Engineering interface-type resistive switching in BiFeO3 thin film switches by Ti implantation of bottom electrodes

BiFeO3 based MIM structures with Ti-implanted Pt bottom electrodes and Au top electrodes have been fabricated on Sapphire substrates. The resulting metal-insulator-metal (MIM) structures show bipolar resistive switching without an electroforming process. It is evidenced that during the BiFeO3 thin film growth Ti diffuses into the BiFeO3 layer. The diffused Ti effectively traps and releases oxygen vacancies and consequently stabilizes the resistive switching in BiFeO3 MIM structures. Therefore, using Ti implantation of the bottom electrode, the retention performance can be greatly improved with increasing Ti fluence. For the used raster-scanned Ti implantation the lateral Ti distribution is not homogeneous enough and endurance slightly degrades with Ti fluence. The local resistive switching investigated by current sensing atomic force microscopy suggests the capability of down-scaling the resistive switching cell to one BiFeO3 grain size by local Ti implantation of the bottom electrode

Fabrication of highly n-type-doped germanium nanowires and Ohmic contacts using ion implantation and flash lamp annealing

Accurate control of doping and fabrication of metal contacts on n-type germanium nanowires (GeNWs) with low resistance and linear characteristics remain a major challenge in germanium-based nanoelectronics. Here, we present a combined approach to fabricate Ohmic contacts on n-type-doped GeNWs. Phosphorus (P) implantation followed by millisecond rear-side flash lamp annealing was used to produce highly n-type-doped Ge with an electron concentration in the order of 10^19-10^20 cm^{-3}. Electron beam lithography, inductively coupled plasma reactive ion etching, and nickel (Ni) deposition were used to fabricate GeNW-based devices with symmetric Hall bar configuration, which allows detailed electrical characterization of the NWs. Afterward, rear-side flash lamp annealing was applied to form Ni germanide at the Ni-GeNWs contacts to reduce the Schottky barrier height. The two-probe current-voltage measurements on P-doped GeNWs exhibit linear Ohmic behavior. Also, the size-dependent electrical measurements showed that carrier scattering near the NW surfaces and reduction of the effective NW cross-section dominate the charge transport in the GeNWs

Vertical GeSn nanowire MOSFETs for CMOS beyond silicon

The continued downscaling of silicon CMOS technology presents challenges for achieving the required low power consumption. While high mobility channel materials hold promise for improved device performance at low power levels, a material system which enables both high mobility n-FETs and p-FETs, that is compatible with Si technology and can be readily integrated into existing fabrication lines is required. Here, we present high performance, vertical nanowire gate-all-around FETs based on the GeSn-material system grown on Si. While the p-FET transconductance is increased to 850 µS/µm by exploiting the small band gap of GeSn as source yielding high injection velocities, the mobility in n-FETs is increased 2.5-fold compared to a Ge reference device, by using GeSn as channel material. The potential of the material system for a future beyond Si CMOS logic and quantum computing applications is demonstrated via a GeSn inverter and steep switching at cryogenic temperatures, respectively

Operando diagnostic detection of interfacial oxygen ‘breathing’ of resistive random access memory by bulk-sensitive hard X-ray photoelectron spectroscopy

The HfO2-based resistive random access memory (RRAM) is one of the most promising candidates for non-volatile memory applications. The detection and examination of the dynamic behavior of oxygen ions/vacancies are crucial to deeply understand the microscopic physical nature of the resistive switching (RS) behavior. By using synchrotron radiation based, non-destructive and bulk-sensitive hard X-ray photoelectron spectroscopy (HAXPES), we demonstrate an operando diagnostic detection of the oxygen ‘breathing’ behavior at the oxide/metal interface, namely, oxygen migration between HfO2 and TiN during different RS periods. The results highlight the significance of oxide/metal interfaces in RRAM, even in filament-type devices

Operando diagnostic detection of interfacial oxygen ‘breathing’ of resistive random access memory by bulk-sensitive hard X-ray photoelectron spectroscopy

The HfO2-based resistive random access memory (RRAM) is one of the most promising candidatesfor non-volatile memory applications. The detection and examination of the dynamic behavior ofoxygen ions/vacancies are crucial to deeply understand the microscopic physical nature of theresistive switching (RS) behavior. By using synchrotron radiation based, non-destructive and bulksensitivehard X-ray photoelectron spectroscopy (HAXPES), we demonstrate an operando diagnosticdetection of the oxygen ‘breathing’ behavior at the oxide/metal interface, namely, oxygen migrationbetween HfO2 and TiN during different RS periods. The results highlight the significance ofoxide/metal interfaces in RRAM, even in filament-type devices