Millimeter-wave Evolution for 5G Cellular Networks

Triggered by the explosion of mobile traffic, 5G (5th Generation) cellular network requires evolution to increase the system rate 1000 times higher than the current systems in 10 years. Motivated by this common problem, there are several studies to integrate mm-wave access into current cellular networks as multi-band heterogeneous networks to exploit the ultra-wideband aspect of the mm-wave band. The authors of this paper have proposed comprehensive architecture of cellular networks with mm-wave access, where mm-wave small cell basestations and a conventional macro basestation are connected to Centralized-RAN (C-RAN) to effectively operate the system by enabling power efficient seamless handover as well as centralized resource control including dynamic cell structuring to match the limited coverage of mm-wave access with high traffic user locations via user-plane/control-plane splitting. In this paper, to prove the effectiveness of the proposed 5G cellular networks with mm-wave access, system level simulation is conducted by introducing an expected future traffic model, a measurement based mm-wave propagation model, and a centralized cell association algorithm by exploiting the C-RAN architecture. The numerical results show the effectiveness of the proposed network to realize 1000 times higher system rate than the current network in 10 years which is not achieved by the small cells using commonly considered 3.5 GHz band. Furthermore, the paper also gives latest status of mm-wave devices and regulations to show the feasibility of using mm-wave in the 5G systems.Comment: 17 pages, 12 figures, accepted to be published in IEICE Transactions on Communications. (Mar. 2015

A comparison of digital transmission techniques under multichannel conditions at 2.4 GHz in the ISM BAND

In order to meet the observation quality criteria of micro-UAVs, and particularly in the context of the « Trophée Micro-Drones », ISAE/SUPAERO is studying technical solutions to transmit a high data rate from a video payload onboard a micro-UAV. The laboratory has to consider the impact of multipath and shadowing effects on the emitted signal. Therefore fading resistant transmission techniques are considered. This techniques paper have to reveal an optimum trade-off between three parameters, namely: the characteristics of the video stream, the complexity of the modulation and coding scheme, and the efficiency of the transmission, in term of BER

Performance evaluation of broadband fixed wireless system based on IEEE 802.16

Fixed Wireless Access systems operating below 11 GHz have the potential to provide broadband wireless access for non line-of-sight operation. In this paper the performance of a typical broadband fixed wireless system based on the IEEE 802.16-2004 specifications is determined. A scenario for business applications with outdoor customer premises equipment is investigated in the 3.5 GHz frequency band. Different path loss models and terrain types are considered. Coverage and throughput in a sector are determined for this business scenario

Impact of the propagation model on the capacity in small‐cell networks: comparison between the UHF/SHF and the millimetre wavebands

This work shows how both frequency and the election of path loss model affect estimated spectral efficiency. Six different frequency bands are considered, ranging from 2.6 GHz in the Ultra High Frequency (UHF) band to 73 GHz in the millimetre wave bands (mmWaves), using both single-slope and two-slope path-loss models. We start by comparing four ur ban path loss models for UHF: the urban/vehicular and pedestrian test environment from the ITU-R M. 1255 Report, which includes the two-slope urban micro line-of-sight (LoS) and NLoS, from the ITU-R 2135 Report. Then, we consider mmWaves taking into con26 sideration the modified Friis propagation model, followed by an analysis of the through put for the 2.6, 3.5, 28, 38, 60 and 73 GHz frequency bands. We have found that the signal to-interference-plus-noise ratio, as estimated with the more realistic two-slope model, is lower for devices that are within the break-point of the transmitter, which is a small dis tance in the UHF/SHF band. As a result, spectral efficiency is higher with mmWaves than with UHF/SHF spectrum when cell radius is under 40 meters but not when cells are larger. Consequently, mmWaves spectrum will be more valuable as cells get small. We also find that capacity as estimated with the two-slope model is considerably smaller than one would obtain with the one-slope model when cells are small but there is little difference in the models when cells are larger. Thus, as cells get smaller, the use of one slope models may underestimate the number of cells that must be deployed.info:eu-repo/semantics/acceptedVersio

Efficient Management of Flexible Functional Splits in 5G Second Phase Networks

The fifth mobile network generation (5G), which offers better data speeds, reduced latency, and a huge number of network connections, promises to improve the performance of the cellular network in practically every way available. A portion of the network operations are deployed in a centralized unit in the 5G radio access network (RAN) partially centralized design. By centralizing these functions, operational expenses are decreased and coordinating strategies are made possible. To link centralized units (CU) and distributed units (DU), and the DU to remote radio units (RRU), both the midhaul and fronthaul networks must have higher capacity. The necessary fronthaul capacity is also influenced by the fluctuating instantaneous user traffic. Consequently, the 5G RAN must be able to dynamically change its centralization level to the user traffic to maximize its performance. To try to relieve this fronthaul capacity it has been considered a more flexible distribution between the base band unit (BBU) (or CU and DU if enhanced common public radio interface (eCPRI) is considered) and the RRU. It may be challenging to provide high-speed data services in crowded areas, particularly when there is imperfect coverage or significant interference. Because of this, the macrocell deployment is insufficient. This problem for outdoor users could be resolved by the introduction of low-power nodes with a limited coverage area. In this context, this MSc dissertation explores, in an urban micro cell scenario model A (UMi_A) for three frequency bands (2.6 GHz, 3.5 GHz, and 5.62 GHz), the highest data rate achievable when a numerology zero is used. For this, it was necessary the implementation of the UMi_A in the 5G-air-simulator. Allowing the determination of the saturation level using the results for the packet loss ratio (PLR=2%). By assuming Open RAN (O-RAN) and functional splitting, the performance of two schedulers in terms of quality-of-service (QoS) were also studied. The QoS-aware modified largest weighted delay first (M-LWDF) scheduler and the QoS-unaware proportional fair (PF) scheduler. PLR was evaluated for both schedulers, whilst analyzing the impact of break point distance while changing the frequency band. The costs, revenues, profit in percentage terms, and other metrics were also estimated for the PF and M-LWDF schedulers when used video (VID) and video plus best effort (VID+BE), with or without consideration of the functional splits 7.2 and 6, for the three frequency bands. One concluded that the profit in percentage terms with functional split option 7.2 applied is always slightly higher than with functional split option 6. It reaches a maximum profit of 366.92% in the case of the M-LWDF scheduler, and 305.51% in the case of the PF scheduler, at a cell radius of 0.4 km for the 2.6 GHz frequency band, considering a price of the traffic of 0.0002 €/min.A quinta geração de redes móveis (5G), oferece ritmos de transmissão melhorados, atraso extremo-a-extremo reduzido, e um vasto número de ligações de rede. A 5G promete melhorar o desempenho das redes celulares em praticamente todos os aspectos relevantes. Uma parte da operação da rede é colocada numa unidade centralizada na rede de acesso de rádio (RAN) 5G com dimensionamento parcialmente centralizado. Ao centralizar estas funções, os custos operacionais decrescem, viabilizando-se as estratégias de coordenação. Para ligar as unidades centralizadas e unidades distribuídas, e por sua vez, unidades distribuidas e unidades de rádio remotas, ambos os midhaul e fronthaul devem ter uma capacidade mais elevada. A capacidade da fronthaul necessária é também influenciada pela flutuação do tráfego instantâneo dos utilizadores. Consequentemente, a RAN 5G deve ser capaz de alterar dinamicamente o seu nível de centralização para o tráfego de utilizadores, com objetivo de maximizar o seu desempenho. Para tentar aliviar o aumento da capacidade suportada pelo fronthaul, tem sido considerada uma distribuição mais flexível entre a unidade de banda base, BBU (ou unidade central e unidade distribuída se a interface de rádio pública comum melhorada, eCPRI, for considerada), e a unidade de rádio remota, RRU. Em áreas densamente povoadas, pode ser um desafio fornecer serviços de dados de elevada velocidade, particularmente quando existe uma cobertura deficiente ou interferência significativa. Por este motivo, o desenvolvimento de macrocélulas pode ser insuficiente, mas este problema para utilizadores em ambiente de exterior pode ser mitigado com a introdução de nós de potência reduzida com uma área de cobertura limitada. Neste contexto, esta dissertação de mestrado explora, num cenário urbano de microcélulas caracterizado pelo modelo A (UMi_A) para três bandas de frequência (2.6 GHz, 3.5 GHz, e 5.62 GHz), o débito binário máximo que se pode alcançar quando se utiliza numerologia zero. Para tal, foi necessária a implementação do UMi_A no 5G - air - simulator. Determinou-se o nivel de saturação, considerandose os resultados para a taxa de perda de pacotes (PLR=2%). Estudou-se o desempenho de dois escalonadores de pacotes em termos de qualidade de serviço (QoS), assumindo-se o OpenRAN (O-RAN) e as divisões funcionais (functionalsplitting). Um dos escalonadores é ciente da QoS, e é de atraso máximo-superior ponderado primeiro (M-LWDF), enquanto que o outro não é ciente da QoS, e é de justiça proporcional (PF). Avaliou-se o PLR para ambos os escalonadores de pacotes, estudando-se o impacto da distância de ponto de quebra (breakpointdistance), variando-se a banda de frequências. Foram também estimados os custos, proveitos, o lucro (em percentagem), e outras metricas, para os escalonadores PF e M-LWDF, considerando o vídeo (VID) e vídeo mais besteffort (VID+BE) como aplicações, com ou sem a consideração das divisões funcionais 7.2 e 6, para as três bandas de frequência. Concluiu-se que o lucro em termos percentuais, com a escolha da opção de divisão funcional 7.2, é sempre ligeiramente mais elevado do que com a opção de divisão funcional 6. Atingese um lucro máximo de 366,92% no caso do escalonador M-LWDF, e de 305,51% no caso do escalonador PF, para um raio de célula de 0,4 km, para a banda de frequência de 2,6 GHz, considerando-se um preço do tráfego de 0,0002 €/min