The mechanism of adapting RED parameters to TCP traffic

Random Early Detection (RED) can stabilize the queue within a given target range and thus achieve high throughput in the routers. However, the average queue size is quite sensitive to network scenarios and it is difficult to adapt RED parameters to changing network traffic. In this paper we use a previously developed dynamic model of TCP behavior and linear feedback model of TCP/RED to analyze and design a mechanism for RED parameter tuning in response to changing network conditions like traffic load, link capacity and round-trip time. Even though the values of four key RED parameters are determined by varying network conditions, they can be tuned independently without consideration of the interactions among these RED parameters. Simulation results show that this mechanism can stabilize the queue and maintain high link utilization in a wide variety of network conditions

Modeling the interaction between TCP and Rate Adaptation

In this paper, we model and investigate the interaction between the TCP protocol and rate adaptation at intermediate routers. Rate adaptation aims at saving energy by controlling the offered capacity of links and adapting it to the amount of traffic. However, when TCP is used at the transport layer, the control loop of rate adaptation and one of the TCP congestion control mechanism might interact and disturb each other, compromising throughput and Quality of Service (QoS). Our investigation is lead through mathematical modeling consisting in depicting the behavior of TCP and of rate adaption through a set of Delay Differential Equations (DDEs). The model is validated against simulation results and it is shown to be accurate. The results of the sensitivity analysis of the system performance to control parameters show that rate adaptation can be effective but a careful parameter setting is needed to avoid undesired disruptive interaction among controllers at different levels, that impair QoS

Parameter self-tuning in internet congestion control

Active Queue Management (AQM) aims to achieve high link utilization, low queuing delay and low loss rate in routers. However, it is difficult to adapt AQM parameters to constantly provide desirable transient and steady-state performance under highly dynamic network scenarios. They need to be a trade-off made between queuing delay and utilization. The queue size would become unstable when round-trip time or link capacity increases, or would be unnecessarily large when round-trip time or link capacity decreases. Effective ways of adapting AQM parameters to obtain good performance have remained a critical unsolved problem during the last fifteen years. This thesis firstly investigates existing AQM algorithms and their performance. Based on a previously developed dynamic model of TCP behaviour and a linear feedback model of TCP/RED, Auto-Parameterization RED (AP-RED) is proposed which unveils the mechanism of adapting RED parameters according to measurable network conditions. Another algorithm of Statistical Tuning RED (ST-RED) is developed for systematically tuning four key RED parameters to control the local stability in response to the detected change in the variance of the queue size. Under variable network scenarios like round-trip time, link capacity and traffic load, no manual parameter configuration is needed. The proposed ST-RED can adjust corresponding parameters rapidly to maintain stable performance and keep queuing delay as low as possible. Thus the sensitivity of RED's performance to different network scenarios is removed. This Statistical Tuning algorithm can be applied to a PI controller for AQM and a Statistical Tuning PI (ST-PI) controller is also developed. The implementation of ST-RED and ST-PI is relatively straightforward. Simulation results demonstrate the feasibility of ST-RED and ST-PI and their capabilities to provide desirable transient and steady-state performance under extensively varying network conditions.EThOS - Electronic Theses Online ServiceGBUnited Kingdo

Dynamic weight parameter for the Random Early Detection (RED) in TCP networks

This paper presents the Weighted Random Early Detection (WTRED) strategy for congestion handling in TCP networks. WTRED provides an adjustable weight parameter to increase the sensitivity of the average queue size in RED gateways to the changes in the actual queue size. This modification, over the original RED proposal, helps gateways minimize the mismatch between average and actual queue sizes in router buffers. WTRED is compared with RED and FRED strategies using the NS-2 simulator. The results suggest that WTRED outperforms RED and FRED. Network performance has been measured using throughput, link utilization, packet loss and delay

Implementation of Provably Stable MaxNet

MaxNet TCP is a congestion control protocol that uses explicit multi-bit signalling from routers to achieve desirable properties such as high throughput and low latency. In this paper we present an implementation of an extended version of MaxNet. Our contributions are threefold. First, we extend the original algorithm to give both provable stability and rate fairness. Second, we introduce the MaxStart algorithm which allows new MaxNet connections to reach their fair rates quickly. Third, we provide a Linux kernel implementation of the protocol. With no overhead but 24-bit price signals, our implementation scales from 32 bit/s to 1 peta-bit/s with a 0.001% rate accuracy. We confirm the theoretically predicted properties by performing a range of experiments at speeds up to 1 Gbit/sec and delays up to 180 ms on the WAN-in-Lab facility

DTMsim - DTM channel simulation in ns

Dynamic Transfer Mode (DTM) is a ring based MAN technology that provides a channel abstraction with a dynamically adjustable capacity. TCP is a reliable end to end transport protocol capable of adjusting its rate. The primary goal of this work is investigate the coupling of dynamically allocating bandwidth to TCP flows with the affect this has on the congestion control mechanism of TCP. In particular we wanted to find scenerios where this scheme does not work, where either all the link capacity is allocated to TCP or congestion collapse occurs and no capacity is allocated to TCP. We have created a simulation environment using ns-2 to investigate TCP over networks which have a variable capacity link. We begin with a single TCP Tahoe flow over a fixed bandwidth link and progressively add more complexity to understand the behaviour of dynamically adjusting link capacity to TCP and vice versa