Characterization of a front-end electronics for the monitoring and control of hadrontherapy beams

Abstract An integrated 64-channel device for the read-out of parallel plate pixel and strip ionization detectors has been developed by the INFN and University of Torino. The detectors will be used for the monitoring and control of hadrontherapy beams. The ASIC has been designed in CMOS 0.8 μm technology and it is based on a current-to-frequency converter followed by a synchronous counter. In this paper, we present a detailed characterization of the device done with 113 chips

'Ionizing radiation effects on a 64-channel charge measurement ASIC designed in CMOS 0.35 μm technology'

A 64-channel circuit Application Specific Integrated Circuit (ASIC) for charge measurement has been designed in CMOS 0.35mm technology and characterized with electrical tests. The ASIC has been conceived to be used as a front-end for dosimetry and beam monitoring detector read-out. For that application, the circuitry is housed at a few centimeters from the irradiated area of the detectors and therefore radiation damages can affect the chip performances. The ASIC has been tested on an X-ray beam. In this paper, the results of the test and an estimate of the expected lifetime of the ASIC in a standard radio-therapeutical treatment environment are presented. An increase of the background current of 2 fA/Gy has been observed at low doses, whilst the gain changes by less than 3% when irradiated up to 15 kGy. Furthermore it has been assessed that, when used as an on-line beam monitor and the annealing effect has been taken into account, the background current increase is � 440 fA/year

Dosimetric characterization of a large area pixel-segmented ionization chamber.

A pixel-segmented ionization chamber has been designed and built by Torino University and INFN. The detector features a 24 x 24 cm2 active area divided in 1024 independent cylindrical ionization chambers and can be read out in 500 micros without introducing dead time; the digital charge quantum can be adjusted between 100 fC and 800 fC. The sensitive volume of each single ionization chamber is 0.07 cm3. The purpose of the detector is to ease the two-dimensional (2D) verifications of fields with complex shapes and large gradients. The detector was characterized in a PMMA phantom using 60Co and 6 MV x-ray photon beams. It has shown good signal linearity with respect to dose and dose rate to water. The average sensitivity of a single ionization chamber was 2.1 nC/Gy, constant within 0.5% over one month of daily measurements. Charge collection efficiency was 0.985 at the operating polarization voltage of 400 V and 3.5 Gy/min dose rate. Tissue maximum ratio and output factor have been compared with a Farmer ionization chamber and were found in good agreement. The dose profiles have been compared with the ones obtained with an ionization chamber in water phantom for the field sizes supplied by a 3D-Line dynamic multileaf collimator. These results show that this detector can be used for 2D dosimetry of x-ray photon beams, supplying a good spatial resolution and sensibly reducing the time spent in dosimetric verification of complex radiation fields

Online measurement of fluence and position for protontherapy beams

Tumour therapy with proton beams has been used for several decades in many centres with very good results in terms of local control and overall survival. Typical pathologies treated with this technique are located in head and neck, eye, prostate and in general at big depths or close to critical organs. The Experimental Physics Department of the University of Turin and the local Section of INFN, in collaboration with INFN Laboratori Nazionali del Sud Catania and Centre de Protontherapie de Orsay Paris, have developed detector systems that allow the measurement of beam position and fluence, obtained in real time during beam delivery. The centre in Catania (CATANA: Centro di AdroTerapia ed Applicazioni Nucleari Avanzate) has been treating patients with eye pathologies since spring 2002 using a superconducting cyclotron accelerating protons up to 62 MeV. This kind of treatments need high-resolution monitor systems and for this reason we have developed a 256-strip segmented ionisation chamber, each strip being 400 μm wide, with a total sensitive area 13 × 13 cm2. The Centre de Protontherapie de Orsay (CPO) has been operational since 1991 and features a synchrocyclotron used for eye and head and neck tumours with proton beams up to 200 MeV. The monitor system has to work on a large surface and for this purpose we have designed a pixel-segmented ionisation chamber, each pixel being 5×5 mm2, for a total active area of 16 × 16 cm2. The results obtained with two prototypes of the pixel and strip chambers demonstrate that the detectors allow the measurement of fluence and centre of gravity as requested by clinical specifications