Incorporation of Functionalized Polyhedral Oligomeric Silsesquioxane Nanomaterials as Reinforcing Agents for Impact Ice Mitigating Coatings

In-flight, aircraft are exposed to a wide range of environments. One commonly exposed environment are clouds containing super-cooled water droplets. These water drop- lets exist in a metastable state below the freezing point of water, in the range of 0 to -20C. As the vehicle impacts the droplets, latent heat is released and within milliseconds the droplets convert to ice. This process is referred to as impact icing or in-flight icing.1 Impact icing is a major concern for aircraft since it can lead to degraded aerodynamic performance and, if left un- treated, can lead to loss of the vehicle. Active approaches (i.e., pneumatic boots, heated air ducts) typically utilized in mitigating in-flight ice accretion significantly increases vehicle weight and cannot be applied to all aircraft.1-3 A passive approach based on coatings is desired, but durability issues are a concern, especially on the wing leading edge.3 Nanomaterials have been shown to afford significant improvement in coating and composite physical properties at low loading levels.4 In this study, Polyhedral Oligomeric Silsesquioxane (POSS) nanomaterials have been shown to increase coating durability. Also, with wide variety of functionalities present on the arm structure, POSS nanomaterials have been shown to readily alter coating surface chemistry to mitigate impact ice adhesion from -16 to -8C in a simulated in-flight icing environment

Reinforcing Additives for Ice Adhesion Reduction Coatings

Adhesion of contaminants has been identified as a ubiquitous issue for aeronautic exterior surfaces. In-flight icing is particularly hazardous for all aircraft and can be experienced throughout the year under the appropriate environmental conditions. On larger vehicles, the accretion of ice could result in loss of lift, engine failure, and potentially loss of vehicle and life were it not for active deicing or anti-icing equipment. Smaller vehicles though cannot support the mass and mechanical complexity of active ice mitigating systems and thus must rely upon passive approaches or avoid icing conditions altogether. One approach that may be applicable to all aircraft is the use of coatings. Durability remains an issue and has prevented realization of coatings for leading edge contamination mitigation. In this work, epoxy coatings were generated as a passive approach for ice adhesion mitigation and methods to improve durability were evaluated. Highly cross-linked epoxy systems can be extremely rigid, which could have deleterious consequences regarding application as a leading edge coating. Incorporation of flexible species, such as poly(ethylene glycol) may improve coating toughness.8 Additionally, core-shell rubber (CSR) particles have been utilized to improve fracture toughness of epoxies.9 Both of these more established additives are investigated in this work. An emerging additive that is also evaluated here is holey graphene. This nanomaterial possesses many of the advantageous properties of graphene (excellent mechanical properties, thermal and electrical conductivity, large surface area, etc.) while also exhibiting behaviors associated with flexible, porous materials (i.e., compressibility, increased permeation, etc.). Holey graphene, HG, was synthesized by the oxidation of defect-rich sites on graphene sheets through controlled thermal expo-sure.10 It is envisioned that the porous nature of HG would allow resin penetration through the graphitic plane, resulting in better interfacial interaction and therefore better translation of the nanomaterials properties to the surrounding matrix

The Effect of Stainless Steel 304 Surface Roughness on Ice Adhesion Shear Strength of Accreted Impact Ice

Aircraft in-flight icing is problematic due to the ad-verse effect on vehicle performance. It occurs when supercooled water droplets (SCWD) present in clouds, under the appropriate environmental conditions, col-lide with the aircraft surface resulting in accretion of ice (i.e., impact icing). Impact ice can range from clear/glaze to rime or a combination of the two (i.e., mixed) with the type determined by the air temperature (0 to -20C), liquid water content (LWC, 0.3-0.6 g/cu.m), and droplet size [median volumetric diameter (MVD) of 15-40 m] present during accretion.1 These impact icing events generally occur at temperatures ranging from 0 to -20C. Below -20C, ice crystals dominate the environment and typically do not adhere to the aircraft surface. A main difference between an impact icing occurrence and a slow growth icing (i.e., freezer ice) one is the speed of the icing event. Besides environmental conditions, ice adhesion strength (IAS) to a metallic substrate depends upon surface roughness. It is known that increasing surface roughness and decreasing temperature lead to in-creases in IAS

Orphan receptor GPR110, an oncogene overexpressed in lung and prostate cancer

<p>Abstract</p> <p>Background</p> <p>GPR110 is an orphan G protein-coupled receptor--a receptor without a known ligand, a known signaling pathway, or a known function. Despite the lack of information, one can assume that orphan receptors have important biological roles. In a retroviral insertion mutagenesis screen in the mouse, we identified GPR110 as an oncogene. This prompted us to study the potential isoforms that can be gleaned from known GPR110 transcripts, and the expression of these isoforms in normal and transformed human tissues.</p> <p>Methods</p> <p>Various epitope-tagged isoforms of GPR110 were expressed in cell lines and assayed by western blotting to determine cleavage, surface localization, and secretion patterns. GPR110 transcript and protein levels were measured in lung and prostate cancer cell lines and clinical samples, respectively, by quantitative PCR and immunohistochemistry.</p> <p>Results</p> <p>We found four potential splice variants of GPR110. Of these variants, we confirmed three as being expressed as proteins on the cell surface. Isoform 1 is the canonical form, with a molecular mass of about 100 kD. Isoforms 2 and 3 are truncated products of isoform 1, and are 25 and 23 kD, respectively. These truncated isoforms lack the seven-span transmembrane domain characteristic of GPR proteins and thus are not likely to be membrane anchored; indeed, isoform 2 can be secreted. Compared with the median gene expression of ~200 selected genes, GPR110 expression was low in most tissues. However, it had higher than average gene expression in normal kidney tissue and in prostate tissues originating from older donors. Although identified as an oncogene in murine T lymphomas, GPR110 is greatly overexpressed in human lung and prostate cancers. As detected by immunohistochemistry, GPR110 was overexpressed in 20 of 27 (74%) lung adenocarcinoma tissue cores and in 17 of 29 (59%) prostate adenocarcinoma tissue cores. Additionally, staining with a GPR110 antibody enabled us to differentiate between benign prostate hyperplasia and potential incipient malignancy.</p> <p>Conclusion</p> <p>Our work suggests a role for GPR110 in tumor physiology and supports it as a potential therapeutic candidate and disease marker for both lung and prostate cancer.</p

A cross-sectional survey of prevalence and correlates of suicidal ideation and suicide attempts among prisoners in New South Wales, Australia

<p>Abstract</p> <p>Background</p> <p>We aimed to estimate the prevalence of suicidal ideation and suicide attempt among prisoners in New South Wales, Australia; and, among prisoners reporting suicidal ideation, to identify factors associated with suicide attempt.</p> <p>Methods</p> <p>A cross-sectional design was used. Participants were a random, stratified sample of 996 inmates who completed a telephone survey. The estimated population prevalence of suicidal ideation and suicide attempt were calculated and differences by sex and Aboriginality were tested using <it>χ</it>2 tests. Correlates of suicidal ideation and suicide attempt were tested using logistic regression.</p> <p>Results</p> <p>One-third of inmates reported lifetime suicidal ideation and one-fifth had attempted suicide. Women and Aboriginal participants were significantly more likely than men and non-Aboriginal participants, respectively, to report attempting suicide. Correlates of suicidal ideation included violent offending, traumatic brain injury, depression, self-harm, and psychiatric hospitalisation. Univariate correlates of suicide attempt among ideators were childhood out-of-home care, parental incarceration and psychiatric hospitalization; however, none of these remained significant in a multivariate model.</p> <p>Conclusions</p> <p>Suicidal ideation and attempts are highly prevalent among prisoners compared to the general community. Assessment of suicide risk is a critical task for mental health clinicians in prisons. Attention should be given to ensuring assessments are gender- and culturally sensitive. Indicators of mental illness may not be accurate predictors of suicide attempt. Indicators of childhood trauma appear to be particularly relevant to risk of suicide attempt among prisoners and should be given attention as part of risk assessments.</p

Initial sequencing and analysis of the human genome

The human genome holds an extraordinary trove of information about human development, physiology, medicine and evolution. Here we report the results of an international collaboration to produce and make freely available a draft sequence of the human genome. We also present an initial analysis of the data, describing some of the insights that can be gleaned from the sequence.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/62798/1/409860a0.pd

Metadata Best Practices for Trans and Gender Diverse Resources

This document is the result of a year of work and collaboration by the Trans Metadata Collective (TMDC; https://transmetadatacollective.org/), a group of dozens of cataloguers, librarians, archivists, scholars, and information professionals with a concerted interest in improving the description and classification of trans and gender diverse people in GLAMS (Galleries, Libraries, Archives, Museums and Special Collections). The Collective’s primary goal was to develop a set of best practices for the description, cataloguing, and classification of information resources as well as the creation of metadata about trans and gender diverse people, including authors and other creators

Metadata Best Practices for Trans and Gender Diverse Resources

This document is the result of a year of work and collaboration by the Trans Metadata Collective (TMDC; https://transmetadatacollective.org/), a group of dozens of cataloguers, librarians, archivists, scholars, and information professionals with a concerted interest in improving the description and classification of trans and gender diverse people in GLAMS (Galleries, Libraries, Archives, Museums and Special Collections). The Collective’s primary goal was to develop a set of best practices for the description, cataloguing, and classification of information resources as well as the creation of metadata about trans and gender diverse people, including authors and other creators