18 research outputs found

    Compressive sampling based differential detection for UWB impulse radio signals

    Get PDF
    Noncoherent detectors significantly contribute to the practical realization of the ultra-wideband (UWB) impulse-radio (IR) concept, in that they allow avoiding channel estimation and provide highly efficient reception capabilities. Complexity can be reduced even further by resorting to an all-digital implementation, but Nyquist-rate sampling of the received signal is still required. The current paper addresses this issue by proposing a novel differential detection (DD) scheme, which exploits the compressive sampling (CS) framework to reduce the sampling rate much below the Nyquist-rate. The optimization problem is formulated to jointly recover the sparse received signal as well as the differentially encoded data symbols, and is compared with both the separate approach and the scheme using the compressed received signal directly, i.e., without reconstruction. Finally, a maximum a posteriori based detector using the compressed symbols is developed for a Laplacian distributed channel, as a reference to compare the performance of the proposed approaches. Simulation results show that the proposed joint CS-based DD brings the considerable advantage of reducing the sampling rate without degrading the performance, compared with the optimal MAP detector

    Performance analysis of the parallel acquisition of weak GPS signals

    Get PDF
    This thesis provides a comprehensive analysis of the acquisition performance of the mobile-embedded Global Positioning System (GPS) receiver. Particular emphasis is given to the analysis of differentially coherent processing techniques and parallel acquisition strategies. New analytical expressions for the distribution of the decision variable of differentially coherent detectors are derived. In addition, new Gaussian approximations are derived and shown to be more accurate than existing approximations. Using these Gaussian approximations it is demonstrated that the traditional noncoherent combining detector is the best choice when the signal to noise ratio is large, but that differentially coherent combining is a superior choice at low signal to noise ratios. An analysis of the effects of carrier Doppler, code Doppler and data modulation on detector performance is also conducted. For the noncoherent combining detector, new expressions are obtained for the mean and worst case power attenuation due to the combined effects of carrier Doppler and data modulation. Approximate expressions are also derived for the differentially coherent combining detector. New expressions are also obtained for the mean and variance of the time to first hit using a Markov chain model and matrix methods. These models permit the use of numerical techniques to determine the optimal choice of receiver parameters for a given performance requirement. Finally the effect of unknown power levels and multi-access interference (MAI) are considered. A novel technique for detecting MAI, referred to as the power level detector, is introduced and its performance analysed. All results are verified by Monte Carlo computer simulation using a simplified signal model. The simulations were implemented on a 100 processor computer cluster

    Design of large polyphase filters in the Quadratic Residue Number System

    Full text link

    Temperature aware power optimization for multicore floating-point units

    Full text link

    Multibeam radar system based on waveform diversity for RF seeker applications

    Get PDF
    Existing radiofrequency (RF) seekers use mechanically steerable antennas. In order to improve the robustness and performance of the missile seeker, current research is investigating the replacement of mechanical 2D antennas with active electronically controlled 3D antenna arrays capable of steering much faster and more accurately than existing solutions. 3D antenna arrays provide increased radar coverage, as a result of the conformal shape and flexible beam steering in all directions. Therefore, additional degrees of freedom can be exploited to develop a multifunctional seeker, a very sophisticated sensor that can perform multiple simultaneous tasks and meet spectral allocation requirements. This thesis presents a novel radar configuration, named multibeam radar (MBR), to generate multiple beams in transmission by means of waveform diversity. MBR systems based on waveform diversity require a set of orthogonal waveforms in order to generate multiple channels in transmission and extract them efficiently at the receiver with digital signal processing. The advantage is that MBR transmit differently designed waveforms in arbitrary directions so that waveforms can be selected to provide multiple radar functions and better manage the available resources. An analytical model of an MBR is derived to analyse the relationship between individual channels and their performance in terms of isolation and phase steering effects. Combinations of linear frequency modulated (LFM) waveforms are investigated and the analytical expressions of the isolation between adjacent channels are presented for rectangular and Gaussian amplitude modulated LFM signals with different bandwidths, slopes and frequency offsets. The theoretical results have been tested experimentally to corroborate the isolation properties of the proposed waveforms. In addition, the practical feasibility of the MBR concept has been proved with a radar test bed with two orthogonal channels simultaneously detecting a moving target

    Recent Advances in Wireless Communications and Networks

    Get PDF
    This book focuses on the current hottest issues from the lowest layers to the upper layers of wireless communication networks and provides "real-time" research progress on these issues. The authors have made every effort to systematically organize the information on these topics to make it easily accessible to readers of any level. This book also maintains the balance between current research results and their theoretical support. In this book, a variety of novel techniques in wireless communications and networks are investigated. The authors attempt to present these topics in detail. Insightful and reader-friendly descriptions are presented to nourish readers of any level, from practicing and knowledgeable communication engineers to beginning or professional researchers. All interested readers can easily find noteworthy materials in much greater detail than in previous publications and in the references cited in these chapters

    Abstracts on Radio Direction Finding (1899 - 1995)

    Get PDF
    The files on this record represent the various databases that originally composed the CD-ROM issue of "Abstracts on Radio Direction Finding" database, which is now part of the Dudley Knox Library's Abstracts and Selected Full Text Documents on Radio Direction Finding (1899 - 1995) Collection. (See Calhoun record https://calhoun.nps.edu/handle/10945/57364 for further information on this collection and the bibliography). Due to issues of technological obsolescence preventing current and future audiences from accessing the bibliography, DKL exported and converted into the three files on this record the various databases contained in the CD-ROM. The contents of these files are: 1) RDFA_CompleteBibliography_xls.zip [RDFA_CompleteBibliography.xls: Metadata for the complete bibliography, in Excel 97-2003 Workbook format; RDFA_Glossary.xls: Glossary of terms, in Excel 97-2003 Workbookformat; RDFA_Biographies.xls: Biographies of leading figures, in Excel 97-2003 Workbook format]; 2) RDFA_CompleteBibliography_csv.zip [RDFA_CompleteBibliography.TXT: Metadata for the complete bibliography, in CSV format; RDFA_Glossary.TXT: Glossary of terms, in CSV format; RDFA_Biographies.TXT: Biographies of leading figures, in CSV format]; 3) RDFA_CompleteBibliography.pdf: A human readable display of the bibliographic data, as a means of double-checking any possible deviations due to conversion
    corecore