A framework for the selection of the right nuclear power plant

Civil nuclear reactors are used for the production of electrical energy. In the nuclear industry vendors propose several nuclear reactor designs with a size from 35–45 MWe up to 1600–1700 MWe. The choice of the right design is a multidimensional problem since a utility has to include not only financial factors as levelised cost of electricity (LCOE) and internal rate of return (IRR), but also the so called “external factors” like the required spinning reserve, the impact on local industry and the social acceptability. Therefore it is necessary to balance advantages and disadvantages of each design during the entire life cycle of the plant, usually 40–60 years. In the scientific literature there are several techniques for solving this multidimensional problem. Unfortunately it does not seem possible to apply these methodologies as they are, since the problem is too complex and it is difficult to provide consistent and trustworthy expert judgments. This paper fills the gap, proposing a two-step framework to choosing the best nuclear reactor at the pre-feasibility study phase. The paper shows in detail how to use the methodology, comparing the choice of a small-medium reactor (SMR) with a large reactor (LR), characterised, according to the International Atomic Energy Agency (2006), by an electrical output respectively lower and higher than 700 MWe

Risk assessment of blasting operations in open pit mines using FAHP method

Purpose. In the mining blasting operation, fragmentation is the most important output. Fly rock, ground vibration, air blast, and environmental effects are detrimental effects of blasting operations. Identifying and ranking the risk of blasting operations is considered as the most important stage in project management. Methods. In this research, the problem of identifying and ranking the factors constituting the risk in blasting operations is considered with the methodology of the Fuzzy Analytical Hierarchy Process (FAHP). Criteria and sub-criteria have been determined based on historical research studies, field studies, and expert opinions for designing a hierarchical process. Findings. Based on FAHP scores, non-control of the sub-criterion of health and safety (C3), blast operation results (C18) and knowledge, and skill and staffing (C2) with a score of 0.377, 0.334, and 0.294 respectively are the most effective sub-criterion for the creation of blasting operations risk. According to the score, the sub-criterion C18 is the most effective sub-criterion in providing the blasting operations risk. Effects and results of blasting operations (D8), with a score of 0.334 as the most effective criterion, and natural hazards (D10), with a score of 0.015, were the last priorities in the factors causing blasting operations risk. Originality. Regarding the risk rating of blasting operations, the control of the sub-criteria C3, C18, and C2, and the D8 criterion, is of particular importance in reducing the risk of blasting operations and improving project management. Practical implications. The evaluation of human resource performance and increase in the level of knowledge and skills and occupational safety and control of all outputs of blasting operations is necessary. Therefore, selecting the most important project risks and taking actions to remove them is essential for risk management.Мета. Визначення ризиків проведення вибухових робіт та їх оцінка на основі використанням нечіткого методу аналізу ієрархій (НМАІ) для покращення управління якістю проектів. Методика. В рамках даного дослідження, проблеми визначення та оцінки ризиків вибухових робіт розглядалися із застосуванням нечіткого методу аналізу ієрархій. На базі аналізу історичних даних і польового дослідження з урахуванням експертних оцінок були визначені критерії та підкритерії для побудови ієрархій. Результати. За результатами НМАІ, неконтролюючий підкритерій здоров’я та безпеки (С3), підкритерій результатів вибухових робіт (С18), знань, умінь і кадрів (С2) зі значеннями 0.377, 0.334 і 0.294 відповідно найбільш ефективні в появі ризику проведення вибухових робіт. Підкритерій С18 чинить найбільший вплив на ризик проведення вибухових робіт. Критерій результатів і наслідків вибухових робіт (D8) з найефективнішим значенням 0.334 та критерій природних катастроф (D10) зі значенням 0.015 є останніми пріоритетами серед чинників, які визначають ризик проведення вибухових робіт. Наукова новизна. Отримав доповнення та подальший розвиток науково-методичний підхід до визначення ризиків при проведенні вибухових робіт, заснований на їх ранжуванні з використанням системи виявлених критеріїв і підкритеріїв методом НМАІ. Практична значимість. Для успішного керування проектом важливо визначати найсерйозніші ризики проекту й вжити заходів щодо їх усунення. Відносно ранжирування ризиків проведення вибухових робіт управління підкритеріями C3, C18 і C2, а також критерієм D8, особливо важливо для зниження цих ризиків та покращення якості управління проектом.Цель. Определение рисков проведения взрывных работ и их оценка на основе использования нечеткого метода анализа иерархий (НМАИ) для улучшения управления качеством проектов. Методика. В рамках данного исследования, проблемы определения и оценки рисков взрывных работ рассматривались с применением нечеткого метода анализа иерархий. На базе анализа исторических данных и полевого исследования с учетом экспертных оценок были определены, критерии и подкритерии для построения иерархий. Результаты. По результатам НМАИ, неконтролирующий подкритерий здоровья и безопасности (С3), подкритерий результатов взрывных работ (С18), знаний, умений и кадров (С2) со значениями 0.377, 0.334 и 0.294 соответственно наиболее эффективны в появлении риска проведения взрывных работ. Подкритерий С18 оказывает самое большое влияние на риск проведения взрывных работ. Критерий результатов и последствий взрывных работ (D8) с самым эффективным значением 0.334 и критерий природных катастроф (D10) со значением 0.015 являются последними приоритетами среди факторов, которые определяют риск проведения взрывных работ. Научная новизна. Получил дополнение и дальнейшее развитие научно-методический подход к определению рисков при проведении взрывных работ, основанный на их ранжировании с использованием системы выявленных критериев и подкритериев методом НМАИ. Практическая значимость. Для успешного руководства проектом важно определять самые серьезные риски проекта и предпринять действия по их устранению. В отношении ранжирования рисков проведения взрывных работ управление подкритериями C3, C18 и C2, а также критерием D8, особенно важно для снижения этих рисков и улучшения руководства проектом.The authors would like to thank Mining Engineering Department, Islamic Azad University (South Tehran Branch) for supporting this research

InSiDDe: A server for designing artificial disordered proteins

InSiDDe (In Silico Disorder Design) is a program for the in silico design of intrinsically disordered proteins of desired length and disorder probability. The latter is assessed using IUPred and spans values ranging from 0.55 to 0.95 with 0.05 increments. One to ten artificial sequences per query, each made of 50 to 200 residues, can be generated by InSiDDe. We describe the rationale used to set up InSiDDe and show that an artificial sequence of 100 residues with an IUPred score of 0.6 designed by InSiDDe could be recombinantly expressed in E. coli at high levels without degradation when fused to a natural molecular recognition element (MoRE). In addition, the artificial fusion protein exhibited the expected behavior in terms of binding modulation of the specific partner recognized by the MoRE. To the best of our knowledge, InSiDDe is the first publicly available software for the design of intrinsically disordered protein (IDP) sequences. InSiDDE is publicly available online

Investors’ preference order of fuzzy numbers

AbstractNowadays greater and greater realistic financial problems are modeled by using the stochastic programming in the fuzzy environment. Hence, ranking a set of fuzzy numbers that is consistent with the investors’ preference becomes important for modelling a realistic problem. In this paper, we will provide a new ranking procedure that is consistent with the preference of the conservative investors. Our ranking procedure satisfies the axioms of three order relations for the separable fuzzy numbers or the triangle fuzzy numbers. We found that our ranking procedure has a better capability of discriminating the order of two fuzzy numbers. For the LR-type fuzzy numbers, our ranking procedure reduces the computational time substantially

An integrated approach for solving a MCDM problem, Combination of Entropy Fuzzy and F-PROMETHEE techniques

Purpose: The intention of this paper is the presentation of a new integrated approach for solving a multi attribute decision making problem by the use of Entropy Fuzzy and F- PROMETHEE (fuzzy preference ranking method for enrichment evaluation) techniques. Design/methodology/approach: In these sorts of multi attribute decision making problem, a number of criteria and alternatives are put forward as input data. Ranking of these alternatives according to mentioned criteria is regarded as the outcome of solving these kinds of problems. Initially, weights of criteria are determined by implementation of Entropy Fuzzy method. According to determined weights, F-PROMETHEE method is exerted to rank these alternatives in terms of desirability of DM (decision maker). Findings: Being in an uncertain environment and vagueness of DM’s judgments, lead us to implement an algorithm which can deal with these constraints properly. This technique namely called Entropy Fuzzy as a weighting method and F-PROMETHEE is performed to fulfill this approach more precisely according to tangible and intangible aspects. The main finding of applied approach is the final ranking of alternatives helping DM to have a more reliable decision. Originality/Value: The main contribution of this approach is the giving real significance to DM’s attitudes about mentioned criteria in determined alternatives which is not elucidate in former approaches like Analytical Hierarchy Process (AHP). Furthermore, previous methods like Shanon Entropy do not pay attention sufficiently to satisfaction degree of each criterion in proposed alternatives, regarding to DM’s statements. Comprehensive explanations about these procedures have been made in miscellaneous sections of this article.Peer Reviewe