Borrowed Channel Relaying: A Novel Method to Improve Infrastructure Network Throughput

From a networking perspective, the chief impediment to throughput enhancement in infrastructure networks such as IEEE802.11 is the access point bottleneck: all traffic to, through, and from the network has to pass through this access point. When some clients experience poor channel conditions and therefore communicate at a lower data rate, this severely impacts the throughput of all clients in the network. Recently, multihop relaying in combination with leveraging multiple data rates was proposed to alleviate this problem. However, our experiments indicate that gains from these techniques are very small with realistic positioning of clients. Instead, we propose a novel scheme that combines relaying and multiple data rate capabilities with the concept of channel borrowing. Our protocol, BCR (Borrowed Channel Relaying), utilizes unused capacity from neighboring access points and is able to achieve network throughput gains of 20% to 60% depending on the scenario. Although we use 802.11 style networks to illustrate this concept, this general principle can be applied to any infrastructure network with receivers capable of tuning to more than one channel

Deployment analysis of carrier grade urban wireless mesh networks

Proceedings of: IEEE 9th Malaysia International Conference on Communications (MICC 2009), 15-17 December 2009, Kuala Lumpur (Malaysia)An optimized and cost-effective wireless mesh network (WMN) deployment for ubiquitous broadband wireless access is known to be highly dependent on a number of key factors such as backhaul solution, number of radio interfaces per node, type of radio technology, network topology/cluster, etc. The choice of network topology in turn affects the gateway-node ratio, and also the placement of gateways (GW)s and access points (AP)s. In this paper, we provide insights on the best possible upper-bound performance and inter-relationship between these key design factors under different operating conditions with respect to different target data rates per user. Next, we incorporate deployment cost analysis into the corresponding design option studies in order to provide more accurate justification on the feasibility of adopting different clustering techniques. The results from our analysis offer a general guideline or reference for network operators who intend to deploy a uniform blanket coverage using WMN especially in the urban environment.European Community's Seventh Framework ProgramPublicad

QoS constrained cellular ad hoc augmented networks

In this dissertation, based on different design criteria, three novel quality of service (QoS) constrained cellular ad hoc augmented network (CAHAN) architectures are proposed for next generation wireless networks. The CAHAN architectures have a hybrid architecture, in which each MT of CDMA cellular networks has ad hoc communication capability. The CAHAN architectures are an evolutionary approach to conventional cellular networks. The proposed architectures have good system scalability and high system reliability. The first proposed architecture is the QoS constrained minimum-power cellular ad hoc augmented network architecture (QCMP CAHAN). The QCMP CAHAN can find the optimal minimum-power routes under the QoS constraints (bandwidth, packet-delay, or packet-error-rate constraint). The total energy consumed by the MTs is lower in the case of QCMP CAHAN than in the case of pure cellular networks. As the ad hoc communication range of each MT increases, the total transmitted power in QCMP CAHAN decreases. However, due to the increased number of hops involved in information delivery between the source and the destination, the end-to-end delay increases. The maximum end-to-end delay will be limited to a specified tolerable value for different services. An MT in QCMP CAHAN will not relay any messages when its ad hoc communication range is zero, and if this is the case for all MTs, then QCMP CAHAN reduces to the traditional cellular network. A QoS constrained network lifetime extension cellular ad hoc augmented network architecture (QCLE CAHAN) is proposed to achieve the maximum network lifetime under the QoS constraints. The network lifetime is higher in the case of QCLE CAHAN than in the case of pure cellular networks or QCMP CAHAN. In QCLE CAHAN, a novel QoS-constrained network lifetime extension routing algorithm will dynamically select suitable ad-hoc-switch-to-cellular points (ASCPs) according to the MT remaining battery energy such that the selection will balance all the MT battery energy and maximizes the network lifetime. As the number of ASCPs in an ad hoc subnet decreases, the network lifetime will be extended. Maximum network lifetime can be increased until the end-to-end QoS in QCLE CAHAN reaches its maximum tolerable value. Geocasting is the mechanism to multicast messages to the MTs whose locations lie within a given geographic area (target area). Geolocation-aware CAHAN (GA CAHAN) architecture is proposed to improve total transmitted power expended for geocast services in cellular networks. By using GA CAHAN for geocasting, saving in total transmitted energy can be achieved as compared to the case of pure cellular networks. When the size of geocast target area is large, GA CAHAN can save larger transmitted energy

Routing Strategies for Capacity Enhancement in Multi-hop Wireless Ad Hoc Networks

This thesis examines a Distributed Interference Impact Probing (DIIP) strategy for Wireless Ad hoc Networks (WANETs), using a novel cross-layer Minimum Impact Routing (MIR) protocol. Perfonnance is judged in tenns of interference reduction ratio, efficiency, and system and user capacity, which are calculated based on the measurement of Disturbed Nodes (DN). A large number of routing algorithms have been proposed with distinctive features aimed to overcome WANET's fundamental challenges, such as routing over a dynamic topology, scheduling broadcast signals using dynamic Media Access Control (MAC), and constraints on network scalability. However, the scalability problem ofWANET cannot simply adapt the frequency reuse mechanism designed for traditional stationary cellular networks due to the relay burden, and there is no single comprehensive algorithm proposed for it. DIIP enhances system and user capacity using a cross layer routing algorithm, MIR, using feedback from DIIP to balance transmit power in order to control hop length, which consequently changes the number of relays along the path. This maximizes the number of simultaneous transmitting nodes, and minimizes the interference impact, i.e. measured in tenns of 'disturbed nodes'. The perfonnance of MIR is examined compared with simple shortest-path routing. A WANET simulation model is configured to simulate both routing algorithms under multiple scenarios. The analysis has shown that once the transmitting range of a node changes, the total number of disturbed nodes along a path changes accordingly, hence the system and user capacity varies with interference impact variation. By carefully selecting a suitable link length, the neighbouring node density can be adjusted to reduce the total number of DN, and thereby allowing a higher spatial reuse ratio. In this case the system capacity can increase significantly as the number of nodes increases. In contrast, if the link length is chosen regardless ofthe negative impact of interference, capacity decreases. In addition, MIR diverts traffic from congested areas, such as the central part of a network or bottleneck points

이동통신 네트워크에서의 QoS 패킷 스케줄러 설계 및 고정 릴레이 관련 주파수 재사용 관리 기법 연구

학위논문 (박사)-- 서울대학교 대학원 공과대학 전기·컴퓨터공학부, 2017. 8. 박세웅.The main interest of this paper is to understand a basic approach to provide more efficient method to allocate radio resources in the mobile communication systems, especially in which radio resources could be allocated by both frequency and time division multiple access. So, we consider OFDMA system and the ideas described in this paper could be easily applied to the current and next generation mobile communication systems. This paper studies two basic research themesa QoS packet scheduler design and fixed relay resource management policies based on frequency reuse in mobile networks. This paper considers novel scheduler structures that are executable in the environments of multiple traffic classes and multiple frequency channels. To design a scheduler structure for multiple traffic classes, we first propose a scheduler selection rule that uses the priority of traffic class and the urgency level of each packet. Then we relax the barrier of traffic class priority when a high priority packet has some room in waiting time. This gives us a chance to exploit multiuser diversity, thereby giving more flexibility in scheduling. Our considered scheduler can achieve higher throughput compared to the simple extension of conventional modified largest weighted delay first (MLWDF) scheduler while maintaining the delay performance for QoS class traffic. We also design a scheduler structure for multiple frequency channels that chooses a good channel for each user whenever possible to exploit frequency diversity. The simulation results show that our proposed scheduler increases the total system throughput by up to 50% without degrading the delay performance. This paper also introduces radio resource management schemes based on frequency reuse for fixed relay stations in mobile cellular networks. Mobile stations in the cell boundary experience poor spectral efficiency due to the path loss and interference from adjacent cells. Therefore, satisfying QoS requirements of each MS at the cell boundary has been an important issue. To resolve this spectral efficiency problem at the cell boundary, deploying fixed relay stations has been actively considered. In this paper, we consider radio resource management policies based on frequency reuse for fixed relays that include path selection rules, frequency reuse pattern matching, and frame transmission pattern matching among cells. We evaluate performance of each policy by varying parameter values such as relay stations position and frequency reuse factor. Through Monte Carlo simulations and mathematical analysis, we suggest some optimal parameter values for each policy and discuss some implementation issues that need to be considered in practical deployment of relay stations. We also surveyed further works that many researchers have been studied to tackle the similar problems of QoS scheduling and resource management for relay with our proposed work. We expect that there would be more future works by priority-based approach and energy-aware approach for QoS scheduling. Also current trends such as the rising interest in IoT system, discussion of densification of cells and D2D communications in 5G systems make us expect that the researches in these topics related with relays would be popular in the future. We also think that there are many interesting problems regarding QoS support and resource management still waiting to be tackled, especially combined with recent key topics in mobile communication systems such as 5G standardization, AI and NFV/SDN.Chapter 1 Introduction 1 1.1 QoS Packet Scheduler 4 1.2 Fixed Relay Frequency Reuse Policies 6 Chapter 2 Scheduler Design for Multiple Traffic Classes in OFDMA Networks 10 2.1 Proposed Schedulers 10 2.1.1 Scheduler Structures 12 2.1.2 MLWDF scheduler for Multiple Traffic Classes 13 2.1.3 Joint Scheduler 13 2.2 System Model 18 2.3 Performance Evaluation 19 2.3.1 Schedulers for Multiple Traffic Classes 20 2.3.2 Impact of Scheduler Selection Rule 25 2.3.3 Frame Based Schedulers 27 2.3.4 Impact of Partial Feedback 30 2.3.5 Adaptive Threshold Version Schedulers 33 2.4 Conclusion 36 Chapter 3 Frequency Reuse Policies for Fixed Relays in Cellular Networks 40 3.1 System Model 40 3.1.1 Frame Transmission and Frequency Reuse Patterns among RSs 42 3.1.2 Positioning of RSs and Channel Capacity 44 3.1.3 Area Spectral Efficiency 45 3.2 Radio Resource Management Policies Based on Frequency Reuse 46 3.2.1 Path Selection Rule 46 3.2.2 Frequency Reuse and Frame Transmission Pattern Matchings among Cells 52 3.3 Monte Carlo Simulation and Results 53 3.4 Consideration of Practical Issues 80 3.5 Conclusion 81 Chapter 4 Surveys of Further Works 83 4.1 Further Works on QoS Schedulers 83 4.1.1 WiMAX Schedulers 85 4.1.2 LTE Schedulers 92 4.2 Further Works on Radio Resource Management in Relay Systems 98 4.3 Future Challenges 100 Chapter 5 Conclusion 104 Bibliography 107 초록 127Docto

Communications à multi-saut dans un réseau cellulaire : État de l’art & Analyse

La partie accès des réseaux cellulaires génère des problèmes communs liés aux points morts (parties qui ne sont pas couvertes par le réseau) et aux points chauds (parties où le nombre d'utilisateurs est important par rapport aux ressources du réseau). Au cours des quinze dernières années, de nombreuses propositions de recherche ont tenté de résoudre les problèmes cellulaires grâce aux architectures MCN (Multi-hope Cellular Networks), un nouveau paradigme permettant l'extension de la partie accès cellulaire via des réseaux ad hoc. Dans cet article, nous proposons une étude de différentes architectures MCN. Nous identifions les principaux facteurs de classification MCN, nous comparons les architectures proposées avec les avantages et les inconvénients de chacune, puis nous présentons certaines questions ouvertes liées à ce sujet