A comparison of surface sensible and latent heat fluxes from aircraft and surface measurements in FIFE 1987

Surface fluxes of sensible and latent heat over a tall-grass prairie in central Kansas, as measured by 22 surface stations during FIFE 1987, are compared with values gained indirectly by linear extrapolation of aircraft-measured flux profiles to the surface. The results of 33 such comparisons covering the period 26 June to 13 October 1987 indicate that the sensible heat flux profiles were generally more linear with less scatter in the measurements at each level than were the latent heat flux profiles, the profile extrapolations of sensible heat flux in general underestimate the surface averages by about 30 percent, with slightly better agreement during periods of small flux, and the profile extrapolations of latent heat flux in general underestimate the surface averages by about 15 percent, with overestimates during periods of small fluxes (dry conditions) and overestimates during periods of large fluxes (moist conditions). Possible origins of the differences between the two sets of measurements are discussed, as directions for further research

Ultra-high-sensitivity two-dimensional bend sensor

A multicore fibre Fabry-Perot-based strain sensor interrogated with tandem interferometry for bend measurement is described. Curvature in two dimensions is obtained by measuring the difference in strain between three co-located low finesse Fabry-Perot interferometers formed in each core of the fibre by pairs of Bragg gratings. This sensor provides a responsivity enhancement of up to 30 times that of a previously reported fibre Bragg grating based sensor. Strain resolutions of 0.6 n epsilon/Hz(1/2) above 1 Hz are demonstrated, which corresponds to a curvature resolution of similar to 0.012 km(-1)/Hz(1/2)

Charged Vacuum Bubble Stability

A type of scenario is considered where electrically charged vacuum bubbles, formed from degenerate or nearly degenerate vacuua separated by a thin domain wall, are cosmologically produced due to the breaking of a discrete symmetry, with the bubble charge arising from fermions residing within the domain wall. Stability issues associated with wall tension, fermion gas, and Coulombic effects for such configurations are examined. The stability of a bubble depends upon parameters such as the symmetry breaking scale and the fermion coupling. A dominance of either the Fermi gas or the Coulomb contribution may be realized under certain conditions, depending upon parameter values.Comment: 16 pages,revtex; accepted for publication in Phys.Rev.

Redressing the balance: Commentary on “Examining motor learning in older adults using analogy instruction” by Tse, Wong, and Masters (2017)

Tse, Wong, and Masters (2017) recently published a study that indicated that analogy instruction may help older adults acquire resilient motor skills that require reduced cognitive processing compared to traditional explicit instruction. Although we do not dispute that analogy learning may prove useful for this population, in this commentary, we contend that there are methodological issues in this research—which are shared with previous studies comparing analogy and explicit instruction—that potentially limit ecological validity, impact the size of detected effects, influence the development and understanding of associated theory, and, as such, constrain resulting recommendations for applied practice. Of particular concern is the comparison of the single-item analogy instruction to the list of nine explicit instructions, which risks conflating the effects of the type of instruction with the volume of instruction. We further argue that the benefits of analogy may be more parsimoniously explained by the instruction’s capability to succinctly convey skill (rather than its potential for limiting reinvestment), but that this capability may only be realised if the to-be-learned analogy is relevant and readily understood by the learner. Finally, we suggest that research in this area must look to incorporate more rigorous methods that compare experimental conditions to representative reference groups that allow us to explore how and when to deploy the myriad instructional tools available to practitioners and learners

Potential signature of a quadrupolar Hubble expansion in Pantheon+ supernovae

The assumption of isotropy -- that the Universe looks the same in all directions on large scales -- is fundamental to the standard cosmological model. This model forms the building blocks of essentially all of our cosmological knowledge to date. It is therefore critical to empirically test in which regimes its core assumptions hold. Anisotropies in the cosmic expansion are expected on small scales due to nonlinear structures in the late Universe, however, the extent to which these anisotropies might impact our low-redshift observations remains to be fully tested. In this paper, we use fully general relativistic simulations to calculate the expected local anisotropic expansion and identify the dominant multipoles in cosmological parameters to be the quadrupole in the Hubble parameter and the dipole in the deceleration parameter. We constrain these multipoles simultaneously in the new Pantheon+ supernova compilation. The fiducial analysis is done in the rest frame of the CMB with peculiar velocity corrections. Under the fiducial range of redshifts in the Hubble flow sample, we find a $\sim 2\sigma$ deviation from isotropy. We constrain the eigenvalues of the quadrupole in the Hubble parameter to be $\lambda_1 =0.021\pm{ 0.011}$ and ${\lambda_2= 3.15\times 10^{-5}}\pm 0.012$ and place a $1\sigma$ upper limit on its amplitude of $2.88\%$. We find no significant dipole in the deceleration parameter, finding constraints of $q_{\rm dip} = 4.5^{+1.9}_{-5.4}$. However, in the rest frame of the CMB without corrections, we find $q_{ \rm dip} = 9.6^{+4.0}_{-6.9}$, a $>2\sigma$ positive amplitude. We also investigate the impact of these anisotropies on the Hubble tension. We find a maximal shift of $0.30$ km s$^{-1}$ Mpc$^{-1}$ in the monopole of the Hubble parameter and conclude that local anisotropies are unlikely to fully explain the observed tension.Comment: 12 pages, to be submitted to MNRA

Quantitative localized proton-promoted dissolution kinetics of calcite using scanning electrochemical microscopy (SECM)

Scanning electrochemical microscopy (SECM) has been used to determine quantitatively the kinetics of proton-promoted dissolution of the calcite (101̅4) cleavage surface (from natural “Iceland Spar”) at the microscopic scale. By working under conditions where the probe size is much less than the characteristic dislocation spacing (as revealed from etching), it has been possible to measure kinetics mainly in regions of the surface which are free from dislocations, for the first time. To clearly reveal the locations of measurements, studies focused on cleaved “mirror” surfaces, where one of the two faces produced by cleavage was etched freely to reveal defects intersecting the surface, while the other (mirror) face was etched locally (and quantitatively) using SECM to generate high proton fluxes with a 25 μm diameter Pt disk ultramicroelectrode (UME) positioned at a defined (known) distance from a crystal surface. The etch pits formed at various etch times were measured using white light interferometry to ascertain pit dimensions. To determine quantitative dissolution kinetics, a moving boundary finite element model was formulated in which experimental time-dependent pit expansion data formed the input for simulations, from which solution and interfacial concentrations of key chemical species, and interfacial fluxes, could then be determined and visualized. This novel analysis allowed the rate constant for proton attack on calcite, and the order of the reaction with respect to the interfacial proton concentration, to be determined unambiguously. The process was found to be first order in terms of interfacial proton concentration with a rate constant k = 6.3 (± 1.3) × 10–4 m s–1. Significantly, this value is similar to previous macroscopic rate measurements of calcite dissolution which averaged over large areas and many dislocation sites, and where such sites provided a continuous source of steps for dissolution. Since the local measurements reported herein are mainly made in regions without dislocations, this study demonstrates that dislocations and steps that arise from such sites are not needed for fast proton-promoted calcite dissolution. Other sites, such as point defects, which are naturally abundant in calcite, are likely to be key reaction sites

Design, Implementation and First Measurements with the Medipix Neutron Camera in CMS

The Medipix detector is the first device dedicated to measuring mixed-field radiation in the CMS cavern and able to distinguish between different particle types. Medipix2-MXR chips bump bonded to silicon sensors with various neutron conversion layers developed by the IEAP CTU in Prague were successfully installed for the 2008 LHC start-up in the CMS experimental and services caverns to measure the flux of various particle types, in particular neutrons. They have operated almost continuously during the 2010 run period, and the results shown here are from the proton run between the beginning of July and the end of October 2010. Clear signals are seen and different particle types have been observed during regular LHC luminosity running, and an agreement in the measured flux rate is found with the simulations. These initial results are promising, and indicate that these devices have the potential for further and future LHC and high energy physics applications as radiation monitoring devices for mixed field environments, including neutron flux monitoring. Further extensions are foreseen in the near future to increase the performance of the detector and its coverage for monitoring in CMS.Comment: 15 pages, 16 figures, submitted to JINS

Pervasive Hitchhiking at Coding and Regulatory Sites in Humans

Much effort and interest have focused on assessing the importance of natural selection, particularly positive natural selection, in shaping the human genome. Although scans for positive selection have identified candidate loci that may be associated with positive selection in humans, such scans do not indicate whether adaptation is frequent in general in humans. Studies based on the reasoning of the MacDonald–Kreitman test, which, in principle, can be used to evaluate the extent of positive selection, suggested that adaptation is detectable in the human genome but that it is less common than in Drosophila or Escherichia coli. Both positive and purifying natural selection at functional sites should affect levels and patterns of polymorphism at linked nonfunctional sites. Here, we search for these effects by analyzing patterns of neutral polymorphism in humans in relation to the rates of recombination, functional density, and functional divergence with chimpanzees. We find that the levels of neutral polymorphism are lower in the regions of lower recombination and in the regions of higher functional density or divergence. These correlations persist after controlling for the variation in GC content, density of simple repeats, selective constraint, mutation rate, and depth of sequencing coverage. We argue that these results are most plausibly explained by the effects of natural selection at functional sites—either recurrent selective sweeps or background selection—on the levels of linked neutral polymorphism. Natural selection at both coding and regulatory sites appears to affect linked neutral polymorphism, reducing neutral polymorphism by 6% genome-wide and by 11% in the gene-rich half of the human genome. These findings suggest that the effects of natural selection at linked sites cannot be ignored in the study of neutral human polymorphism