Sodium Lignosulfonate As A Renewable Stabilizing Agent For Aqueous Alumina Suspensions.

The macromolecule sodium lignosulfonate (SL) has been investigated as dispersing agent for aqueous alumina colloids as a renewable alternative to usual petrochemical stabilizing agents. Optimization of the SL concentration necessary to stabilize the alumina suspension at different pH values was determined by viscometer. The results showed that addition of 250ppm of the total suspension mass led to about 70% viscosity reduction of the suspension, whereas zeta potential analysis revealed negative values for the SL suspensions throughout the pH range investigated, suggesting that the alumina particles were covered by negatively charged SL molecules. Particle size investigation informed that the average particle diameter of the SL suspensions was smaller compared to that of the pristine particles. Sedimentation time for the SL suspensions was dramatically longer than that for the pristine one. The reported data strongly corroborated that SL is a suitable renewable dispersing agent for aqueous alumina colloids.82927-93

Derivatives of Biomacromolecules as Stabilizers of Aqueous Alumina Suspensions

The stabilization of alumina suspensions is key to the development of high-performance materials for the ceramic industry, which has motivated extensive research into synthetic polymers used as stabilizers. In this study, mimosa tannin extract and a chitosan derivative, that is, macromolecules obtained from renewable resources, are shown to be promising to replace synthetic polymers, yielding less viscous suspensions with smaller particles and greater fluidity, that is, more homogeneous suspensions that may lead to better-quality products. The functional groups of tannin present in mimosa extract and N,N,N-trimethylchitosan (TMC) are capable of establishing interactions with the alumina surface, thus leading to repulsion between the particles mainly due to steric and electrosteric mechanisms, respectively. The stabilization of the suspension induced by either TMC or mimosa tannin was confirmed by a considerable decrease in viscosity and average particle size, in comparison with alumina suspensions without stabilizing agents. The viscosity/average particle size decreased by 49/84% and 52/87% for suspensions with TMC and mimosa tannin, respectively. In addition, the increase in the absolute zeta potential upon addition of either TMC or mimosa tannin extract, especially at high pHs, points to an increased stability of the suspension. The feasibility of using derivatives of macromolecules from renewable sources to stabilize aqueous alumina suspensions was therefore demonstrated. (C) 2010 Wiley Periodicals, Inc. J Appl Polym Sci 117: 58-66, 2010Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)CNPq (National Council for Scientific and Technological Development, Brazil)Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)FAPESP (State of Sao Paulo Research Foundation, Brazil)Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)CAPES (Coordination for the Improvement of Higher Education Personnel

Highly corrosion resistant siloxane-polymethyl methacrylate hybrid coatings

Siloxane-polymethyl methacrylate hybrid films were deposited on carbon steel substrates by dip-coating from a sol prepared by acid-catalyzed hydrolytic co-polycondensation of tetraethoxysilane (TEOS) and 3-methacryloxy propyl-trimethoxysilane (MPTS), followed by radical polymerization of methyl methacrylate (MMA). Structural properties of the hybrids were studied using Si-29 and C-13 nuclear magnetic resonance (NMR), X-ray photoelectron spectroscopy (XPS) and thermogravimetric analysis (TGA), as a function of the MMA/MPTS ratio, which ranged between 2 and 10. The efficiency of corrosion protection of hybrid-coated carbon steel was investigated by XPS, potentiodynamic polarization curves and electrochemical impedance spectroscopy after immersion of the material in acidic and neutral saline aqueous solution. The NMR and TGA results indicate a high degree of polycondensation (84%) and elevated thermal stability of 410 A degrees C for the hybrid film with a MMA/MPTS ratio of 8, exhibiting also and excellent adhesion to the substrate. The XPS analysis confirmed the variation of the MMA phase in the hybrid, and showed that no corrosion-induced changes had occurred after 18 days immersion of the coated steel in 3.5% NaCl solution. Potentiodynamic polarization curves have shown that the hybrid coating prepared using a TEOS/MPTS ratio of 8 yielded the best anti-corrosion performance. It acts as a very efficient corrosion barrier, increasing the total impedance by almost 6 orders of magnitude and reducing the current densities by 4 orders of magnitude, compared to the bare electrode. The obtained results are discussed based on the correlation of structural information with impedance data presented for both electrolytes in the form of electrical equivalent circuits.Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP