2,659 research outputs found
Compensating vacancy defects in Sn- and Mg-doped In 2O3
MBE-grown Sn- and Mg-doped epitaxial In2O3 thin-film samples with varying doping concentrations have been measured using positron Doppler spectroscopy and compared to a bulk crystal reference. Samples were subjected to oxygen or vacuum annealing and the effect on vacancy type defects was studied. Results indicate that after oxygen annealing the samples are dominated by cation vacancies, the concentration of which changes with the amount of doping. In highly Sn-doped In2O3, however, these vacancies are not the main compensating acceptor. Vacuum annealing increases the size of vacancies in all samples, possibly by clustering them with oxygen vacancies.Peer reviewe
Phase-selective growth of - vs -GaO and (InGa)O by In-mediated metal exchange catalysis in plasma-assisted molecular beam epitaxy
Its piezo- and potentially ferroelectric properties make the metastable kappa
polymorph of GaO an interesting material for multiple applications,
while In-incorporation into any polymorphs of GaO allows to lower their
bandgap. In this work, we provide a guideline to achieve single phase
-, -GaO as well as their (InGa)O
alloys up to x = 0.14 and x = 0.17 respectively, using In-mediated metal
exchange catalysis in plasma assisted molecular beam epitaxy (MEXCAT-MBE). The
polymorph transition from to is also addressed, highlighting
the fundamental role played by the thermal stability of the
-GaO. Additionally, we also demonstrate the possibility to grow
(01) -GaO on top of -AlO (0001) at
temperatures at least 100 {\deg}C above those achievable with conventional
non-catalyzed MBE, opening the road for increased crystal quality in
heteroepitaxy. The role of the substrate, as well as strain and structural
defects in the growth of -GaO is also investigated by growing
simultaneously on three different materials: (i) -AlO (0001),
(ii) 20 nm of (01) -GaO on -AlO (0001)
and (iii) (01) -GaO single crystal.Comment: Main text: 7 pages, 4 figures; Supplementary: 6 pages, 9 figure
Conducting Polymers and Corrosion III. A Scanning Vibrating Electrode Study of Poly(3-octyl pyrrole) on Steel and Aluminum
Electroactive conducting polymers (ECPs) continue to be of considerable interest as components of corrosion-resistant coating systems. ECPs, in addition to being conductive, are redox active materials, typically with potentials that are positive of iron and aluminum. Thus, as with chromate, interesting and potentially beneficial interactions of ECPs with active metal alloys such as steel and aluminum are anticipated. In this work, the scanning vibrating electrode technique (SVET), also known as the current density probe, was used to probe such interactions between a poly(3-octyl pyrrole) coating (POP) and cold-rolled steel and aluminum (Al 2024-T3) substrates. The POP coatings were scribed to simulate a defect through the coating to the metal substrate surface. The SVET was used to map the current flowing in and around the defect while the sample was immersed in either 3% NaCl (steel) or in dilute Harrison solution (aluminum), an aqueous solution consisting of 0.35% (NH4)2SO4, 0.05% NaCl. Although there were significant differences in the behavior of the POP-coated steel and POP-coated aluminum substrates, both exhibited a significant delay before the onset of any observable current compared to uncoated or epoxy-coated samples. Current density maps for the steel clearly indicate that the reduction reaction occurred on the conducting polymer surface, with oxidation confined to the defect. Current density maps for the aluminum alloy never displayed significant oxidation at the defect. Rather, reduction (after a significant delay) occurred at the defect as well as across the polymer surface, with concomitant localized undercoating oxidation of the aluminum substrate
Electrical conductivity and gas-sensing properties of Mg-doped and undoped single-crystalline In2O3 thin films: Bulk vs. surface
This study aims to provide a better fundamental understanding of the gas-sensing mechanism of In2O3-based conductometric gas sensors. In contrast to typically used polycrystalline films, we study single crystalline In2O3 thin films grown by molecular beam epitaxy (MBE) as a model system with reduced complexity. Electrical conductance of these films essentially consists of two parallel contributions: the bulk of the film and the surface electron accumulation layer (SEAL). Both these contributions are varied to understand their effect on the sensor response. Conductance changes induced by UV illumination in air, which forces desorption of oxygen adatoms on the surface, give a measure of the sensor response and show that the sensor effect is only due to the SEAL contribution to overall conductance. Therefore, a strong sensitivity increase can be expected by reducing or eliminating the bulk conductivity in single crystalline films or the intra-grain conductivity in polycrystalline films. Gas-response measurements in ozone atmosphere test this approach for the real application
Recommended from our members
Electrical conductivity and gas-sensing properties of Mg-doped and undoped single-crystalline In2O3 thin films: Bulk vs. surface
This study aims to provide a better fundamental understanding of the gas-sensing mechanism of In2O3-based conductometric gas sensors. In contrast to typically used polycrystalline films, we study single crystalline In2O3 thin films grown by molecular beam epitaxy (MBE) as a model system with reduced complexity. Electrical conductance of these films essentially consists of two parallel contributions: the bulk of the film and the surface electron accumulation layer (SEAL). Both these contributions are varied to understand their effect on the sensor response. Conductance changes induced by UV illumination in air, which forces desorption of oxygen adatoms on the surface, give a measure of the sensor response and show that the sensor effect is only due to the SEAL contribution to overall conductance. Therefore, a strong sensitivity increase can be expected by reducing or eliminating the bulk conductivity in single crystalline films or the intra-grain conductivity in polycrystalline films. Gas-response measurements in ozone atmosphere test this approach for the real application
Meal-derived glucagon responses are related to lower hepatic phosphate concentrations in obesity and type 2 diabetes
Aim. - Type 2 diabetes (T2D) alters glucagon, glucagon-like peptide (GLP)-1, glucose-dependent insulinotropic polypeptide (GIP) and hepatic energy metabolism, yet the possible relationships remain unclear.Methods. - In this observational study, lean insulin-sensitive control subjects (BMI: 23.2 +/- 1.5 kg/m(2)), age-matched insulin-resistant obese subjects (BMI: 34.3 +/- 1.7 kg/m(2)) and similarly obese elderly T2D patients (BMI: 32.0 +/- 2.4 kg/m(2)) underwent mixed-meal tolerance tests (MMTTs), and assessment of hepatic gamma ATP, inorganic phosphate (P-i) and lipids using P-31/H-1 magnetic resonance spectroscopy. Meal-induced secretion of glucagon and incretins was calculated from incremental areas under the concentration-time curves (iAUCs). Peripheral and adipose tissue insulin sensitivity were assessed from time courses of circulating glucose, insulin and free fatty acids.Results. - MMTT-derived peripheral insulin sensitivity was lowest in T2D patients (P <0.001), while glucagon concentrations were comparable across all three groups. At 260 min, GLP-1 was lower in T2D patients than in controls, whereas GIP was lowest in obese individuals. Fasting glucagon concentrations correlated positively with fasting (r = 0.60) and postprandial hepatocellular lipid levels (160 min: r= 0.51, 240 min: r = 0.59), and negatively with adipose tissue insulin sensitivity (r = -0.73). Higher meal-induced glucagon release (iAUC(0)(-260) (min)) correlated with lower fasting (r = -0.62) and postprandial P(i )levels (160 min: r = -0.43, 240 min: r = -0.42; all P <0.05). Higher meal-induced release of GIP (iAUC(0-260) (min)) correlated positively with fasting (r = 0.54) and postprandial serum triglyceride concentrations (iAUC(0-260 min, )r = 0.54; all P <0.01).Conclusion. - Correlations between fasting glucagon and hepatic lipids and between meal-induced glucagon and hepatic P-i suggest a role for glucagon in hepatic energy metabolism. (C) 2018 Elsevier Masson SAS. All rights reserved.</p
Evaluation of the possibility of using diatomite natural mineral as a composite agent in acrylic coating
WOS: 000427736200014In the present study the possibility of the commercially available acryl and diatomite earth (DE) mineral as a composite coating for corrosion protection of Mg alloys has been evaluated. The acrylic coating is used as a top coating in a wide field of applications like automotive, aerospace, medicine and electronics where it shows beneficial properties. Diatomite-dispersed acrylic paint was applied over the substrate by conventional spray technique with an air pressure of 3 kg cm(-2). Firstly the acryl was mixed with hardener and then the DE was added to the mixture. Four types of coating with 0, 2, 4, 8 g/L DE have been prepared. The results show that adding up to 4 g/L of the DE improved the corrosion resistance and produced a coating with acceptable surface roughness
- …