An experimental study of near wall flow parameters in the blade end-wall corner region

The near wall flow parameters in the blade end-wall corner region is investigated. The blade end-wall corner region was simulated by mounting an airfoil section (NACA 65-015 base profile) symmetric blades on both sides of the flat plate with semi-circular leading edge. The initial 7 cm from the leading edge of the flat plate was roughened by gluing No. 4 floor sanding paper to artificially increase the boundary layer thickness on the flat plate. The initial flow conditions of the boundary layer upstream of the corner region are expected to dictate the behavior of flow inside the corner region. Therefore, an experimental investigation was extended to study the combined effect of initial roughness and increased level of free stream turbulence on the development of a 2-D turbulent boundary layer in the absence of the blade. The measurement techniques employed in the present investigation included, the conventional pitot and pitot-static probes, wall taps, the Preston tube, piezoresistive transducer and the normal sensor hot-wire probe. The pitot and pitot-static probes were used to obtain mean velocity profile measurements within the boundary layer. The measurements of mean surface static pressure were obtained with the surface static tube and the conventional wall tap method. The wall shear vector measurements were made with a specially constructed Preston tube. The flush mounted piezoresistive type pressure transducer were employed to measure the wall pressure fluctuation field. The velocity fluctuation measurements, used in obtaining the wall pressure-velocity correlation data, were made with normal single sensor hot-wire probe. At different streamwise stations, in the blade end-wall corner region, the mean values of surface static pressure varied more on the end-wall surface in the corner region were mainly caused by the changes in the curvature of the streamlines. The magnitude of the wall shear stress in the blade end-wall corner region increased significantly in the close vicinity of the corner line. The maximum value of the wall shear stress and its location from the corner line, on both the surfaces forming the corner region, were observed to change along the corner. These observed changes in the maximum values of the wall shear stress and its location from the corner line could be associated with the stretching and attenuation of the horseshoe vortex. The wall shear stress vectors in the blade end-wall corner region were observed to be more skewed on the end-wall surface as compared to that on the blade surface. The differences in the wall shear stress directions obtained with the Preston tube and flow visualization method were within the range in which the Preston tube was found to be insensitive to the yaw angle

A stable mode of bookmarking by TBP recruits RNA polymerase II to mitotic chromosomes.

Maintenance of transcription programs is challenged during mitosis when chromatin becomes condensed and transcription is silenced. How do the daughter cells re-establish the original transcription program? Here, we report that the TATA-binding protein (TBP), a key component of the core transcriptional machinery, remains bound globally to active promoters in mouse embryonic stem cells during mitosis. Using live-cell single-molecule imaging, we observed that TBP mitotic binding is highly stable, with an average residence time of minutes, in stark contrast to typical TFs with residence times of seconds. To test the functional effect of mitotic TBP binding, we used a drug-inducible degron system and found that TBP promotes the association of RNA Polymerase II with mitotic chromosomes, and facilitates transcriptional reactivation following mitosis. These results suggest that the core transcriptional machinery promotes efficient transcription maintenance globally

An investigation on the role of ytterbium in ytterbium promoted y-alumina-supported nickel catalysts for dry reforming of methane

Addition of low quantities of ytterbium to sol-gel prepared Ni/yAl2O3 catalysts has been shown to lead to significant increases in catalytic activity and long term stability in the catalytic conversion of CO2 and CH4 into syngas (H2 and CO). The role of ytterbium in these catalysts was investigated in this study through detailed investigations on the structure and composition of ytterbium promoted Ni/y-Al2O3 catalysts using the following techniques: synchrotron X-ray diffraction, X-ray Photoemission Spectroscopy, Transmission Electron Microscopy, Scanning Electron Microscopy/Energy Dispersive X-ray analysis, Temperature Programmed Reduction techniques and N2 adsorption-desorption isotherms. The results obtained indicated that ytterbium, at small quantities (up to 2 wt%), interacted strongly with the support which in turn altered the interaction between nickel and the support (most notably it was found to completely inhibit the formation of NiAl2O4). This decreased interaction between Ni and the support also led to a higher quantity of Ni being present in the catalyst in the form of Ni

Ordered monolayer gold nano-urchin structures and their size induced control for high gas sensing performance

The synthesis of ordered monolayers of gold nano-urchin (Au-NU) nanostructures with controlled size, directly on thin films using a simple electrochemical method is reported in this study. In order to demonstrate one of the vast potential applications, the developed Au-NUs were formed on the electrodes of transducers (QCM) to selectively detect low concentrations of elemental mercury (Hg0) vapor. It was found that the sensitivity and selectivity of the sensor device is enhanced by increasing the size of the nanospikes on the Au-NUs. The Au-NU-12 min QCM (Au-NUs with nanospikes grown on it for a period of 12 min) had the best performance in terms of transducer based Hg0 vapor detection. The sensor had 98% accuracy, 92% recovery, 96% precision (repeatability) and significantly, showed the highest sensitivity reported to date, resulting in a limit of detection (LoD) of only 32 μg/m3 at 75 °C. When compared to the control counterpart, the accuracy and sensitivity of the Au-NU-12 min was enhanced by ~2 and ~5 times, respectively. The results demonstrate the excellent activity of the developed materials which can be applied to a range of applications due to their long range order, tunable size and ability to form directly on thin-films

Pelagic sharks by-catch in the tuna longline fishery of the Indian EEZ

Several species of pelagic and oceanic sharks are caught by the tuna longliners of FSI while surveying the oceanic tuna resources in the Indian EEZ. Though the sharks are not targeted species in tuna longlining, they constitute a major share of the catches. The sharks hooked could be, therefore, treated as by- catches or incidental catches of the tuna longline fisher

Quintuple product identity as a special case of Ramanujan's 1ψ1 summation formula.

In this note we observe an interesting fact that the well-known quintuple product identity can be regarded as a special case of the celebrated 1ψ1 summation formula of Ramanujan which is known to unify the Jacobi triple product identity and the q-binomial theorem

Arithmetical Congruence Preservation: from Finite to Infinite

Various problems on integers lead to the class of congruence preserving functions on rings, i.e. functions verifying $a-b$ divides $f(a)-f(b)$ for all $a,b$. We characterized these classes of functions in terms of sums of rational polynomials (taking only integral values) and the function giving the least common multiple of $1,2,\ldots,k$. The tool used to obtain these characterizations is "lifting": if $\pi\colon X\to Y$ is a surjective morphism, and $f$ a function on $Y$ a lifting of $f$ is a function $F$ on $X$ such that $\pi\circ F=f\circ\pi$. In this paper we relate the finite and infinite notions by proving that the finite case can be lifted to the infinite one. For $p$-adic and profinite integers we get similar characterizations via lifting. We also prove that lattices of recognizable subsets of $Z$ are stable under inverse image by congruence preserving functions