Thermal expansion of composites using Moire interferometry

An experimental technique for precise measurement of the thermal response of fiber-reinforced composite materials uses moire interferometry with fringe multiplication which yield a sensitivity of 833 nm (32.8 mu in.) per fringe. Results from the technique are compared with those obtained from electrical resistance strain gages, and also those predicted from classical lamination theory. Temperature dependent coefficients of thermal expansion for composite materials subjected to thermal cycling in the temperature range of 297 K (75 F) to 422 K (300 F) were determined for four laminate configurations (0, 90, 0/ + or - 45/90 sub s and 0/90/ + or - 45 sub s) of T300/5208 graphite epoxy, and ranged from -0.107 mu epsilon K/1 (-0.059 mu epsilon deg F/-) for the 0 laminate to 32.18 mu epsilon K/1 (17.88 mu epsilon F/1) for the 90 laminate. Moisture was found to greatly influence the thermal response of a quasi-isotropic laminate, resulting in hysteresis and residual compressive strain as the moisture content was reduced. Comparisons between moire and strain gage measurements were inconclusive with both techniques giving consistent but systematically different results. Differences of as much as 29% were observed

Temporal Trends in Incidence, Sepsis-Related Mortality, and Hospital-Based Acute Care After Sepsis.

OBJECTIVES: A growing number of patients survive sepsis hospitalizations each year and are at high risk for readmission. However, little is known about temporal trends in hospital-based acute care (emergency department treat-and-release visits and hospital readmission) after sepsis. Our primary objective was to measure temporal trends in sepsis survivorship and hospital-based acute care use in sepsis survivors. In addition, because readmissions after pneumonia are subject to penalty under the national readmission reduction program, we examined whether readmission rates declined after sepsis hospitalizations related to pneumonia. DESIGN AND SETTING: Retrospective, observational cohort study conducted within an academic healthcare system from 2010 to 2015. PATIENTS: We used three validated, claims-based approaches to identify 17,256 sepsis or severe sepsis hospitalizations to examine trends in hospital-based acute care after sepsis. INTERVENTIONS: None. MEASUREMENTS AND MAIN RESULTS: From 2010 to 2015, sepsis as a proportion of medical and surgical admissions increased from 3.9% to 9.4%, whereas in-hospital mortality rate for sepsis hospitalizations declined from 24.1% to 14.8%. As a result, the proportion of medical and surgical discharges at-risk for hospital readmission after sepsis increased from 2.7% to 7.8%. Over 6 years, 30-day hospital readmission rates declined modestly, from 26.4% in 2010 to 23.1% in 2015, driven largely by a decline in readmission rates among survivors of nonsevere sepsis, and nonpneumonia sepsis specifically, as the readmission rate of severe sepsis survivors was stable. The modest decline in 30-day readmission rates was offset by an increase in emergency department treat-and-release visits, from 2.8% in 2010 to a peak of 5.4% in 2014. CONCLUSIONS: Owing to increasing incidence and declining mortality, the number of sepsis survivors at risk for hospital readmission rose significantly between 2010 and 2015. The 30-day hospital readmission rates for sepsis declined modestly but were offset by a rise in emergency department treat-and-release visits

Enumeration of distinct mechanically stable disk packings in small systems

We create mechanically stable (MS) packings of bidisperse disks using an algorithm in which we successively grow or shrink soft repulsive disks followed by energy minimization until the overlaps are vanishingly small. We focus on small systems because this enables us to enumerate nearly all distinct MS packings. We measure the probability to obtain a MS packing at packing fraction $\phi$ and find several notable results. First, the probability is highly nonuniform. When averaged over narrow packing fraction intervals, the most probable MS packing occurs at the highest $\phi$ and the probability decays exponentially with decreasing $\phi$. Even more striking, within each packing-fraction interval, the probability can vary by many orders of magnitude. By using two different packing-generation protocols, we show that these results are robust and the packing frequencies do not change qualitatively with different protocols.Comment: 4 pages, 3 figures, Conference Proceedings for X International Workshop on Disordered System

“I see my culture starting to disappear”: Anishinaabe perspectives on the socioecological impacts of climate change and future research needs

Climate change disproportionately affects Indigenous Peoples because of strong connections between environmental, cultural, and spiritual well-being. While much of the global discourse surrounding climate change is founded in Western science, the holistic, place-based knowledge of Indigenous Peoples offers a complementary way of understanding and mitigating climate change impacts. The goal of this research was to elevate Anishinaabe concerns, observations, and perspectives about climate change impacts and future research needs. We organized a workshop called “Connecting Guardians in a Changing World” where participants shared concerns about animal and plant life cycles, water cycles and water quality, and impacts to ways of life, including reduced capacity to perform cultural practices and erosion of their knowledge. Participants highlighted the challenge of prioritizing a single impact of climate change, emphasizing that impacts to the environment and ways of life are interconnected. Participants also expressed the need for research and policy that move beyond interdisciplinarity to include intercultural philosophy and research that better reflects Indigenous worldviews and incorporates Indigenous methodologies. Moving forward, meaningful partnerships and opportunities for knowledge sharing should be prioritized in climate change discourse to ensure solutions are generated together, with all of the tools and knowledge available

High-Energy Proton Testing of Sensitive Electronics for use on Modular Infrared Molecules and Ices Sensor (MIRMIS) Instrument

The Comet Interceptor (CI) mission is ESA\u27s first F class mission, selected in June 2019. This mission consists of three spacecraft: Spacecraft A (main spacecraft), Spacecraft B1 (supplied by the Japanese space agency JAXA), and Spacecraft B2. In this paper, we highlight the Modular Infrared Molecular and Ices Sensor (MIRMIS) instrument, which is integrated into the CI Spacecraft A\u27s scientific payload. In addition to hardware contributions from Finland (VTT Finland) and the UK (University of Oxford), the MIRMIS instrument team includes members from the University of Helsinki and NASA\u27s Goddard Space Flight Centre. MIRMIS covers the spectral range of 0.9 to ~25 μm. This paper presents the preliminary high-proton-energy radiation test results of MIRMIS’ near-infrared detector arraysensitive electronic components. Proton beam testing is performed to estimate Single Event Effects (SEE) on the PCB boards and SEE and Total Non-Ionizing Dose (TNID)/ Displacement Damage (DD) on the detectors. The tests were conducted at the Paul Scherrer Institute (PSI) Proton Irradiation Facility (PIF), Villigen, Switzerland. The levels for the tests were based on the mission requirements for the ESA Comet Interceptor mission: 3 years (at 1 AU- Segment 1) and 2 years (at 0.9 AU- Segment 2). The DD levels from the analysis were equivalent to 1e11 protons/cm2 with an energy of 50 MeV. The electronics are exposed to high-energy protons causing Single Event Effects (SEE) which may induce potentially destructive and non-destructive effects. The test items primarily included the InGaAs image sensors (SCD Cardinal640, standard and low noise), Xilinx Spartan-6 FPGAs (Field Programmable Gate Arrays), and other proximity electronics. The proton energies were varied from 50 to 200 MeV, at fluxes of 106 to 108 particles/cm2/s. No events were observed on the standard Cardinal640 sensor at target fluences between 1.00E+10 to 1.00E+11 particles/cm2. FPGAs did not show any susceptibility to TNID at fluences up to 1.00E+11 (particles/cm2)

Compositional Ground Truth of Diviner Lunar Radiometer Observations

The Moon affords us a unique opportunity to "ground truth" thermal infrared (i.e. 3 to 25 micron) observations of an airless body. The Moon is the most accessable member of the most abundant class of solar system bodies, which includes Mercury, astroids, and icy satellites. The Apollo samples returned from the Moon are the only extraterrestrial samples with known spatial context. And the Diviner Lunar Radiometer (Diviner) is the first instrument to globally map the spectral thermal emission of an airless body. Here we compare Diviner observations of Apollo sites to compositional and spectral measurements of Apollo lunar soil samples in simulated lunar environment (SLE)

Curie Temperature Enhancement and Cation Ordering in Titanomagnetites: Evidence From Magnetic Properties, XMCD, and Mössbauer Spectroscopy

Previous work has documented time‐ and temperature‐dependent variations in the Curie temperature (Tc) of natural titanomagnetites, independent of any changes in sample composition. To better understand the atomic‐scale processes responsible for these variations, we have generated a set of synthetic titanomagnetites with a range of Ti, Mg, and Al substitution; a subset of samples was additionally oxidized at low temperature (150 °C). Samples were annealed at temperatures between 325 and 400 °C for up to 1,000 hr and characterized in terms of magnetic properties; Fe valence and site occupancy were constrained by X‐ray magnetic circular dichroism (XMCD) and Mössbauer spectroscopy. Annealing results in large (up to ~100 °C) changes in Tc, but Mössbauer, XMCD, and saturation magnetization data all demonstrate that intersite reordering of Fe2+/Fe3+ does not play a role in the observed Tc changes. Rather, the data are consistent with vacancy‐enhanced nanoscale chemical clustering within the octahedral sublattice. This clustering may be a precursor to chemical unmixing at temperatures below the titanomagnetite binary solvus. Additionally, the data strongly support a model where cation vacancies are predominantly situated on octahedral sites, Mg substitution is largely accommodated on octahedral sites, and Al substitution is split between the two sites

Predicting the Impact of Vaccination on the Transmission Dynamics of Typhoid in South Asia: A Mathematical Modeling Study

Background: Modeling of the transmission dynamics of typhoid allows for an evaluation of the potential direct and indirect effects of vaccination; however, relevant typhoid models rooted in data have rarely been deployed. Methodology/Principal Findings We developed a parsimonious age-structured model describing the natural history and immunity to typhoid infection. The model was fit to data on culture-confirmed cases of typhoid fever presenting to Christian Medical College hospital in Vellore, India from 2000–2012. The model was then used to evaluate the potential impact of school-based vaccination strategies using live oral, Vi-polysaccharide, and Vi-conjugate vaccines. The model was able to reproduce the incidence and age distribution of typhoid cases in Vellore. The basic reproductive number (R0) of typhoid was estimated to be 2.8 in this setting. Vaccination was predicted to confer substantial indirect protection leading to a decrease in the incidence of typhoid in the short term, but (intuitively) typhoid incidence was predicted to rebound 5–15 years following a one-time campaign. Conclusions/Significance: We found that model predictions for the overall and indirect effects of vaccination depend strongly on the role of chronic carriers in transmission. Carrier transmissibility was tentatively estimated to be low, consistent with recent studies, but was identified as a pivotal area for future research. It is unlikely that typhoid can be eliminated from endemic settings through vaccination alone

Using Apollo Sites and Soils to Compositionally Ground Truth Diviner Lunar Radiometer Observations

Apollo landing sites and returned soils afford us a unique opportunity to "ground truth" Diviner Lunar Radiometer compositional observations, which are the first global, high resolution , thermal infrared measurements of an airless body. The Moon is the most accessible member of the most abundant class of solar system objects, which includes Mercury, asteroids, and icy satellites. And the Apollo samples returned from the Moon are the only extraterrestrial samples with known spatial context. Here we compare Diviner observations of Apollo landing sites and compositional and spectral laboratory measurements of returned Apollo soils. Diviner, onboard NASA's Lunar Reconnaissance Orbiter, has three spectral channels near 8 micron that were designed to characterize the mid-infrared emissivity maximum known as the Christiansen feature (CF), a well-studied indicator of silicate mineralogy. It has been observed that thermal infrared spectra measured in simulated lunar environment (SLE) are significantly altered from spectra measured under terrestrial or martian conditions, with enhanced CF contrast and shifted CF position relative to other spectral features. Therefore only thermal emission experiments conducted in SLE are directly comparable to Diviner data. With known compositions, Apollo landing sites and soils are important calibration points for the Diviner dataset, which includes all six Apollo sites at approximately 200 m spatial resolution. Differences in measured CFs caused by composition and space weathering are apparent in Diviner data. Analyses of Diviner observations and SLE measurements for a range of Apollo soils show good agreement, while comparisons to thermal reflectance measurements under ambient conditions do not agree well, which underscores the need for SLE measurements and validates our measurement technique. Diviner observations of Apollo landing sites are also correlated with geochemical measurements of Apollo soils from the Lunar Sample Compendium. In particular, the correlations between CF and FeO and AI203 are very strong, owing to the dependence on the feldspar-mafic ratio. Our analyses suggest that Diviner data may offer an independent measure of soil iron content from the existing optical and gamma-ray spectrometer datasets