998 research outputs found
Near-field sonic-boom pressure signatures for the space shuttle launch and orbiter vehicles at Mach 6
Static-pressure signatures parallel to the flight path of the launch and entry configurations of the space shuttle were measured. The launch configurations, consisting of an equivalent body of revolution (representing the orbiter and external fuel tank) with a solid exhaust gas plume attached, was tested at an angle of attack of 0 deg. The entry configuration (orbiter only) was tested over an angle-of-attack range from 10 deg to 40 deg. Calculated pressure signatures were in good agreement with measured signatures for both configurations
Aerodynamic testing technique for twin fuselage models at hypersonic speeds
A testing technique for obtaining the static aerodynamic characteristics of twin-fuselage configurations at hypersonic speeds by using a conventional single-balance installation has been evaluated. Data from a triple-fuselage model and a single-fuselage model were summed and then halved to obtain the characteristics for a twin-fuselage model of the same scale. The three related models were evaluated experimentally at Mach 20.3 in helium and Mach 6 in air for an angle-of-attack range from minus 6 deg to 50 deg. The Reynolds numbers, based on model length, were 1.88 million for the Mach 20.3 tests and 2.55 million for the Mach 6 tests
Flow-field surveys on the windward side of the NASA 040A space shuttle orbiter at 31 deg angle of attack and Mach 20 in helium
Pitot pressure and flow angle distributions in the windward flow field of the NASA 040A space shuttle orbiter configuration and surface pressures were measured, at a Mach number of 20 and an angle of attack of 31 deg. The free stream Reynolds number, based on model length, was 5.39 x 10 to the 6th power. Results show that cores of high pitot pressure, which are related to the body-shock-wing-shock intersections, occur on the windward plane of symmetry in the vicinity of the wing-body junction and near midspan on the wing. Theoretical estimates of the flow field pitot pressures show that conical flow values for the windward plane of symmetry surface are representative of the average level over the entire lower surface
CENTER-LINE PRESSURE DISTRIBUTIONS ON TWO-DIMENSIONAL BODIES WITH LEADING-EDGE ANGLES GREATER THAN THAT FOR SHOCK DETACHMENT AT MACH NUMBER 6 AND ANGLES OF ATTACK UP TO 25 DEG
Center-line pressure distribution on two- dimensional bodie
A study of the sonic-boom characteristics of a blunt body at a Mach number of 6
An experimental and analytical study of the sonic boom static pressure signatures generated by a blunt body at mach 6 has shown that finite difference computer programs can be used to give reasonable estimates of the signatures. The calculated near field static pressure signature was extrapolated to the far field by a program using the method of characteristics. A comparison of this extrapolated signature with the signature predicted by far field sonic boom theory (linearized) shows that peak overpressures are about the same, at least up to mach, but the far field theory overestimates the length of the signature
Effects of surface roughness on the aerodynamic characteristics of the modified 089 B shuttle orbiter at Mach 6 (LA15)
A one hundredth scale model of the modified 089B shuttle orbiter was tested in the Langley 20-Inch Mach 6 tunnel. Force and moment, surface pressure and oilflow data were obtained on one model, and phase-change coating data were obtained on another. The pressure tests were conducted first; the tubes were clipped near the base of the model and then the force and moment and oil flow tests conducted. Angles of attack for the tests were from 20 deg to 35 deg and are commensurate with the range of flight values from entry down to Mach 5. The design flight Reynolds number at Mach 6, based on model length, was 15 million, which could not be obtained in the tunnel; therefore, the tests were conducted at the highest and lowest values for this model in the tunnel, 9.4 million and 4.0 million, respectively, to indicate Reynolds number effects. Two control deflection combinations, representative of the bank and pitch control limits of the design flight trajectory, were used
Boundary-layer transition and displacement thickness effects on zero-lift drag of a series of power-law bodies at Mach 6
Wave and skin-friction drag have been numerically calculated for a series of power-law bodies at a Mach number of 6 and Reynolds numbers, based on body length, from 1.5 million to 9.5 million. Pressure distributions were computed on the nose by the inverse method and on the body by the method of characteristics. These pressure distributions and the measured locations of boundary-layer transition were used in a nonsimilar-boundary-layer program to determine viscous effects. A coupled iterative approach between the boundary-layer and pressure-distribution programs was used to account for boundary-layer displacement-thickness effects. The calculated-drag coefficients compared well with previously obtained experimental data
- …