die Systemperformance stark zu beeinflussen.DF

Magnesium Phosphate Cement as Mineral Bone Adhesive

Mineral bone cements were actually not developed for their application as bone-bonding agents, but as bone void fillers. In particular, calcium phosphate cements (CPC) are considered to be unsuitable for that application, particularly under moist conditions. Here, we showed the ex vivo ability of different magnesium phosphate cements (MPC) to adhere on bovine cortical bone substrates. The cements were obtained from a mixture of farringtonite (Mg$_3$(PO$_4$)$_2$) with different amounts of phytic acid (C$_6$H$_{18}$O$_{24}$P$_6$, inositol hexaphosphate, IP6), whereas cement setting occurred by a chelation reaction between Mg$^{2+}$ ions and IP6. We were able to show that cements with 25% IP6 and a powder-to-liquid ratio (PLR) of 2.0 g/mL resulted in shear strengths of 0.81 ± 0.12 MPa on bone even after 7 d storage in aqueous conditions. The samples showed a mixed adhesive–cohesive failure with cement residues on the bone surface as indicated by scanning electron microscopy and energy-dispersive X-ray analysis. The presented material demonstrated appropriate bonding characteristics, which could enable a broadening of the mineral bone cements’ application field to bone adhesive

Analyzing the neocortical fine-structure

Cytoarchitectonic fields of the human neocortex are defined by characteristic variations in the composition of a general six-layer structure. It is commonly accepted that these fields correspond to functionally homogeneous entities. Diligent techniques were developed to characterize cytoarchitectonic fields by staining sections of post-mortem brains and subsequent statistical evaluation. Fields were found to show a considerable interindividual variability in extent and relation to macroscopic anatomical landmarks. With upcoming new high-resolution magnetic resonance imaging (MRI) protocols, it appears worthwhile to examine the feasibility of characterizing the neocortical fine-structure from anatomical MRI scans, thus, defining neocortical fields by in vivo techniques. A fixated brain hemisphere was scanned at a resolution of approximately 0.3 mm. After correcting for intensity inhomogeneities in the dataset, the cortex boundaries (the white/grey matter and grey matter/background interfaces) were determined as a triangular mesh. Radial intensity profiles following the shortest path through the cortex were computed and characterized by a sparse set of features. A statistical similarity measure between features of different regions was defined, and served to define the extent of Brodmann’s Areas 4, 17, 44 and 45 in this dataset

Combined Description of N‾N\bf{\overline{N}N} Scattering and Annihilation With A Hadronic Model

A model for the nucleon-antinucleon interaction is presented which is based on meson-baryon dynamics. The elastic part is the $G$-parity transform of the Bonn $NN$ potential. Annihilation into two mesons is described in terms of microscopic baryon-exchange processes including all possible combinations of $\pi,\eta,\rho,\omega,a_0,f_0,a_1,f_1,a_2,f_2,K,K^*$. The remaining annihilation part is taken into account by a phenomenological energy- and state independent optical potential of Gaussian form. The model enables a simultaneous description of nucleon-antinucleon scattering and annihilation phenomena with fair quality.Comment: revised version, REVTEX, 9 pages, 10 figures available from this URL ftp://ikp113.ikp.kfa-juelich.de/pub/kph140/nucl-th.9411014.u

Measurement of the Omega_c Lifetime

We present the measurement of the lifetime of the Omega_c we have performed using three independent data samples from two different decay modes. Using a Sigma- beam of 340 GeV/c we have obtained clean signals for the Omega_c decaying into Xi- K- pi+ pi+ and Omega- pi+ pi- pi+, avoiding topological cuts normally used in charm analysis. The short but measurable lifetime of the Omega_c is demonstrated by a clear enhancement of the signals at short but finite decay lengths. Using a continuous maximum likelihood method we determined the lifetime to be tau(Omega_c) = 55 +13-11(stat) +18-23(syst) fs. This makes the Omega_c the shortest living weakly decaying particle observed so far. The short value of the lifetime confirms the predicted pattern of the charmed baryon lifetimes and demonstrates that the strong interaction plays a vital role in the lifetimes of charmed hadrons.Comment: 15 pages, including 7 figures; gzipped, uuencoded postscrip

Influence of thermal history on the structure and properties of silicate glasses

We studied a set of float glass samples prepared with different fictive temperature by previous annealing around the glass transition temperature. We compared the results to previous measurements on a series of amorphous silica samples, also prepared with different fictive temperature. We showed that the modifications on the structure at a local scale are very small, the changes of physical properties are moderate but the changes on density fluctuations at a nanometer scale are rather large: 12 and 20% in float glass and silica, for relative changes of fictive temperature equal to 13 and 25% respectively. Local order and mechanical properties of silica vary in the opposite way compared to float glass (anomalous behavior) but the density fluctuations in both glasses increase with temperature and fictive temperature

Authorship in scientific publications: analysis and recommendations.

In 2008, a Swiss Academies of Arts and Sciences working group chaired by Professor Emilio Bossi issued a "Memorandum on scientific integrity and the handling of misconduct in the scientific context", together with a paper setting out principles and procedures concerning integrity in scientific research. In the Memorandum, unjustified claims of authorship in scientific publications are referred to as a form of scientific misconduct - a view widely shared in other countries. In the Principles and Procedures, the main criteria for legitimate authorship are specified, as well as the associated responsibilities. It is in fact not uncommon for disputes about authorship to arise with regard to publications in fields where research is generally conducted by teams rather than individuals. Such disputes may concern not only the question who is or is not to be listed as an author but also, frequently, the precise sequence of names, if the list is to reflect the various authors' roles and contributions. Subjective assessments of the contributions made by the individual members of a research group may differ substantially. As scientific collaboration - often across national boundaries - is now increasingly common, ensuring appropriate recognition of all parties is a complex matter and, where disagreements arise, it may not be easy to reach a consensus. In addition, customs have changed over the past few decades; for example, the practice of granting "honorary" authorship to an eminent researcher - formerly not unusual - is no longer considered acceptable. It should be borne in mind that the publications list has become by far the most important indicator of a researcher's scientific performance; for this reason, appropriate authorship credit has become a decisive factor in the careers of young researchers, and it needs to be managed and protected accordingly. At the international and national level, certain practices have therefore developed concerning the listing of authors and the obligations of authorship. The Scientific Integrity Committee of the Swiss Academies of Arts and Sciences has collated the relevant principles and regulations and formulated recommendations for authorship in scientific publications. These should help to prevent authorship disputes and offer guidance in the event of conflicts