2,263 research outputs found
An investigation of the beneficial effects of adding carbon nanotubes to standard injection grout
Mortar grouting is often used in masonry constructions to mitigate structural decay and repair damage by filling cracks and voids, resulting in an improvement in mechanical properties. This paper presents an original experimental investigation on grout with added carbon nanotubes (CNTs). The samples were prepared with different percentages of CNTs, up to 1.2 wt% with respect to the binder, and underwent three‐point bending tests in crack mouth opening displacement mode and compressive tests. The results showed that very small additions (up to 0.12 wt% of CNTs) increased not only flexural and compressive strengths (+73% and 35%, respectively, in comparison with plain mortar) but also fracture energy (+80%). These results can be explained on the basis of a reduction in porosity, as evidenced by mercury intrusion porosimetry, as well as by a crack bridging mechanism and by the probable formation of nucleation sites for hydration products, as observed through scanning electron microscopy
A new modulation technique for high data rate low power UWB wireless optical communication in implantable biotelemetry systems
We report on the development of a novel modulation technique for UWB wireless optical communication systems for application in a transcutaneous biotelemetry. The solution, based on the generation of short laser pulses, allows for a high data rate link whilst achieving a significant power reduction (energy per bit) compared to the state-of-the-art. These features make this particularly suitable for emerging biomedical applications such as implantable neural/biosensor systems. The relatively simple architecture consists of a transmitter and receiver that can be integrated in a standard CMOS technology in a compact Silicon footprint. These parts include circuits for bias and drive current generation, conditioning and processing, optimised for low-volt age/low-power operation. Preliminary experimental findings validate the new paradigm and show good agreement with expected results. The complete system achieves a BER less than 10-7, with maximum data rate of 125Mbps and estimated total power consumption of less than 3mW
Where Fail-Safe Default Logics Fail
Reiter's original definition of default logic allows for the application of a
default that contradicts a previously applied one. We call failure this
condition. The possibility of generating failures has been in the past
considered as a semantical problem, and variants have been proposed to solve
it. We show that it is instead a computational feature that is needed to encode
some domains into default logic
Experimental Analysis of Heat Transfer in Passive Latent Heat Thermal Energy Storage Systems for CSP Plants
Abstract Thermal energy storage is a key factor for efficiency, dispatchability and economic sustainability of concentrated solar plants. The latent heat storage systems could ensure a significant reduction in construction costs and environmental impact, because of its high storage energy density. In LHTES, the heat transfer between the heat transfer fluid and the storage system is strongly limited by the reduced thermal conductivity of the storage media. For operating temperatures between 200 and 600 °C, the most used storage media are salts. In order to evaluate solutions which promote the thermal conductivity, by increasing the exchange surface and/or the addition of nanoparticles to the storage media, Enea set up a small facility to test some storage concepts. In this facility, a diathermic oil flows through three elementary "shell-and-tube" storage systems, connected in series, reaching a maximum temperature of about 280 °C. The elementary storage systems are filled with a mixture of sodium and potassium nitrates salts, which melt at about 225 °C. Moreover a small percentage of alumina and silica nanoparticles were added to this mixture. The results of the experiments show an increase of the thermal diffusivity of the medium not only for the presence of fins on the heat transfer tubes but also because of convective flows within the melted fraction were established. These phenomena strongly reduce the charging times of the system (by about 30%). Instead, the presence of nanoparticles increases the thermal capacity and the thermal conductivity of the storage system but seems not to have a relevant effect on the thermal diffusivity of the mixture. This behavior depends on the type of used nanoparticles, which can significantly change over time some characteristics of the storage medium, in which they are dispersed, leaving other characteristics unchanged, according to mechanisms which are still to be well understood
Integration of ground-penetrating radar, ultrasonic tests and infrared thermography for the analysis of a precious medieval rose window
Abstract. The integration of high-resolution, non-invasive geophysical techniques (such as ground-penetrating radar or GPR) with emerging sensing techniques (acoustics, thermography) can complement limited destructive tests to provide a suitable methodology for a multi-scale assessment of the state of preservation, material and construction components of monuments. This paper presents the results of the application of GPR, infrared thermography (IRT) and ultrasonic tests to the 13th century rose window of Troia Cathedral (Apulia, Italy), affected by widespread decay and instability problems caused by the 1731 earthquake and reactivated by recent seismic activity. This integrated approach provided a wide amount of complementary information at different scales, ranging from the sub-centimetre size of the metallic joints between the various architectural elements, narrow fractures and thin mortar fillings, up to the sub-metre scale of the internal masonry structure of the circular ashlar curb linking the rose window to the façade, which was essential to understand the original building technique and to design an effective restoration strategy
Pseudozyma aphidis bloodstream infection in a patient with aggressive lymphoma and a history of intravenous drug use: Case report and review of the literature
Pseudozyma aphidis is an environmental fungus which causes opportunistic infections in immunocompromised patients. Here we report the case of a 54-year-old, intravenous drug user woman, newly diagnosed to have an aggressive lymphoma, who developed a bloodstream infection caused by P. aphidis treated successfully with amphotericin-B therapy. The precise identification was assessed by sequencing. We propose to consider intravenous drug use as a risk factor for invasive infections due to this environmental yeast
Compilability of Abduction
Abduction is one of the most important forms of reasoning; it has been
successfully applied to several practical problems such as diagnosis. In this
paper we investigate whether the computational complexity of abduction can be
reduced by an appropriate use of preprocessing. This is motivated by the fact
that part of the data of the problem (namely, the set of all possible
assumptions and the theory relating assumptions and manifestations) are often
known before the rest of the problem. In this paper, we show some complexity
results about abduction when compilation is allowed
From byproduct to resource: Fermented apple pomace as beer flavoring
One of the main struggles of the large-scale apple processing industry is pomace disposal. One solution for this problem is to convert this waste into a resource. Apple pomace could be used as a substrate for lactic acid bacteria and could induce the formation of a more complex aroma profile, making this fermented product an innovative aromatizer for alcoholic beverages, such as beer. In this study, for the first time, the effect of lacto-fermented apple pomace addition in beer was evaluated. Three bacterial strains (Lactobacillus rhamnosus 1473 and 1019, and L. casei 2246) were tested for apple pomace fermentation, and L. rhamnosus 1473 was the strain that best modified the aromatic profile. The addition of fermented apple pomace to beer increased the complexity of the aroma profile, demonstrating the potential of this byproduct as an aromatizer in the alcoholic beverage industry
- …