Interaction of a Modulated Electron Beam with a Plasma

The results of a theoretical and experimental investigation of the high-frequency interaction of an electron beam with a plasma are reported. An electron beam, modulated at a microwave frequency, passes through a uniform region of a mercury arc discharge after which it is demodulated. Exponentially growing wave amplification along the electron beam was experimentally observed for the first time at a microwave frequency equal to the plasma frequency. Approximate theories of the effects of 1) plasma-electron collision frequencies, 2) plasma-electron thermal velocities and 3) finite beam diameter, are given. In a second experiment the interaction between a modulated electron beam and a slow electrostatic wave on a plasma column has been studied. A strong interaction occurs when the velocity of the electron beam is approximately equal to the velocity of the wave and the interaction is essentially the same as that which occurs in traveling-wave amplifiers, except that here the plasma colum replaces the usual helical slow-wave circuit. The theory predicting rates of growth is presented and compared with the experimental results

Particle kinetic simulation of high altitude hypervelocity flight

In this grant period, the focus has been on the effects of thermo-chemical nonequilibrium in low-density gases, and on interactions between such gases and solid surfaces. Such conditions apply to hypersonic flows of re-entry vehicles, and to the expansion plumes of small rockets. Due to the nonequilibrium nature of these flows, a particle approach has been adopted. The method continues to undergo refinement and application to typical flows of interest. A number of studies have been performed for flows in thermo-chemical nonequilibrium. The effects of vibrational nonequilibrium on the rate of dissociation were studied for diatomic nitrogen. It was found that a new model reproduced the nonequilibrium behavior observed experimentally

Measurement and analysis of a small nozzle plume in vacuum

Pitot pressures and flow angles are measured in the plume of a nozzle flowing nitrogen and exhausting to a vacuum. Total pressures are measured with Pitot tubes sized for specific regions of the plume and flow angles measured with a conical probe. The measurement area for total pressure extends 480 mm (16 exit diameters) downstream of the nozzle exit plane and radially to 60 mm (1.9 exit diameters) off the plume axis. The measurement area for flow angle extends to 160 mm (5 exit diameters) downstream and radially to 60 mm. The measurements are compared to results from a numerical simulation of the flow that is based on kinetic theory and uses the direct-simulation Monte Carlo (DSMC) method. Comparisons of computed results from the DSMC method with measurements of flow angle display good agreement in the far-field of the plume and improve with increasing distance from the exit plane. Pitot pressures computed from the DSMC method are in reasonably good agreement with experimental results over the entire measurement area

Discussion quality diffuses in the digital public square

Studies of online social influence have demonstrated that friends have important effects on many types of behavior in a wide variety of settings. However, we know much less about how influence works among relative strangers in digital public squares, despite important conversations happening in such spaces. We present the results of a study on large public Facebook pages where we randomly used two different methods--most recent and social feedback--to order comments on posts. We find that the social feedback condition results in higher quality viewed comments and response comments. After measuring the average quality of comments written by users before the study, we find that social feedback has a positive effect on response quality for both low and high quality commenters. We draw on a theoretical framework of social norms to explain this empirical result. In order to examine the influence mechanism further, we measure the similarity between comments viewed and written during the study, finding that similarity increases for the highest quality contributors under the social feedback condition. This suggests that, in addition to norms, some individuals may respond with increased relevance to high-quality comments.Comment: 10 pages, 6 figures, 2 table

Stochastic properties of systems controlled by autocatalytic reactions II

We analyzed the stochastic behavior of systems controlled by autocatalytic reaction A+X -> X+X, X+X -> A+X, X -> B provided that the distribution of reacting particles in the system volume is uniform, i.e. the point model of reaction kinetics introduced in arXiv:cond-mat/0404402 can be applied. Assuming the number of substrate particles A to be kept constant by a suitable reservoir, we derived the forward Kolmogorov equation for the probability of finding n=0,1,... autocatalytic particles X in the system at a given time moment. We have shown that the stochastic model results in an equation for the mean value of autocatalytic particles X which differs strongly from the kinetic rate equation. It has been found that not only the law of the mass action is violated but also the bifurcation point is disappeared in the well-known diagram of X particle- vs. A particle-concentration. Therefore, speculations about the role of autocatalytic reactions in processes of the "natural selection" can be hardly supported.Comment: 17 pages, 6 figure

Quantum channels in nonlinear optical processes

Quantum electrodynamics furnishes a new type of representation for the characterisation of nonlinear optical processes. The treatment elicits the detailed role and interplay of specific quantum channels, information that is not afforded by other methods. Following an illustrative application to the case of Rayleigh scattering, the method is applied to second and third harmonic generation. Derivations are given of parameters that quantify the various quantum channels and their interferences; the results are illustrated graphically. With given examples, it is shown in some systems that optical nonlinearity owes its origin to an isolated channel, or a small group of channels. © 2009 World Scientific Publishing Company

Scoping a public health impact assessment of aquaculture with particular reference to tilapia in the UK

Background. The paper explores shaping public health impact assessment tools for tilapia, a novel emergent aquaculture sector in the UK. This Research Council’s UK Rural Economy and Land Use project embraces technical, public health, and marketing perspectives scoping tools to assess possible impacts of the activity. Globally, aquaculture produced over 65 million tonnes of food in 2008 and will grow significantly requiring apposite global public health impact assessment tools.<p></p> Methods. Quantitative and qualitative methods incorporated data from a tridisciplinary literature. Holistic tools scoped tilapia farming impact assessments. Laboratory-based tilapia production generated data on impacts in UK and Thailand along with 11 UK focus groups involving 90 consumers, 30 interviews and site visits, 9 visits to UK tilapia growers and 2 in The Netherlands.<p></p> Results. The feasibility, challenges, strengths, and weaknesses of creating a tilapia Public Health Impact Assessment are analysed. Occupational and environmental health benefits and risks attached to tilapia production were identified.<p></p> Conclusions. Scoping public health impacts of tilapia production is possible at different levels and forms for producers, retailers, consumers, civil society and governmental bodies that may contribute to complex and interrelated public health assessments of aquaculture projects. Our assessment framework constitutes an innovatory perspective in the field

High temperature turbine engine structure

A high temperature ceramic/metallic turbine engine includes a metallic housing which journals a rotor member of the turbine engine. A ceramic disk-like shroud portion of the engine is supported on the metallic housing portion and maintains a close running clearance with the rotor member. A ceramic spacer assembly maintains the close running clearance of the shroud portion and rotor member despite differential thermal movements between the shroud portion and metallic housing portion

Pressure measurements in a low-density nozzle plume for code verification

Measurements of Pitot pressure were made in the exit plane and plume of a low-density, nitrogen nozzle flow. Two numerical computer codes were used to analyze the flow, including one based on continuum theory using the explicit MacCormack method, and the other on kinetic theory using the method of direct-simulation Monte Carlo (DSMC). The continuum analysis was carried to the nozzle exit plane and the results were compared to the measurements. The DSMC analysis was extended into the plume of the nozzle flow and the results were compared with measurements at the exit plane and axial stations 12, 24 and 36 mm into the near-field plume. Two experimental apparatus were used that differed in design and gave slightly different profiles of pressure measurements. The DSMC method compared well with the measurements from each apparatus at all axial stations and provided a more accurate prediction of the flow than the continuum method, verifying the validity of DSMC for such calculations