Blind reception of multicarrier DS-CDMA using antenna arrays

Published versio

Enhanced MDIR receiver for space-time dispersive channels

A particular property of the matched desired impulse response receiver is introduced in this paper, namely, the fact that full exploitation of the diversity is obtained with multiple beamformers when the channel is spatially and timely dispersive. This particularity makes the receiver specially suitable for mobile and underwater communications. The new structure provides better performance than conventional and weighted VRAKE receivers, and a diversity gain with no needs of additional radio frequency equipment. The baseband hardware needed for this new receiver may be obtained through reconfigurability of the RAKE architectures available at the base station. The proposed receiver is tested through simulations assuming UTRA frequency-division-duplexing mode.Peer Reviewe

Advanced receivers for high data rate mobile communications

Improving the spectral efficiency is a key issue in the future wireless communication systems since the spectrum is a scarce resource. Both the number of users as well the demanded data rates are increasing all the time. Furthermore, in mobile communications the wireless link is required to be reliable even when the mobile is in a fast moving vehicle. Using Multiple-Input Multiple-Output (MIMO) antennas is a well known technique to provide higher spectral efficiency as well as better link reliability. Additionally, higher order modulation methods can be used to provide higher data rates. In order to benefit from these enhancements in practise, sophisticated signal processing methods as well as accurate estimates of time-varying wireless channel parameters are needed. This thesis addresses the problem of designing multi-antenna receivers in high data rate systems. The case of multiple transmit antennas is also considered. System specific features of High Speed Downlink Packet Access (HSDPA) which is part of 3rd generation (3G) Wideband Code Division Multiple Access (WCDMA) evolution are exploited in channel estimation methods and in MIMO receiver design. Additionally, complexity reduction methods for Minimum Mean Square Error (MMSE) equalization are addressed. Blind channel estimation methods are spectrally efficient, since no extra resources are needed for pilot signals. However, in mobile communications accurate estimates are needed also in fast fading channels. Consequently, semi-blind channel estimation methods where the receiver combines blind and pilot based channel estimation are an appealing alternative. In this thesis blind and semi-blind channel estimation methods based on knowledge of multiple spreading codes are derived. A novel semi-blind combining scheme for code multiplexed pilot signal and blind estimation is proposed. Another important factor in receiver design criteria is the structure of interference in the received signals. Interference mitigation techniques in MIMO systems have been shown to be potential methods for providing improved performance. A chip level inter-antenna interference cancellation method has been developed in this thesis for HSDPA. Furthermore, this multi-stage ordered interference canceler is combined with the semi-blind channel estimation scheme to enhance the system performance further.Langattomassa tiedonsiirrossa radiospektrin tehokas käyttö on tulevaisuuden suuria haasteita. Taajuuksia on käytössä vain rajoitetusti, kun taas käyttäjien määrä sekä vaaditut siirtonopeudet kasvavat jatkuvasti. Lisäksi langattomien yhteyksien on toimittava luotettavasti myös nopeasti liikkuvissa kulkuneuvoissa. Moniantennijärjestelmät, joissa on useita antenneita sekä tukiasemissa että päätelaitteissa mahdollistavat radiospektrin tehokkaamman käytön sekä parantavat yhteyksien laatua. Tiedonsiirtonopeutta voidaan myös kasvattaa erilaisilla modulaatiotekniikoilla. Hyötyjen saavutamiseksi käytännössä tarvitaan sekä kehittyneitä vastaanotinrakenteita että tarkkoja estimaatteja aikamuuttuvasta radiokanavasta. Tässä työssä on kehitetty vastaanotinrakenteita ja kanavan estimointimenetelmiä kolmannen sukupolven (3G) nopeiden datayhteyksien (HSPA) järjestelmissä. Työssä on johdettu menetelmiä, jotka hyödyntävät HSPA järjestelmien erikoispiirteitä tehokkaasti. Lisäksi on kehitetty laskennallisesti tehokkaita menetelmiä vastaanottimien signaalinkäsittelyyn. Ns. sokeat menetelmät mahdollistavat taajuuskaistan tehokkaan käytön, koska ne eivät vaadi tunnettuja harjoitussignaaleja. Mobiileissa tietolikennejärjestelmissä radiokanava saattaa kuitenkin muuttua hyvin nopeasti, jonka vuoksi kanavan estimoinnissa on tyypillisesti hyödynnetty tunnettua pilottisignaalia. Yhdistämällä pilottipohjainen ja sokea kanavaestimointimenetelmä, voidaan saavuttaa molempien menetelmien edut. Tässä työssä kehitettiin sokeita kanavaestimointimenetelmiä, jotka hyödyntävät useita tunnettuja hajoituskoodeja. Sokean ja koodijakoiseen pilottisignaaliin pohjautuvien kanavan estimaattien yhdistämiseksi kehitettiin uusi menetelmä. Signaalin laatua ja siten vastaanottimen suorituskykyä voidaan langattomissa järjestelmissä parantaa vaimentamalla interferenssiä eli häiriöitä. Vastaanottimen toimintaa voidaan tehostaa oleellisesti, jos häiriösignaalin rakenne tunnetaan. Käytettäessä useampaa lähetysantennia HSPA järjestelmissä vastaanotetussa signaalissa olevia häiriötä voidaan kumota usealla eri tasolla. Tässä työssä on kehitetty chippitasolla häiriöitä kumoava vastaanotinrakenne, joka hyödyntää HSPA järjestelmän ominaisuuksia. Vastaanottimen suorituskykyä on edelleen parannettu yhdistämällä se aiemmin esitettyyn puolisokeaan kanavan estimointimenetelmään.reviewe

Space time transceiver design over multipath fading channels

Imperial Users onl

Intercarrier Interference Suppression for the OFDM Systems in Time-Varying Multipath Fading Channels

Due to its spectral efficiency and robustness over the multipath channels, orthogonal frequency division multiplexing (OFDM) has served as one of the major modulation schemes for the modern communication systems. In the future, the wireless OFDM systems are expected to operate at high carrier-frequencies, high speed and high throughput mobile reception, where the fasting time-varying fading channels are encountered. The channel variation destroys the orthogonality among the subcarriers and leads to the intercarrier interference (ICI). ICI poses a significant limitation to the wireless OFDM systems. The aim of this dissertation is to find an efficient method of providing reliable communication using OFDM in the fast time-varying fading channel scenarios. First, we investigate the OFDM performance in the situation of time-varying mobile channels in the presence of multiple Doppler frequency shifts. A new mathematical framework of the ICI effect is derived. The simulation results show that ICI induces an irreducible error probability floor, which in proportional to the Doppler frequency shifts. Furthermore, it is observed that ICI power arises from a few adjacent subcarriers. This observation motivates us to design the low-complexity Q-tap equalizers, namely, Minimum Mean Square Error (MMSE) linear equalizer and Decision Feedback (DF) non-linear equalizer to mitigate the ICI. Simulation results show that both Q-tap equalizers can improve the system performance in the sense of symbol error rate (SER). To employ these equalizers, the channel state information is also required. In this dissertation, we also design a pilot-aided channel estimation via Wiener filtering for a time-varying Wide-sense Stationary Uncorrelated Scatterers (WSSUS) channel model. The channel estimator utilizes that channel statistical properties. Our proposed low-complexity ICI suppression scheme, which incorporates the Q-tap equalizer with our proposed channel estimator, can significantly improve the performance of the OFDM systems in a fast time-varying fading channels. At the last part of the dissertation, an alternative ICI mitigation approach, which is based on the ICI self-cancellation coding, is also discussed. The EM-based approach, which solves the phase and amplitude ambiguities associated with this approach, is also introduced

Joint array combining and MLSE for single-user receivers in multipath Gaussian multiuser channels

The well-known structure of an array combiner along with a maximum likelihood sequence estimator (MLSE) receiver is the basis for the derivation of a space-time processor presenting good properties in terms of co-channel and intersymbol interference rejection. The use of spatial diversity at the receiver front-end together with a scalar MLSE implies a joint design of the spatial combiner and the impulse response for the sequence detector. This is faced using the MMSE criterion under the constraint that the desired user signal power is not cancelled, yielding an impulse response for the sequence detector that is matched to the channel and combiner response. The procedure maximizes the signal-to-noise ratio at the input of the detector and exhibits excellent performance in realistic multipath channels.Peer Reviewe

Interference mitigation and awareness for improved reliability

Wireless systems are commonly affected by interference from various sources. For example, a number of users that operate in the same wireless network can result in multiple-access interference (MAI). In addition, for ultrawideband (UWB) systems, which operate at very low power spectral densities, strong narrowband interference (NBI) can have significant effects on the communications reliability. Therefore, interference mitigation and awareness are crucial in order to realize reliable communications systems. In this chapter, pulse-based UWB systems are considered, and the mitigation of MAI is investigated first. Then, NBI avoidance and cancelation are studied for UWB systems. Finally, interference awareness is discussed for short-rate communications, next-generation wireless networks, and cognitive radios.Mitigation of multiple-access interference (MAI)In an impulse radio ultrawideband (IR-UWB) communications system, pulses with very short durations, commonly less than one nanosecond, are transmitted with a low-duty cycle, and information is carried by the positions or the polarities of pulses [1-5]. Each pulse resides in an interval called frame, and the positions of pulses within frames are determined according to time-hopping (TH) sequences specific to each user. The low-duty cycle structure together with TH sequences provide a multiple-access capability for IR-UWB systems [6].Although IR-UWB systems can theoretically accommodate a large number of users in a multiple-access environment [2, 4], advanced signal processing techniques are necessary in practice in order to mitigate the effects of interfering users on the detection of information symbols efficiently [6]. © Cambridge University Press 2011