68 research outputs found
Microwave stray radiation losses in vacuum windows
Vacuum windows are required in magnetically confined fusion experiments to provide possibilities to observe the plasma in a wide range of electromagnetic wavelengths. The window disk consists of a dielectric, e.g. Fused Silica (SiO), Sapphire or Chemically Vapourised Diamond (CVD). As electromagnetic waves pass through the disk, a fraction of the beam power is dissipated resulting in a temperature increase of the disk. In Electron Cyclotron Waves (ECW) heated plasmas the dissipation in the window disk can be very high. The computation of dielectric losses for a collimated beam with known incidence angle, polarisation and loss tangent (measure for the intrinsic dielectric loss) is well established. However, the dielectric losses in diagnostic windows mostly result from microwave stray radiation, which results from a modest, but inevitable, fraction of non-absorbed ECW. This fraction diffuses in the vessel by many reflections into rays with random k-vector and with random polarisation. In this work the thermal load on the window disk by microwave stray radiation is assessed. The load by a collimated beam is studied as a function of incidence angle and polarisation allowing to average over a distribution of incident rays. An experiment was commissioned measuring the loss tangent of a number of commercially available SiO disks at low power in an open resonator, and subsequently measuring the dielectric heating of these disks at high power stray radiation using the facility ’MISTRAL’ at Wendelstein-7X. The experimental results are compared to modelling and it is demonstrated that, in the parameter range considered, single-pass fractional absorption may be applied while taking a safety margin that arises from the minima and maxima due to multiple reflections
Short-pulse frequency stabilization of a MW-class ECRH gyrotron at W7-X for CTS diagnostic
At the Wendelstein 7-X stellarator, a 174 GHz Collective Thomson Scattering (CTS) diagnostic will be implemented. One of the 140 GHz Electron Cyclotron Resonance Heating (ECRH) gyrotrons will be operated at around 174 GHz in a higher cavity mode, using it as source for the CTS mm-wave probing beam. To prevent any damage to the CTS receiver, a notch filter cuts out the high-power gyrotron signal at the entrance of the receiver. The bandwidth of the gyrotron signal determines the notch filter bandwidth. First proof-of-principle experiments on frequency stabilization were conducted on W7-X ECRH gyrotrons employing Phase-Locked Loop techniques. The gyrotron output frequency was controlled with the accelerating voltage, which is applied between the anode and cathode of the gyrotron diode-type Magnetron Injection Gun. Frequency stabilization experiments with 10 ms pulses were conducted at the gyrotron nominal frequency of 140 GHz as well as at 174 GHz. It is concluded that the gyrotron frequency could be stabilized for at least 3 ms at 140 GHz and 8 ms at 174 GHz. In the frequency spectrum, a clear main peak of the gyrotron frequency at 140 GHz with a full -15 dB linewidth of below 500 Hz was achieved
Nuclear Fusion (FUSION): Plasma Heating Systems – Microwave Plasma Heating & Current Drive Systems
Nuclear Fusion (FUSION): Plasma Heating Systems -Microwave Plasma Heating & Current Drive System
The Role of Information Provision in Economic Evaluations of Newborn Bloodspot Screening: A Systematic Review
Skin Lesions on Common Bottlenose Dolphins (Tursiops truncatus) from Three Sites in the Northwest Atlantic, USA
Skin disease occurs frequently in many cetacean species across the globe; methods to categorize lesions have relied on photo-identification (photo-id), stranding, and by-catch data. The current study used photo-id data from four sampling months during 2009 to estimate skin lesion prevalence and type occurring on bottlenose dolphins (Tursiops truncatus) from three sites along the southeast United States coast [Sarasota Bay, FL (SSB); near Brunswick and Sapelo Island, GA (BSG); and near Charleston, SC (CHS)]. The prevalence of lesions was highest among BSG dolphins (P = 0.587) and lowest in SSB (P = 0.380), and the overall prevalence was significantly different among all sites (p<0.0167). Logistic regression modeling revealed a significant reduction in the odds of lesion occurrence for increasing water temperatures (OR = 0.92; 95%CI:0.906–0.938) and a significantly increased odds of lesion occurrence for BSG dolphins (OR = 1.39; 95%CI:1.203–1.614). Approximately one-third of the lesioned dolphins from each site presented with multiple types, and population differences in lesion type occurrence were observed (p<0.05). Lesions on stranded dolphins were sampled to determine the etiology of different lesion types, which included three visually distinct samples positive for herpesvirus. Although generally considered non-fatal, skin disease may be indicative of animal health or exposure to anthropogenic or environmental threats, and photo-id data provide an efficient and cost-effective approach to document the occurrence of skin lesions in free-ranging populations
- …