272 research outputs found
Chemical identification of microfossils from Gunflint chert (1.88 Ga) with spaceborne Mass Spectrometer
Stars and planetary system
Imaging thermal conductivity with nanoscale resolution using a scanning spin probe
The ability to probe nanoscale heat flow in a material is often limited by lack of spatial resolution. Here, we use a diamond-nanocrystal-hosted nitrogen-vacancy centre attached to the apex of a silicon thermal tip as a local temperature sensor. We apply an electrical current to heat up the tip and rely on the nitrogen vacancy to monitor the thermal changes the tip experiences as it is brought into contact with surfaces of varying thermal conductivity. By combining atomic force and confocal microscopy, we image phantom microstructures with nanoscale resolution, and attain excellent agreement between the thermal conductivity and topographic maps. The small mass and high thermal conductivity of the diamond host make the time response of our technique short, which we demonstrate by monitoring the tip temperature upon application of a heat pulse. Our approach promises multiple applications, from the investigation of phonon dynamics in nanostructures to the characterization of heterogeneous phase transitions and chemical reactions in various solid-state systems
Imaging thermal conductivity with nanoscale resolution using a scanning spin probe
The ability to probe nanoscale heat flow in a material is often limited by lack of spatial resolution. Here, we use a diamond-nanocrystal-hosted nitrogen-vacancy centre attached to the apex of a silicon thermal tip as a local temperature sensor. We apply an electrical current to heat up the tip and rely on the nitrogen vacancy to monitor the thermal changes the tip experiences as it is brought into contact with surfaces of varying thermal conductivity. By combining atomic force and confocal microscopy, we image phantom microstructures with nanoscale resolution, and attain excellent agreement between the thermal conductivity and topographic maps. The small mass and high thermal conductivity of the diamond host make the time response of our technique short, which we demonstrate by monitoring the tip temperature upon application of a heat pulse. Our approach promises multiple applications, from the investigation of phonon dynamics in nanostructures to the characterization of heterogeneous phase transitions and chemical reactions in various solid-state systems
Nanofriction mechanisms derived from the dependence of friction on load and sliding velocity from air to UHV on hydrophilic silicon
This paper examines friction as a function of the sliding velocity and
applied normal load from air to UHV in a scanning force microscope (SFM)
experiment in which a sharp silicon tip slides against a flat Si(100) sample.
Under ambient conditions, both surfaces are covered by a native oxide, which is
hydrophilic. During pump-down in the vacuum chamber housing the SFM, the
behavior of friction as a function of the applied normal load and the sliding
velocity undergoes a change. By analyzing these changes it is possible to
identify three distinct friction regimes with corresponding contact properties:
(a) friction dominated by the additional normal forces induced by capillarity
due to the presence of thick water films, (b) higher drag force from ordering
effects present in thin water layers and (c) low friction due to direct
solid-solid contact for the sample with the counterbody. Depending on
environmental conditions and the applied normal load, all three mechanisms may
be present at one time. Their individual contributions can be identified by
investigating the dependence of friction on the applied normal load as well as
on the sliding velocity in different pressure regimes, thus providing
information about nanoscale friction mechanisms
- …