249 research outputs found
Recommended from our members
Estimating the contribution of photochemical particle formation to ultrafine particle number averages in an urban atmosphere
Ultrafine particles (UFPs, diameter < 100 nm) have gained major attention in the environmental health discussion due to a number of suspected health effects. Observations of UFPs in urban air reveal the presence of several, time-dependent particle sources. In order to attribute measured UFP number concentrations to different source type contributions, we analyzed observations collected at a triplet of observation sites (roadside, urban background, rural) in the city of Leipzig, Germany. Photochemical new particle formation (NPF) events can be the overwhelming source of UFP particles on particular days, and were identified on the basis of characteristic patterns in the particle number size distribution data. A subsequent segmentation of the diurnal cycles of UFP concentration yielded a quantitative contribution of NPF events to daily, monthly, and annual mean values. At roadside, we obtained source contributions to the annual mean UFP number concentration (diameter range 5–100 nm) for photochemical NPF events (7%), local traffic (52%), diffuse urban sources (20%), and regional background (21%). The relative contribution of NPF events rises when moving away from roadside to the urban background and rural sites (14 and 30%, respectively). Their contribution also increases when considering only fresh UFPs (5–20 nm) (21% at the urban background site), and conversely decreases when considering UFPs at bigger sizes (20–100 nm) (8%). A seasonal analysis showed that NPF events have their greatest importance on UFP number concentration in the months May–August, accounting for roughly half of the fresh UFPs (5–20 nm) at the urban background location. The simplistic source apportionment presented here might serve to better characterize exposure to ambient UFPs in future epidemiological studies
Non-volatile residuals of newly formed atmospheric particles in the boreal forest
The volatility of sub-micrometer atmospheric aerosol particles was studied in a rural background environment in Finland using a combination of a heating tube and a scanning mobility particle sizer. The analysis focused on nanoparticles formed through nucleation which were subsequently observed during their growth in the diameter range between 5 and 60 nm. During the 6 days of new particle formation shown in detail, the concentrations of newly formed particles increased up to 10 000 cm−3. The number of nucleation mode particles measured after volatilization in the heating tube at 280°C was up to 90% of the total number under ambient conditions. Taking into account the absolute accuracy of the size distribution measurements, all ambient particles found in the rural atmosphere could have a non-volatile core after volatilization at 280°C. As the regional new particle formation events developed over time as a result of further vapor condensation, the newly formed particles grew at an average growth rate of 2.4±0.3 nm h−1. Importantly, the non-volatile cores of nucleation mode particles were also observed to grow over time, however, at a lower average growth rate of 0.6±0.3 nm h−1. One implication of the volatility analysis is that the newly formed particles, which have reached ambient diameters of 15 nm, are unlikely to consist of sulfuric acid, ammonium sulfate, and water alone. A relatively constant ratio between the growth rate of the ambient particles as well as their non-volatile cores indicates that non-volatile matter is formed only gradually in the growing particles. The non-volatile fraction of the particles showed some correlation with the ambient temperature. The composition and formation mechanism of this non-volatile material in nucleation mode particles are, to date, not known
Recommended from our members
Correlation between traffic density and particle size distribution in a street canyon and the dependence on wind direction
Combustion of fossil fuel in gasoline and diesel powered vehicles is a major source of aerosol particles in a city. In a street canyon, the number concentration of particles smaller than 300 nm in diameter, which can be inhaled and cause serious health effects, is dominated by particles originating from this source. In this study we measured both, particle number size distribution and traffic density continuously in a characteristic street canyon in Germany for a time period of 6 months. The street canyon with multistory buildings and 4 traffic lanes is very typical for larger cities. Thus, the measurements also are representative for many other street canyons in Europe. In contrast to previous studies, we measured and analyzed the particle number size distribution with high size resolution using a Twin Differential Mobility Analyzer (TDMPS). The measured size range was from 3 to 800 nm, separated into 40 size channels. Correlation coefficients between particle number concentration for integrated size ranges and traffic counts of 0.5 were determined. Correlations were also calculated for each of the 40 size channels of the DMPS system, respectively. We found a maximum of the correlation coefficients for nucleation mode particles in the size range between 10 and 20 nm in diameter. Furthermore, correlations between traffic and particles in dependence of meteorological data were calculated. Relevant parameters were identified by a multiple regression method. In our experiment only wind parameters have influenced the particle number concentration significantly. High correlation coefficients (up to 0.8) could be observed in the lee side of the street canyon for particles in the range between 10 and 100 nm in diameter. These values are significantly higher than correlation coefficients for other wind directions and other particle sizes. A minimum was found in the luff side of the street. These findings are in good agreement with theory of fluid dynamics in street canyons
Recommended from our members
Analysis of exceedances in the daily PM10 mass concentration (50 μg m−3) at a roadside station in Leipzig, Germany
Five years of PM10 and PM2.5 ambient air measurements at a roadside, an urban, and a regional background site in Leipzig (Germany) were analyzed for violations of the legal PM10 limit value (EC, 1999). The annual mean PM10 concentrations at the three sites were well below the legal threshold of 40 μg m−3 (32.6, 22.0 and 21.7 μg m−3, respectively). At roadside, the daily maximum value of 50 μg m−3 was exceeded on 232 days (13% of all days) in 2005–2009, which led to a violation of the EC directive in three out of five years. We analysed the meteorological factors and local source contributions that eventually led to the exceedances of the daily limit value. As noted in other urban environments before, most exceedance days were observed in the cold season. Exceedance days were most probable under synoptic situations characterised by stagnant winds, low temperatures and strong temperature inversions in winter time. However, these extreme situations accounted for only less than half of the exeedance days. We also noticed a significant number of exceedance days that occurred in the cold season under south-westerly winds, and in the warm season in the presence of easterly winds. Our analysis suggests that local as well as regional sources of PM are equally responsible for exceedances days at the roadside site. The conclusion is that a combined effort of local, national and international reduction measures appears most likely to avoid systematic exceedances of the daily limit value in the future
Correlation between traffic density and particle size distribution in a street canyon and the dependence on wind direction
International audienceCombustion of fossil fuel in gasoline and diesel powered vehicles is a major source of aerosol particles in a city. In a street canyon, the number concentration of particles smaller than 300 nm in diameter, which can be inhaled and cause serious health effects, is dominated by particles originating from this source. In this study we measured both, particle number size distribution and traffic density continuously in a characteristic street canyon in Germany for a time period of 6 months. The street canyon with multistory buildings and 4 traffic lanes is very typical for larger cities. Thus, the measurements also are representative for many other street canyons in Europe. In contrast to previous studies, we measured and analyzed the particle number size distribution with high size resolution using a Twin Differential Mobility Analyzer (TDMPS). The measured size range was from 3 to 800 nm, separated into 40 size channels. Correlation coefficients between particle number concentration for integrated size ranges and traffic counts of 0.5 were determined. Correlations were also calculated for each of the 40 size channels of the DMPS system, respectively. We found a maximum of the correlation coefficients for nucleation mode particles in the size range between 10 and 20 nm in diameter. Furthermore, correlations between traffic and particles in dependence of meteorological data were calculated. Relevant parameters were identified by a multiple regression method. In our experiment only wind parameters have influenced the particle number concentration significantly. High correlation coefficients (up to 0.8) could be observed in the lee side of the street canyon for particles in the range between 10 and 100 nm in diameter. These values are significantly higher than correlation coefficients for other wind directions and other particle sizes. A minimum was found in the luff side of the street. These findings are in good agreement with theory of fluid dynamics in street canyons
A fast and easy-to-implement inversion algorithm for mobility particle size spectrometers considering particle number size distribution information outside of the detection range
Multiple-charge inversion is an essential procedure to convert the raw mobility distributions recorded by mobility particle size spectrometers, such as the DMPS or SMPS (differential or scanning mobility particle sizers), into true particle number size distributions. In this work, we present a fast and easy-to-implement multiple-charge inversion algorithm with sufficient precision for atmospheric conditions, but extended functionality. The algorithm can incorporate size distribution information from sensors that measure beyond the upper sizing limit of the mobility spectrometer, such as an aerodynamic particle sizer (APS) or an optical particle counter (OPC). This feature can considerably improve the multiple-charge inversion result in the upper size range of the mobility spectrometer, for example, when substantial numbers of coarse particles are present. The program also yields a continuous size distribution from both sensors as an output. The algorithm is able to calculate the propagation of measurement errors, such as those based on counting statistics, into on the final particle number size distribution. As an additional aspect, the algorithm can perform all inversion steps under the assumption of non-spherical particle shape, including constant or size-dependent shape factors
Recommended from our members
Size-segregated chemical, gravimetric and number distribution-derived mass closure of the aerosol in Sagres, Portugal during ACE-2
During the ACE-2 field campaign in the summer of 1997 an intensive, ground-based physical
and chemical characterisation of the clean marine and continentally polluted aerosol was performed
at Sagres, Portugal. Number size distributions of the dry aerosol in the size range
3–10 000 nm were continuously measured using DMPS and APS systems. Impactor samples
were regularly taken at 60% relative humidity (RH) to obtain mass size distributions by
weighing the impactor foils, and to derive a chemical mass balance by ion and carbon analysis.
Hygroscopic growth factors of the metastable aerosol at 60% RH were determined to estimate
the number size distribution at a relative humidity of 60%. A size segregated 3-way mass closure
study was performed in this investigation for the first time. Mass size distributions at 60% RH
derived from number size distribution measurements and impactors samples (weighing and
chemical analysis) are compared. A good agreement was found for the comparison of total
gravimetrically-determined mass with both number distribution-derived (slope=1.23/1.09;
R2>0.97; depending on the parameters humidity growth and density) and chemical mass
concentration (slope=1.02; R2=0.79) for particles smaller than 3 mm in diameter. Except for
the smallest impactor size range relatively good correlations (slope=0.86–1.42) with small
deviations (R2=0.76–0.98) for the different size fractions were found. Since uncertainties in
each of the 3 methods are about 20% the observed differences in the size-segregated mass
fractions can be explained by the measurement uncertainties. However, the number distributionderived
mass is mostly higher than the chemically and gravimetrically determined mass, which
can be explained by sampling losses of the impactor, but as well with measurement uncertainties
as, e.g., the sizing of the DMPS/APS
A concept of an automated function control for ambient aerosol measurements using mobility particle size spectrometers
An automated function control unit was developed to regularly check the
ambient particle number concentration derived from a mobility particle size
spectrometer as well as its zero-point behaviour. The function control allows
unattended quality assurance experiments at remote air quality monitoring or
research stations under field conditions. The automated function control also
has the advantage of being able to get a faster system stability response
than the recommended on-site comparisons with reference instruments. The
method is based on a comparison of the total particle number concentration
measured by a mobility particle size spectrometer and a condensation particle
counter while removing diffusive particles smaller than 20 nm in diameter.
In practice, the small particles are removed by a set of diffusion screens,
as traditionally used in a diffusion battery. Another feature of the
automated function control is to check the zero-point behaviour of the
ambient aerosol passing through a high-efficiency particulate air (HEPA)
filter.
<br><br>
The performance of the function control is illustrated with the aid of a
1-year data set recorded at Annaberg-Buchholz, a station in the Saxon air
quality monitoring network. During the period of concern, the total particle
number concentration derived from the mobility particle size spectrometer
slightly overestimated the particle number concentration recorded by the
condensation particle counter by 2 % (grand average). Based on our first
year of experience with the function control, we developed tolerance criteria
that allow a performance evaluation of a tested mobility particle size
spectrometer with respect to the total particle number concentration. We
conclude that the automated function control enhances the quality and
reliability of unattended long-term particle number size distribution
measurements. This will have beneficial effects for intercomparison studies
involving different measurement sites, and help provide a higher data
accuracy for cohort health and climate research studies
Recommended from our members
Infrequent new particle formation over the remote boreal forest of Siberia
Aerosol particle number size distributions (PNSD) were investigated to verify, if extremely low-volatility organic vapors (ELVOC) from natural sources alone could induce new particle formation and growth events over the remote boreal forest region of Siberia, hundreds of kilometers away from significant anthropogenic sources. We re-evaluated observations determined at a height of 300 m of the remote observatory ZOTTO (Zotino Tall Tower Observatory, http://www.zottoproject.org). We found that new particle formation events occurred only on 11 days in a 3-year period, suggesting that homogeneous nucleation with a subsequent condensational growth could not be the major process, maintaining the particle number concentration in the planetary boundary layer of the remote boreal forest area of Siberia. © 2018 Elsevier Lt
- …