Towards robust aero-thermodynamic predictions for re-usable single-stage to orbit vehicles

Re-usable single stage to orbit launch vehicles promise to reduce the cost of access to space, but their success will be particularly reliant on accurate and robust modelling of their aero-thermodynamic characteristics. For preliminary design and optimization studies, relatively simple numerical prediction techniques must perforce be used, but it is important that the uncertainty that is inherent in the predictions of these models be understood. Predictions of surface pressure and heat transfer obtained using a new reduced-order model that is based on the Newtonian flow assumption and the Reynolds analogy for heating are compared against those of a more physically-sophisticated Direct Simulation Monte Carlo method in order to determine the ability of the model to capture the aero-thermodynamics of vehicles with very complex configuration even when run at low enough resolution to be practical in the context of design optimization studies. Attention is focused on the high-altitude regime where lifting re-usable Single-Stage to Orbit configurations will experience their greatest thermal load during re-entry, but where non-continuum effects within the gas of the atmosphere might be important. It is shown that the reduced-order model is capable of reproducing the results of the more complex Monte Carlo formalism with surprising fidelity, but that residual uncertainties exist, particularly in the behaviour of the heating models and in the applicability of the continuum assumption given the onset of finite slip velocity on surface of vehicle. The results suggest thus that, if used with care, reduced-order models such as those described here can be used very effectively in the design and optimization of space-access vehicles with very complex configuration, as long as their predictions are adequately supported by the use of more sophisticated computational techniques

Soft-mode anisotropy in the negative thermal expansion material ReO3

We use a symmetry-motivated approach to analyse neutron pair distribution function data to investigate the character of the soft phonon modes in negative thermal expansion (NTE) material ReO3. This analysis shows that its local structure is dominated by an in-phase octahedral tilting mode and that the octahedral units are far less flexible to scissoring type deformations than in the related NTE compound ScF3. The lack of flexibility in ReO3 restricts the NTE-driving phonons to a smaller region of reciprocal space, limiting the magnitude and temperature range of NTE. These results support the idea that structural flexibility is an important factor in NTE materials. Surprisingly, our results show that the local fluctuations, even at elevated temperatures, respect the symmetry and order parameter direction of the initial pressure induced phase transition in ReO3. The result indicates that the dynamic motions associated with rigid unit modes are highly anisotropic in these systems

Final Assembly of the Helmholtz Zentrum Berlin Series Connected Hybrid Magnet System

The final assembly of the Series Connected Hybrid magnet system for the Helmholtz Zentrum Berlin for Materials and Energy HZB has occurred with the integration of the superconducting cold mass, cryostat, resistive Florida Bitter coils, and the cryogenic, chilled water, power, and control subsystems. The hybrid magnet consists of a 13 T superconducting Nb3Sn CICC coil and a set of 12 T resistive, water cooled coils at 4.4 MW. Much of the cryostat and cold mass functional requirements were dictated by the electromagnetic interactions between the superconducting and resistive coils. This includes the radial decentering and axial aligning forces from normal operations and a 1.1 MN fault load. The system assembly was an international achievement with the cold mass being completed at the NHMFL in the USA, cryostat to cold mass interfaces made at Criotec Impianti in Italy, and final assembly at the HZB in German

Superheavy Dark Matter with Discrete Gauge Symmetries

We show that there are discrete gauge symmetries protect naturally heavy X particles from decaying into the ordinary light particles in the supersymmetric standard model. This makes the proposal very attractive that the superheavy X particles constitute a part of the dark matter in the present universe. It is more interesting that there are a class of discrete gauge symmetries which naturally accommodate a long-lived unstable X particle. We find that in some discrete Z_{10} models, for example, a superheavy X particle has lifetime \tau_X \simeq 10^{11}-10^{26} years for its mass M_X \simeq 10^{13}-10^{14} GeV. This long lifetime is guaranteed by the absence of lower dimensional operators (of light particles) couple to the X. We briefly discuss a possible explanation for the recently observed ultra-high-energy cosmic ray events by the decay of this unstable X particle.Comment: 9 pages, Late

Density-functional embedding using a plane-wave basis

The constrained electron density method of embedding a Kohn-Sham system in a substrate system (first described by P. Cortona, Phys. Rev. B {\bf 44}, 8454 (1991) and T.A. Wesolowski and A. Warshel, J. Phys. Chem {\bf 97}, 8050 (1993)) is applied with a plane-wave basis and both local and non-local pseudopotentials. This method divides the electron density of the system into substrate and embedded electron densities, the sum of which is the electron density of the system of interest. Coupling between the substrate and embedded systems is achieved via approximate kinetic energy functionals. Bulk aluminium is examined as a test case for which there is a strong interaction between the substrate and embedded systems. A number of approximations to the kinetic-energy functional, both semi-local and non-local, are investigated. It is found that Kohn-Sham results can be well reproduced using a non-local kinetic energy functional, with the total energy accurate to better than 0.1 eV per atom and good agreement between the electron densities.Comment: 11 pages, 4 figure

Isotropization of Ultra-High Energy Cosmic Ray Arrival Directions by Radio Ghosts

The isotropy in the ultra high energy cosmic ray (UHECR) flux observed by Yakutsk and AGASA experiments, is a very strong constraint to production and propagation models alike. Most of the scenarios proposed in the literature should produce a sizable anisotropy as either extragalactic luminous or dark matter is normally associated with the invoked particle sources. We explore the possibility that the magnetic fields in fossil cocoons of former radio galaxies -- so called {\it radio ghosts} -- are able to scatter UHECR in the intergalactic medium giving rise to the observed isotropy. We show, through numerical simulations, under which conditions this process can be operative and the magnitude of the effect. We further demonstrate, that if radio ghosts mix with the ambient medium, they might be able to produce the observed magnetic fields in clusters of galaxies. In the case of mixing, the UHECR isotropization would be even stronger than in our conservative estimates.Comment: Astroparticle Physics (accepted)--30 pages, 13 figures--please, contact GMT for higher quality figure

Initial State Interactions for K−K^--Proton Radiative Capture

The effects of the initial state interactions on the $K^--p$ radiative capture branching ratios are examined and found to be quite sizable. A general coupled-channel formalism for both strong and electromagnetic channels using a particle basis is presented, and applied to all the low energy $K^--p$ data with the exception of the {\it 1s} atomic level shift. Satisfactory fits are obtained using vertex coupling constants for the electromagnetic channels that are close to their expected SU(3) values.Comment: 16 pages, uses revte

Ultra-High Energy Neutrino Fluxes and Their Constraints

Applying our recently developed propagation code we review extragalactic neutrino fluxes above 10^{14} eV in various scenarios and how they are constrained by current data. We specifically identify scenarios in which the cosmogenic neutrino flux, produced by pion production of ultra high energy cosmic rays outside their sources, is considerably higher than the "Waxman-Bahcall bound". This is easy to achieve for sources with hard injection spectra and luminosities that were higher in the past. Such fluxes would significantly increase the chances to detect ultra-high energy neutrinos with experiments currently under construction or in the proposal stage.Comment: 11 pages, 15 figures, version published in Phys.Rev.

Relic neutrino masses and the highest energy cosmic rays

We consider the possibility that a large fraction of the ultrahigh energy cosmic rays are decay products of Z bosons which were produced in the scattering of ultrahigh energy cosmic neutrinos on cosmological relic neutrinos. We compare the observed ultrahigh energy cosmic ray spectrum with the one predicted in the above Z-burst scenario and determine the required mass of the heaviest relic neutrino as well as the necessary ultrahigh energy cosmic neutrino flux via a maximum likelihood analysis. We show that the value of the neutrino mass obtained in this way is fairly robust against variations in presently unknown quantities, like the amount of neutrino clustering, the universal radio background, and the extragalactic magnetic field, within their anticipated uncertainties. Much stronger systematics arises from different possible assumptions about the diffuse background of ordinary cosmic rays from unresolved astrophysical sources. In the most plausible case that these ordinary cosmic rays are protons of extragalactic origin, one is lead to a required neutrino mass in the range 0.08 eV - 1.3 eV at the 68 % confidence level. This range narrows down considerably if a particular universal radio background is assumed, e.g. to 0.08 eV - 0.40 eV for a large one. The required flux of ultrahigh energy cosmic neutrinos near the resonant energy should be detected in the near future by AMANDA, RICE, and the Pierre Auger Observatory, otherwise the Z-burst scenario will be ruled out.Comment: 19 pages, 22 figures, REVTeX