Theory of enhancement of thermoelectric properties of materials with nanoinclusions

Based on the concept of band bending at metal/semiconductor interfaces as an energy filter for electrons, we present a theory for the enhancement of the thermoelectric properties of semiconductor materials with metallic nanoinclusions. We show that the Seebeck coefficient can be significantly increased due to a strongly energy-dependent electronic scattering time. By including phonon scattering, we find that the enhancement of ZT due to electron scattering is important for high doping, while at low doping it is primarily due to a decrease in the phonon thermal conductivity

Thermoelectric enhancement in PbTe with K, Na co-doping from tuning the interaction of the light and heavy hole valence bands

The effect of K and K-Na substitution for Pb atoms in the rock salt lattice of PbTe was investigated to test a hypothesis for development of resonant states in the valence band that may enhance the thermoelectric power. We combined high temperature Hall-effect, electrical conductivity and thermal conductivity measurements to show that K-Na co-doping do not form resonance states but2 can control the energy difference of the maxima of the two primary valence sub-bands in PbTe. This leads to an enhanced interband interaction with rising temperature and a significant rise in the thermoelectric figure of merit of p-type PbTe. The experimental data can be explained by a combination of a single and two-band model for the valence band of PbTe depending on hole density that varies in the range of 1-15 x 10^19 cm^-3.Comment: 8 figure

Flight Hardware Packaging Design for Stringent EMC Radiated Emission Requirements

This packaging design approach can help heritage hardware meet a flight project's stringent EMC radiated emissions requirement. The approach requires only minor modifications to a hardware's chassis and mainly concentrates on its connector interfaces. The solution is to raise the surface area where the connector is mounted by a few millimeters using a pedestal, and then wrapping with conductive tape from the cable backshell down to the surface-mounted connector. This design approach has been applied to JPL flight project subsystems. The EMC radiated emissions requirements for flight projects can vary from benign to mission critical. If the project's EMC requirements are stringent, the best approach to meet EMC requirements would be to design an EMC control program for the project early on and implement EMC design techniques starting with the circuit board layout. This is the ideal scenario for hardware that is built from scratch. Implementation of EMC radiated emissions mitigation techniques can mature as the design progresses, with minimal impact to the design cycle. The real challenge exists for hardware that is planned to be flown following a built-to-print approach, in which heritage hardware from a past project with a different set of requirements is expected to perform satisfactorily for a new project. With acceptance of heritage, the design would already be established (circuit board layout and components have already been pre-determined), and hence any radiated emissions mitigation techniques would only be applicable at the packaging level. The key is to take a heritage design with its known radiated emissions spectrum and repackage, or modify its chassis design so that it would have a better chance of meeting the new project s radiated emissions requirements

Heat Capacity of PbS: Isotope Effects

In recent years, the availability of highly pure stable isotopes has made possible the investigation of the dependence of the physical properties of crystals, in particular semiconductors, on their isotopic composition. Following the investigation of the specific heat ($C_p$, $C_v$) of monatomic crystals such as diamond, silicon, and germanium, similar investigations have been undertaken for the tetrahedral diatomic systems ZnO and GaN (wurtzite structure), for which the effect of the mass of the cation differs from that of the anion. In this article we present measurements for a semiconductor with rock salt structure, namely lead sulfide. Because of the large difference in the atomic mass of both constituents ($M_{\rm Pb}$= 207.21 and ($M_{\rm S}$=32.06 a.m.u., for the natural isotopic abundance) the effects of varying the cation and that of the anion mass are very different for this canonical semiconductor. We compare the measured temperature dependence of $C_p \approx C_v$, and the corresponding derivatives with respect to ($M_{\rm Pb}$ and $M_{\rm S}$), with \textit{\textit{ab initio}} calculations based on the lattice dynamics obtained from the local density approximation (LDA) electronic band structure. Quantitative deviations between theory and experiment are attributed to the absence of spin-orbit interaction in the ABINIT program used for the electronic band structure calculations.Comment: 17 pages including 10 Fig

Disorder suppression and precise conductance quantization in constrictions of PbTe quantum wells

Conductance quantization was measured in submicron constrictions of PbTe, patterned into narrow,12 nm wide quantum wells deposited between Pb$_{0.92}$Eu$_{0.08}$Te barriers. Because the quantum confinement imposed by the barriers is much stronger than the lateral one, the one-dimensional electron energy level structure is very similar to that usually met in constrictions of AlGaAs/GaAs heterostructures. However, in contrast to any other system studied so far, we observe precise conductance quantization in $2e^2/h$ units, {\it despite of significant amount of charged defects in the vicinity of the constriction}. We show that such extraordinary results is a consequence of the paraelectric properties of PbTe, namely, the suppression of long-range tails of the Coulomb potentials due to the huge dielectric constant.Comment: 7 pages, 6 figures, submitted to Phys. Rev.

Band-Gap Nonlinearity in Lead Chalcogenide (PbQ, Q = Te, Se, S) Alloys

Narrow band-gap lead chalcogenides have been developed for several optical and electronic applications. However, band-gap energies of the ternary and quaternary alloys have received little attention compared with the parent binary phases. Here, we have fabricated single-phase ternary (PbTe)1−x(PbSe)x and quaternary (PbTe)0.9−y(PbSe)0.1(PbS)y and (PbTe)0.65−z(PbSe)0.35(PbS)z alloys and shown that although lattice parameters follow Vegard’s law as a function of composition, the bandgap energies exhibit a substantial bowing effect. The ternary (PbTe)1−x(PbSe)x system features a smaller bowing parameter predominantly due to the difference in electronegativity between Se and Te, whereas the larger bowing parameters in quaternary alloys are generated from a larger crystal lattice mismatch and larger miscibility gap. These findings can lead to further advances in tuning the band-gap and lattice parameters for optical and electronic applications of lead chalcogenides

A Neptune Orbiter Concept Using Drag Modulated Aerocaptue (DMA) and the Adaptable, Deployable Entry and Placement Technology (ADEPT)

Conceptual Neptune orbiter was designed for the purpose of assessing mission feasibilityBuilt off of the 2017 Pre-Decadal Study, but adapted for drag modulation aerocapture.Science payload includes: Narrow Angle camera, Doppler Imager, Magnetometer, Atmospheric Probe (w/ ASI, Nephelometer, Mass Spectrometer). Baseline concept of operations releases probe prior to orbit insertion, but investigations are ongoing to assess the feasibility of bringing the probe to orbit before release

Granular cell tumors of the urinary bladder

BACKGROUND: Granular cell tumors (GCTs) are extremely rare lesions of the urinary bladder with only nine cases being reported in world literature of which one was malignant. Generally believed to be of neural origin based on histochemical, immunohistochemical, and ultrastructural studies; they mostly follow a clinically benign course but are commonly mistaken for malignant tumors since they are solid looking, ulcerated tumors with ill-defined margins. MATERIALS AND METHODS: We herein report two cases of GCTs, one benign and one malignant, presenting with gross hematuria in a 14- and a 47-year-old female, respectively. RESULTS: Histopathology revealed characteristic GCTs with positive immunostaining for neural marker (S-100) and negative immunostaining for epithelial (cytokeratin, Cam 5.2, AE/A13), neuroendocrine (neuron specific enolase, chromogranin A, and synaptophysin) and sarcoma (desmin, vimentin) markers. The benign tumor was successfully managed conservatively with transurethral resection alone while for the malignant tumor, radical cystectomy, hysterectomy with bilateral salpingo-oophorectomy, anterior vaginectomy, plus lymph node dissection was done. Both cases show long-term disease free survival. CONCLUSION: We recommend careful pathologic assessment for establishing the appropriate diagnosis and either a conservative or aggressive surgical treatment for benign or localized malignant GCT of the urinary bladder, respectively

Liberalization, globalization and the dynamics of democracy in India

In the closing decades of the twentieth century there has been an almost complete intellectual triumph of the twin principles of marketization (understood here as referring to the liberalization of domestic markets and freer international mobility of goods, services, financial capital and perhaps, more arguably, labour) and democratization . A paradigm shift of this extent and magnitude would not have occurred in the absence of some broad consensus among policymakers and (sections of) intellectuals around the globe on the desirability of such a change. There seems to be a two-fold causal nexus between marketization and democracy. The first is more direct, stemming from the fact of both systems sharing certain values and attitudes in common. But there is also a second more indirect chain from marketization to democracy, which is predicated via three sub-chains (i) from marketization to growth, (ii) from growth to overall material development welfare and (iii) from material development to social welfare and democracy. We examine each of these sub-links in detail with a view to obtaining a greater understanding of the hypothesized role of free markets in promoting democracies. In the later part of the paper we examine the socio-economic outcomes governing the quality of democracy in a specifically Indian context