19 research outputs found
FCC study: parameters and optics for hadron and lepton colliders
AbstractA new international study has just been launched to design a hadron collider with a centre-of-mass energy of the order of 100 TeV in a new 80–100 km tunnel as a long-term goal. The design study includes a 90–350 GeV lepton collider, seen as a potential intermediate step, and an ep option. This paper reports on the overall parameters and preliminary optics designs with special emphasis on the Interaction Regions and the constraints arising for having to host both the lepton and the hadron colliders. Preliminary hardware specifications, as magnetic field, gradient, lengths and aperture are also presented
Measurement of and between 3.12 and 3.72 GeV at the KEDR detector
Using the KEDR detector at the VEPP-4M collider, we have measured
the values of and at seven points of the center-of-mass
energy between 3.12 and 3.72 GeV. The total achieved accuracy is about or
better than at most of energy points with a systematic uncertainty of
about . At the moment it is the most accurate measurement of in
this energy range
Measurement of \Gamma_{ee}(J/\psi)*Br(J/\psi->e^+e^-) and \Gamma_{ee}(J/\psi)*Br(J/\psi->\mu^+\mu^-)
The products of the electron width of the J/\psi meson and the branching
fraction of its decays to the lepton pairs were measured using data from the
KEDR experiment at the VEPP-4M electron-positron collider. The results are
\Gamma_{ee}(J/\psi)*Br(J/\psi->e^+e^-)=(0.3323\pm0.0064\pm0.0048) keV,
\Gamma_{ee}(J/\psi)*Br(J/\psi->\mu^+\mu^-)=(0.3318\pm0.0052\pm0.0063) keV.
Their combinations
\Gamma_{ee}\times(\Gamma_{ee}+\Gamma_{\mu\mu})/\Gamma=(0.6641\pm0.0082\pm0.0100)
keV,
\Gamma_{ee}/\Gamma_{\mu\mu}=1.002\pm0.021\pm0.013 can be used to improve
theaccuracy of the leptonic and full widths and test leptonic universality.
Assuming e\mu universality and using the world average value of the lepton
branching fraction, we also determine the leptonic \Gamma_{ll}=5.59\pm0.12 keV
and total \Gamma=94.1\pm2.7 keV widths of the J/\psi meson.Comment: 7 pages, 6 figure
Search for narrow resonances in e+ e- annihilation between 1.85 and 3.1 GeV with the KEDR Detector
We report results of a search for narrow resonances in e+ e- annihilation at
center-of-mass energies between 1.85 and 3.1 GeV performed with the KEDR
detector at the VEPP-4M e+ e- collider. The upper limit on the leptonic width
of a narrow resonance Gamma(R -> ee) Br(R -> hadr) < 120 eV has been obtained
(at 90 % C.L.)
Measurement of main parameters of the \psi(2S) resonance
A high-precision determination of the main parameters of the \psi(2S)
resonance has been performed with the KEDR detector at the VEPP-4M e^{+}e^{-}
collider in three scans of the \psi(2S) -- \psi(3770) energy range. Fitting the
energy dependence of the multihadron cross section in the vicinity of the
\psi(2S) we obtained the mass value
M = 3686.114 +- 0.007 +- 0.011 ^{+0.002}_{-0.012} MeV and the product of the
electron partial width by the branching fraction into hadrons \Gamma_{ee}*B_{h}
= 2.233 +- 0.015 +- 0.037 +- 0.020 keV.
The third error quoted is an estimate of the model dependence of the result
due to assumptions on the interference effects in the cross section of the
single-photon e^{+}e^{-} annihilation to hadrons explicitly considered in this
work.
Implicitly, the same assumptions were employed to obtain the charmonium
leptonic width and the absolute branching fractions in many experiments.
Using the result presented and the world average values of the electron and
hadron branching fractions, one obtains the electron partial width and the
total width of the \psi(2S):
\Gamma_{ee} =2.282 +- 0.015 +- 0.038 +- 0.021 keV,
\Gamma = 296 +- 2 +- 8 +- 3 keV.
These results are consistent with and more than two times more precise than
any of the previous experiments
New precise determination of the \tau lepton mass at KEDR detector
The status of the experiment on the precise lepton mass measurement
running at the VEPP-4M collider with the KEDR detector is reported. The mass
value is evaluated from the cross section behaviour around the
production threshold. The preliminary result based on 6.7 pb of data is
MeV. Using 0.8 pb of data
collected at the peak the preliminary result is also obtained:
eV.Comment: 6 pages, 8 figures; The 9th International Workshop on Tau-Lepton
Physics, Tau0
SuperB: next-generation e+e- B-factory collider
International audienceThe SuperB international team continues to optimize the design of an electron-positron collider, which will allow the enhanced study of the origins of flavor physics. The project combines the best features of a linear collider (high single- collision luminosity) and a storage-ring collider (high rep- etition rate), bringing together all accelerator physics as- pects to make a very high luminosity of 10^36 cm^−2 sec^−1 . This asymmetric-energy collider with a polarized electron beam will produce hundreds of millions of B-mesons at the Υ(4S) resonance. The present design is based on ex- tremely low emittance beams colliding at a large Piwin- ski angle to allow very low β⋆y without the need for ultra short bunches. Use of crab-waist sextupoles will enhance the luminosity, suppressing dangerous resonances and al- lowing for a higher beam-beam parameter. The project has flexible beam parameters, improved dynamic aperture, and spin-rotators in the Low Energy Ring for longitudinal po- larization of the electron beam at the Interaction Point. Op- timized for best colliding-beam performance, the facility may also provide high-brightness photon beams for syn- chrotron radiation applications
New precision measurement of the - and -meson masses
A new high precision measurement of the - and -meson masses
has been performed at the VEPP-4M collider using the KEDR detector. The
resonant depolarization method has been employed for the absolute calibration
of the beam energy. The following mass values have been obtained:
MeV,
MeV.
The relative measurement accuracy has reached for and
for , approximately 3 times better than in the previous
precise experiments.Comment: 12 pages, 4 tables, 10 figure
Recommended from our members
Status of the Super-B factory Design
The SuperB international team continues to optimize the design of an electron-positron collider, which will allow the enhanced study of the origins of flavor physics. The project combines the best features of a linear collider (high single-collision luminosity) and a storage-ring collider (high repetition rate), bringing together all accelerator physics aspects to make a very high luminosity of 10{sup 36} cm{sup -2} sec{sup -1}. This asymmetric-energy collider with a polarized electron beam will produce hundreds of millions of B-mesons at the Y(4S) resonance. The present design is based on extremely low emittance beams colliding at a large Piwinski angle to allow very low {beta}{sub y} without the need for ultra short bunches. Use of crab-waist sextupoles will enhance the luminosity, suppressing dangerous resonances and allowing for a higher beam-beam parameter. The project has flexible beam parameters, improved dynamic aperture, and spin-rotators in the Low Energy Ring for longitudinal polarization of the electron beam at the Interaction Point. Optimized for best colliding-beam performance, the facility may also provide high-brightness photon beams for synchrotron radiation applications