Direct observation of voids in the vacancy excess region of ion bombarded silicon

The results reported in this letter indicate that the spatial separation of the vacancy and interstitial excesses which result from ion bombardment gives rise to stable voids upon annealing at 850 °C even for implants where the projected ion range is only of the order of a few thousand Ångstrom. Such voids have been observed directly by transmission electron microscopy. Furthermore, in cases where both voids and interstitial-based defects are present at different depths, it is found that Au has a strong preference for decorating void surfaces and hence Au can, indeed, be used as a selective detector of open volume defects in Si.One of the authors ~J.W.-L.! acknowledges the Australian Research Council for financial support

Holographic analysis of thin films

Technique for monitoring deposition of films on surfaces, in place on a real-time basis, reads both the thickness and the uniformity of the deposited film. Holograms are produced from both reflected and transmitted light on one plate

Thermistor holder for skin-temperature measurements

Sensing head of thermistor probe is supported in center area of plastic ring which has tabs so that it can be anchored in place by rubber bands or adhesive tapes. Device attaches probes to human subjects practically, reliably, and without affecting characteristics of skin segment being measured

Detection of H-alpha emission from the Magellanic Stream: evidence for an extended gaseous Galactic halo

We have detected faint, diffuse H$\alpha emission from several points along the Magellanic Stream, using the Rutgers Fabry--Perot Interferometer at the CTIO 1.5-m telescope. At points on the leading edges of the H I clouds MS II, MS III, and MS IV, we detect H$\alpha emission of surface brightness $0.37 \pm 0.02$ Rayleighs, $0.21 \pm 0.04$ R, and $0.20 \pm 0.02$ R respectively, corresponding to emission measures of 1.0 to 0.5 \cmsixpc. We have observed several positions near the MS IV concentration, and find that the strongest emission is on the sharp leading-edge density gradient. There is less emission at points away from the gradient, and halfway between MS III and MS IV the H$\alpha surface brightness is$< 0.04$R. We attribute the H$\alpha emission at cloud leading edges to heating of the Stream clouds by ram pressure from ionized gas in the halo of the Galaxy. These observations suggest that ram pressure from halo gas plays a large role in stripping the Stream out of the Magellanic Clouds. They also suggest the presence of a relatively large density of gas, $n_{\rm H} \sim 10^{-4} cm^{-3}$, in the Galactic halo at $\sim 50$ kpc radius, and far above the Galactic plane, $b \sim -80\deg$. This implies that the Galaxy has a very large baryonic, gaseous extent, and supports models of Lyman-$\alpha and metal-line QSO absorption lines in which the absorption systems reside in extended galactic halos.Comment: 15 pages, aaspp latex, + 1 table & 3 figures. Accepted in A.J. Also available from http://www.physics.rutgers.edu/~bweiner/astro/papers

Automatic water inventory, collecting, and dispensing unit

Two cylindrical tanks with piston bladders and associated components for automatic filling and emptying use liquid inventory readout devices in control of water flow. Unit provides for adaptive water collection, storage, and dispensation in weightlessness environment

Start-to-end modelling of a mode-locked optical klystron free electron laser amplifier

A free electron laser (FEL) in a mode-locked optical klystron (MLOK) configuration is modelled using start-to-end simulations that simulate realistic electron beam acceleration and transport before input into a full three-dimensional FEL simulation code. These simulations demonstrate that the MLOK scheme is compatible with the present generation of radiofrequency accelerator designs. A train of few-optical cycle pulses is predicted with peak powers similar to those of the equivalent conventional FEL amplifier. The role of electron beam energy modulation in these results is explained and the limitations of some simulation codes discussed. It is shown how seeding the FEL interaction using a High Harmonic seed laser can improve the coherence properties of the output

Ultrasonic attenuation as an indicator of fatigue life of graphite/epoxy fiber composite

The narrow band ultrasonic longitudinal wave velocity and attenuation were measured as a function of the transfiber compression-compression fatigue of unidirectional graphite/epoxy composites. No change in velocity was detected at any point in fatigue life. For specimens fatigued at 80% of static strength, there was generally a 5% to 10% increase in attenuation, however, this increase does not appear to be a satisfactory indicator of fatigue life. On the other hand, there appears to be a correlation between initial attenuation (measured prior to cycling) and cycles to fracture. Initial attenuation as measured at 1.5 MHz and 2.0 MHz appears to be a good indicator of relative fatigue life

FLIC Overlap Fermions

The action of the overlap-Dirac operator on a vector is typically implemented indirectly through a multi-shift conjugate gradient solver. The compute-time required depends upon the condition number, $\kappa$, of the matrix that is used as the overlap kernel. While the Wilson action is typically used as the overlap kernel, the FLIC (Fat Link Irrelevant Clover) action has an improved condition number and provides up to a factor of two speedup in evaluating the overlap action. We summarize recent progress on the use of FLIC overlap fermions.Comment: Lattice2002(chiral