IETF standardization in the field of the Internet of Things (IoT): a survey

Smart embedded objects will become an important part of what is called the Internet of Things. However, the integration of embedded devices into the Internet introduces several challenges, since many of the existing Internet technologies and protocols were not designed for this class of devices. In the past few years, there have been many efforts to enable the extension of Internet technologies to constrained devices. Initially, this resulted in proprietary protocols and architectures. Later, the integration of constrained devices into the Internet was embraced by IETF, moving towards standardized IP-based protocols. In this paper, we will briefly review the history of integrating constrained devices into the Internet, followed by an extensive overview of IETF standardization work in the 6LoWPAN, ROLL and CoRE working groups. This is complemented with a broad overview of related research results that illustrate how this work can be extended or used to tackle other problems and with a discussion on open issues and challenges. As such the aim of this paper is twofold: apart from giving readers solid insights in IETF standardization work on the Internet of Things, it also aims to encourage readers to further explore the world of Internet-connected objects, pointing to future research opportunities

A Test Bed for Evaluating the Performance of IoT Networks

The use of smaller, personal IoT networks has increased over the past several years. These devices demand a lot of resources but only have limited access. To establish and sustain a flexible network connection, 6LoWPAN with RPL protocol is commonly used. While RPL provides a low-cost solution for connection, it lacks load balancing mechanisms. Improvements in OF load balancing can be implemented to strengthen network stability. This paper proposes a test bed configuration to show the toll of frequent parent switching on 6LoWPAN. Contiki’s RPL 6LoWPAN software runs on STM32 Nucleo microcontrollers with expansion boards for this test bed. The configuration tests frequency of parent changes and packet loss to demonstrate network instability of different RPL OFs. Tests on MRHOF for RPL were executed to confirm the working configuration. Results, with troubleshooting and improvements, show a working bed. The laid-out configuration provides a means for testing network stability in IoT networks

A Lesson in Scaling 6LoWPAN -- Minimal Fragment Forwarding in Lossy Networks

This paper evaluates two forwarding strategies for fragmented datagrams in the IoT: hop-wise reassembly and a minimal approach to directly forward fragments. Minimal fragment forwarding is challenged by the lack of forwarding information at subsequent fragments in 6LoWPAN and thus requires additional data at nodes. We compared the two approaches in extensive experiments evaluating reliability, end-to-end latency, and memory consumption. In contrast to previous work and due to our alternate setup, we obtained different results and conclusions. Our findings indicate that direct fragment forwarding should be deployed only with care, since higher packet transmission rates on the link-layer can significantly reduce its reliability, which in turn can even further reduce end-to-end latency because of highly increased link-layer retransmissions.Comment: If you cite this paper, please use the LCN reference: M. S. Lenders, T. C. Schmidt, M. W\"ahlisch. "A Lesson in Scaling 6LoWPAN - Minimal Fragment Forwarding in Lossy Networks." in Proc. of IEEE LCN, 201