Evolution of Resistive Switching Characteristics in WO3-x-based MIM Devices by Tailoring Oxygen Deficiency

We report on resistive switching (RS) characteristics of W/WO3-x/Pt-based thin film memristors modulated by precisely controlled oxygen non-stoichiometry. RS properties of the devices with varied oxygen vacancy (VO) concentration have been studied by measuring their DC current voltage properties. Switchability of the resistance states in the memristors have been found to depend strongly on the VOs concentration in the WO3-x layer. Depending on x, the memristors exhibited forming-free bipolar, forming-required bipolar and non-formable characteristics. Devices with high VOs concentration (~1*1021 cm-3) exhibited lower initial resistance and memory window of only 15, which has been increased to ~6500 with reducing VOs concentration to ~5.8*1020 cm-3. Forming-free, stable RS with memory window of ~2000 have been realized for a memristor possessing VOs concentration of ~6.2*1020 cm-3. Investigation of the conduction mechanism suggests that tailoring VOs concentration modifies the formation and dimension of the conducting filaments as well as the Schottky barrier height at WO3-x/Pt interface which deterministically modulates RS characteristics of the WO3-x based memristors

Electrocaloric effect of PMN-PT thin films near morphotropic phase boundary

The electrocaloric effect is calculated for PMN-PT relaxor ferroelectric thin film near morphotropic phase boundary composition. Thin film of thickness, ~240 nm, has been deposited using pulsed laser deposition technique on a highly (111) oriented platinized silicon substrate at 700°C and at 100 mtorr oxygen partial pressure. Prior to the deposition of PMN-PT, a template layer of LSCO of thickness, ~60 nm, is deposited on the platinized silicon substrate to hinder the pyrochlore phase formation. The temperature dependent P-E loops were measured at 200 Hz triangular wave operating at the virtual ground mode. Maximum reversible adiabatic temperature change, ΔT = 31 K, was calculated at 140°C for an external applied voltage of 18 V

Investigation of biferroic properties in La0.6Sr0.4MnO3/0.7 Pb(Mg1/3Nb2/3)O3 0.3 PbTiO3 epitaxial bilayered heterostructures

Epitaxial bilayered thin films consisting of La0.6Sr0.4MnO3 (LSMO) and 0.7 Pb(Mg1/3Nb2/3)O3 0.3 PbTiO3 (PMN-PT) layers of relatively different thicknesses were fabricated on LaNiO3 coated LaAlO3 (100) single crystal substrates by pulsed laser ablation technique. Ferroelectric and ferromagnetic characteristics of these heterostructures confirmed their biferroic nature. The magnetization and ferroelectric polarization of the bilayered heterostructures were enhanced with increasing PMN-PT layer thickness owing to the effect of lattice strain. Dielectric properties of these heterostructures studied over a wide range of temperature under different magnetic field strength suggested a possible role of elastic strain mediated magnetoelectric coupling behind the observed magneto-dielectric effect in addition to the influence of rearrangement of the interfacial charge carriers under an applied magnetic field

Magnetocapacitive La0.6Sr0.4MnO3 0.7Pb(Mg0.33Nb0.67)O3 0.3PbTiO3 epitaxial heterostructures

Epitaxial heterostructures of La0.6Sr0.4MnO3 0.7Pb(Mg0.33Nb0.67)O3 0.3PbTiO3 were fabricated on LaNiO3 coated LaAlO3 (100) substrates by pulsed laser ablation. Ferromagnetic and ferroelectric hysteresis established their biferroic nature. Dielectric behviour studied under different magnetic fields over a wide range of frequency and temperatures revealed that the capacitance in these heterostructures varies with the applied magnetic field. Appearance of magnetocapacitance and its dependence on magnetic fields, magnetic layer thickness, temperature and frequency indicated a combined contribution of strain mediated magnetoelectric coupling, magnetoresistance of the magnetic layer and Maxwell Wagner effect on the observed properties

Engineering room-temperature multiferroicity in Bi and Fe codoped BaTiO3

Fe doping into BaTiO3, stabilizes the paraelectric hexagonal phase in place of the ferroelectric tetragonal one [P. Pal et al. Phys. Rev. B, 101, 064409 (2020)]. We show that simultaneous doping of Bi along with Fe into BaTiO3 effectively enhances the magnetoelectric (ME) multiferroic response (both ferromagnetism and ferroelectricity) at room-temperature, through careful tuning of Fe valency along with the controlled-recovery of ferroelectric-tetragonal phase. We also report systematic increase in large dielectric constant values as well as reduction in loss tangent values with relatively moderate temperature variation of dielectric constant around room-temperature with increasing Bi doping content in Ba1-xBixTi0.9Fe0.1O3 (0<x<0.1), which makes the higher Bi-Fe codoped sample (x=0.08) promising for the use as room-temperature high-k dielectric material. Interestingly, x=0.08 (Bi-Fe codoped) sample is not only found to be ferroelectrically (~20 times) and ferromagnetically (~6 times) stronger than x=0 (only Fe-doped) at room temperature, but also observed to be better insulating (larger bandgap) with indirect signatures of larger ME coupling as indicated from anomalous reduction of magnetic coercive field with decreasing temperature. Thus, room-temperature ME multiferroicity has been engineered in Bi and Fe codoped BTO (BaTiO3) compounds.Comment: 16 pages, 17 figure

Investigation of true remnant polarization response in heterostructured artificial biferroics

Epitaxial bilayered thin films composed of ferromagnetic La0.6Sr0.4MnO3 and ferroelectric 0.7Pb (Mg1/3Nb2/3)O3-0.3(PbTiO3) were fabricated on LaAlO3 (100) substrates by pulsed laser ablation. Ferroelectric, ferromagnetic and magneto-dielectric characterizations performed earlier indicated the possible existence of strain-mediated magneto-electric coupling in these biferroic heterostructures. In order to investigate their true remnant polarization characteristics, usable in devices, room-temperature polarization versus electric field, positive-up negative-down (PUND) pulse polarization studies and remnant hysteresis measurements were carried out. The PUND and remnant hysteresis measurements revealed the significant contribution of the non-remnant component in the observed polarization hysteresis response of these heterostructures. (C) 2010 Published by Elsevier Lt

Engineered Biferroic 0.7Pb(Mg1/3Nb2/3)O3-0.3PbTiO3/La0.6Sr0.4MnO3 Epitaxial Superlattices

Symmetric and asymmetric superlattices (SLs) composed of ferromagnetic La0.6Sr0.4MnO3 (LSMO) and ferroelectric 0.7Pb(Mg1/3Nb2/3)O3 – 0.3PbTiO3 (PMN-PT) with different periodicities have been fabricated on LaNiO3 (LNO) coated LaAlO3 (100) (LAO) substrates by pulsed laser ablation deposition. Structural, ferromagnetic and ferroelectric properties have been studied for all the SLs. All the heterostructures exhibited good ferromagnetic response over a wide range of temperatures (10K – 300K), whereas only the asymmetric SLs exhibited reasonably good ferroelectric behaviour. Ferromagnetic and ferroelectric hysteresis loops observed in the asymmetric SLs confirmed their biferroic nature. Studies were conducted towards understanding the influence of LSMO layers on the electrical responses of the heterostructures. Absence of ferroelectricity in the symmetric SL structures has been attributed to their high leakage characteristics. Strong influence of an applied magnetic field of 1.2T was observed on the ferroelectric properties of the asymmetric SLs. The effect of magnetic field on the ferroelectric properties of the SLs indicated possibility of strong interfacial effect