2,769 research outputs found
Calibration Strategy and Efficiency measurement of the Muon Identification procedure at LHCb
We present a strategy for calibrating with data the LHCb muon identification procedure and for extracting in-situ the performance. Two main calibration samples are used: the inclusive decay as a source of muons and the decay as a source of hadrons decaying and non-decaying in flight. For each of them we describe the selection, the expected purity and the rates for different running scenarios. The distributions extracted from calibration samples are compared with those obtained from a generic b-inclusive sample. An estimate of the precision that can be reached in the evaluation of the muon identification efficiency and misidentification rate is given as a function of the collected statistics
Performance of the Muon Identification at LHCb
The performance of the muon identification in LHCb is extracted from data
using muons and hadrons produced in J/\psi->\mu\mu, \Lambda->p\pi and
D^{\star}->\pi D0(K\pi) decays. The muon identification procedure is based on
the pattern of hits in the muon chambers. A momentum dependent binary
requirement is used to reduce the probability of hadrons to be misidentified as
muons to the level of 1%, keeping the muon efficiency in the range of 95-98%.
As further refinement, a likelihood is built for the muon and non-muon
hypotheses. Adding a requirement on this likelihood that provides a total muon
efficiency at the level of 93%, the hadron misidentification rates are below
0.6%.Comment: 17 pages, 10 figure
Measurement of the front-end dead-time of the LHCb muon detector and evaluation of its contribution to the muon detection inefficiency
A method is described which allows to deduce the dead-time of the front-end
electronics of the LHCb muon detector from a series of measurements performed
at different luminosities at a bunch-crossing rate of 20 MHz. The measured
values of the dead-time range from 70 ns to 100 ns. These results allow to
estimate the performance of the muon detector at the future bunch-crossing rate
of 40 MHz and at higher luminosity
Performance of the LHCb muon system
The performance of the LHCb Muon system and its stability across the full
2010 data taking with LHC running at ps = 7 TeV energy is studied. The
optimization of the detector setting and the time calibration performed with
the first collisions delivered by LHC is described. Particle rates, measured
for the wide range of luminosities and beam operation conditions experienced
during the run, are compared with the values expected from simulation. The
space and time alignment of the detectors, chamber efficiency, time resolution
and cluster size are evaluated. The detector performance is found to be as
expected from specifications or better. Notably the overall efficiency is well
above the design requirementsComment: JINST_015P_1112 201
Performance of the LHCb muon system with cosmic rays
The LHCb Muon system performance is presented using cosmic ray events
collected in 2009. These events allowed to test and optimize the detector
configuration before the LHC start. The space and time alignment and the
measurement of chamber efficiency, time resolution and cluster size are
described in detail. The results are in agreement with the expected detector
performance.Comment: Submitted to JINST and accepte
Study of the a_0(980) meson via the radiative decay phi->eta pi^0 gamma with the KLOE detector
We have studied the phi->a_0(980) gamma process with the KLOE detector at the
Frascati phi-factory DAPhNE by detecting the phi->eta pi^0 gamma decays in the
final states with eta->gamma gamma and eta->pi^+ pi^- pi^0. We have measured
the branching ratios for both final states: Br(phi->eta pi^0 gamma)=(7.01 +/-
0.10 +/- 0.20)x10^-5 and (7.12 +/- 0.13 +/- 0.22)x10^-5 respectively. We have
also extracted the a_0(980) mass and its couplings to eta pi^0, K^+ K^-, and to
the phi meson from the fit of the eta pi^0 invariant mass distributions using
different phenomenological models.Comment: 17 pages, 6 figures, submitted to Physics Letters B. Corrected typos
in eq.
Precision Measurement of KS Meson Lifetime with the KLOE detector
Using a large sample of pure, slow, short lived K0 mesons collected with KLOE
detector at DaFne, we have measured the KS lifetime. From a fit to the proper
time distribution we find tau = (89.562 +- 0.029_stat +- 0.043_syst) ps. This
is the most precise measurement today in good agreement with the world average
derived from previous measurements. We observe no dependence of the lifetime on
the direction of the Ks.Comment: 5 pages, 7 figure
Study of the process e+e- -> omega pi0 in the phi-meson mass region with the KLOE detector
We have studied the e+e- -> omegapi0 cross section in the sqrt(s) interval
1000-1030 MeV using the pi+pi-pi0pi0 and pi0pi0gamma final states with a sample
of ~600 pb^-1 collected with the KLOE detector at DAFNE. By fitting the
observed interference pattern around M_phi for both final states, we extract
the ratio of the decay widths Gamma(omega->pi0gamma)/Gamma(omega->pi+pi-pi0) =
0.0897 +- 0.0016 and derive the branching fractions BR(omega -> pi+pi-pi0)=
(90.24 +- 0.19)%, BR(omega -> pi0gamma) = (8.09 +- 0.14)%. The parameters
describing the e+e- -> omegapi0 reaction around M_\phi are also used to extract
the branching fraction for the OZI and G-parity violating phi -> omegapi0
decay: BR(phi->omegapi0) = (4.4 +- 0.6)x10^-5.Comment: 12 Pages, 4 figures, submitted to Physics Letter
- …