Measurements of greenhouse gases and related tracers at Bialystok tall tower station in Poland

Quasi-continuous, in-situ measurements of atmospheric CO2, O2/N2, CH4, CO, N2O, and SF6 have been performed since August 2005 at the tall tower station near Bialystok, in Eastern Poland, from five heights up to 300 m. Besides the in-situ measurements, flask samples are filled approximately weekly and measured at Max-Planck Institute for Biogeochemistry for the same species and, in addition, for H2, Ar/N2 and the stable isotopes 13C and 18O in CO2. The in-situ measurement system was built based on commercially available analysers: a LiCor 7000 for CO2, a Sable Systems "Oxzilla" FC-2 for O2, and an Agilent 6890 gas chromatograph for CH4, CO, N2O and SF6. The system was optimized to run continuously with very little maintenance and to fulfill the precision requirements of the CHIOTTO project. The O2/N2 measurements in particular required special attention in terms of technical setup and quality assurance. The evaluation of the performance after more than three years of operation gave overall satisfactory results, proving that this setup is suitable for long term remote operation with little maintenance. The precision achieved for all species is within or close to the project requirements. The comparison between the in-situ and flask sample results, used to verify the accuracy of the in-situ measurements, showed no significant difference for CO2, O2/N2, CH4 and N2O, and a very small difference for SF6. The same comparison however revealed a statistically significant difference for CO, of about 6.5 ppb, for which the cause could not be fully explained. From more than three years of data, the main features at Bialystok have been characterized in terms of variability, trends, and seasonal and diurnal variations. CO2 and O2/N2 show large short term variability, and large diurnal signals during the warm seasons, which attenuate with the increase of sampling height. The trends calculated from this dataset, over the period August 2005 to December 2008, are 2.02±0.46 ppm/year for CO2 and -23.2±2.5 per meg/year for O2/N2. CH4, CO and N2O show also higher variability at the lower sampling levels, which in the case of CO is strongly seasonal. Diurnal variations in CH4, CO and N2O mole fractions can be observed during the warm season, due to the periodicity of vertical mixing combined with the diurnal cycle of anthropogenic emissions. We calculated increase rates of 10.1±4.4 ppb/year for CH4, (-8.3)±5.3 ppb/year for CO and 0.67±0.08 ppb/year for N2O. SF6 shows only few events, and generally no vertical gradients, which suggests that there are no significant local sources. A weak SF6 seasonal cycle has been detected, which most probably is due to the seasonality of atmospheric circulation. SF6 increased during the time of our measurement at an average rate of 0.29±0.01 ppt/year

Sub 200 fs pulse generation from a graphene mode-locked fiber laser

Ultrafast fiber lasers with short pulses and broad bandwidth are in great demand for a variety of applications, such as spectroscopy, biomedical diagnosis and optical communications. In particular sub-200fs pulses are required for ultrafast spectroscopy with high temporal resolution. Graphene is an ideal ultra-wide-band saturable absorber. We report the generation of 174fs pulses from a graphene-based fiber lase

Graphene Q-switched, tunable fiber laser

We demonstrate a wideband-tunable Q-switched fiber laser exploiting a graphene saturable absorber. We get ~2us pulses, tunable between 1522 and 1555nm with up to~40nJ energy. This is a simple and low-cost light source for metrology, environmental sensing and biomedical diagnostics

Scalar nanosecond pulse generation in a nanotube mode-locked environmentally stable fiber laser

We report an environmentally stable nanotube mode-locked fibre laser producing linearly-polarized, nanosecond pulses. A simple all-polarization-maintaining fibre ring cavity is used, including 300 m of highly nonlinear fibre to elongate the cavity and increase intracavity dispersion and nonlinearity. The laser generates scalar pulses with a duration of 1.23 ns at a centre wavelength of 1042 nm, with 1.3-nm bandwidth and at 641-kHz repetition rate. Despite the long cavity, the output characteristics show no significant variation when the cavity is perturbed, and the degree of polarization remains at 97%

A stable, power scaling, graphene-mode-locked all-fiber oscillator

This is the final version. Available from AIP Publishing via the DOI in this record.We report power tunability in a fiber laser mode-locked with a solution-processed filtered graphene film on a fiber connector. 370 fs pulses are generated with output power continuously tunable from 4 up to 52 mW. This is a simple, low-cost, compact, portable, all-fiber ultrafast source for applications requiring environmentally stable, portable sources, such as imaging.European Research Council (ERC)Engineering and Physical Sciences Research Council (EPSRC)Emmanuel College, CambridgeIsaac Newton Trust, Trinity College Cambridg

Few-cycle pulses from a graphene mode-locked all-fiber laser

We combine a graphene mode-locked oscillator with an external compressor and achieve~29fs pulses with~52mW average power. This is a simple, low-cost, and robust setup, entirely fiber based, with no free-space optics, for applications requiring high temporal resolution

A stable, power scaling, graphene-mode-locked all-fiber oscillator

We report power tunability in a fiber laser mode-locked with a solution-processed filtered graphene film on a fiber connector. ∼370 fs pulses are generated with output power continuously tunable from ∼4 up to ∼52 mW. This is a simple, low-cost, compact, portable, all-fiber ultrafast source for applications requiring environmentally stable, portable sources, such as imaging.</jats:p

Tm-doped fiber laser mode-locked by graphene-polymer composite.

We demonstrate mode-locking of a thulium-doped fiber laser operating at 1.94 μm, using a graphene-polymer based saturable absorber. The laser outputs 3.6 ps pulses, with ~0.4 nJ energy and an amplitude fluctuation ~0.5%, at 6.46 MHz. This is a simple, low-cost, stable and convenient laser oscillator for applications where eye-safe and low-photon-energy light sources are required, such as sensing and biomedical diagnostics

Stable, Surfactant-Free Graphene–Styrene Methylmethacrylate Composite for Ultrafast Lasers

Graphene–polymer composites play an increasing role in photonic and optoelectronic applications, from ultrafast pulse generation to solar cells. The fabrication of an optical quality surfactant-free graphene-styrene methyl methacrylate composite, stable to large humidity and temperature ranges is reported. The composite is tailored for photonic applications showing wavelength-independent linear absorption in the visible and near-infrared. When tested in a mode-locked laser, it allows the generation of stable ≈ 326 fs mode-locked pulses at 1550 nm, unperturbed by environmental conditions. The composite continues to operate as a saturable absorber even under complete water immersion at 60 °C. This confi rms its stability against high- temperature and humidity