2,449 research outputs found
Spectrum Modeling of Out-of-Band Intermodulation for Dual-Band RF Amplifiers in OFDM Modulation
Dual-band RF amplifiers play increasingly important roles in next-generation mobile communication systems including 5G, and the out-of-band intermodulation products are often not negligible since they generate interference to adjacent channels. In this article, following our previous modeling of cross-modulation for amplified dual-band signals, an analytical expression of out-of-band intermodulation for dual-band orthogonal frequency-division multiplexing signals is derived using the third-order intercept points IP3. The experimental measurement results validate the proposed analytical expression
Contribution to dimensionality reduction of digital predistorter behavioral models for RF power amplifier linearization
The power efficiency and linearity of radio frequency (RF) power amplifiers (PAs) are critical in wireless communication systems. The main scope of PA designers is to build the RF PAs capable to maintain high efficiency and linearity figures simultaneously. However, these figures are inherently conflicted to each other and system-level solutions based on linearization techniques are required.
Digital predistortion (DPD) linearization has become the most widely used solution to mitigate the efficiency versus linearity trade-off. The dimensionality of the DPD model depends on the complexity of the system. It increases significantly in high efficient amplification architectures when considering current wideband and spectrally efficient technologies. Overparametrization may lead to an ill-conditioned least squares (LS) estimation of the DPD coefficients, which is usually solved by employing regularization techniques. However, in order to both reduce the computational complexity and avoid ill-conditioning problems derived from overparametrization, several efforts have been dedicated to investigate dimensionality reduction techniques to reduce the order of the DPD model.
This dissertation contributes to the dimensionality reduction of DPD linearizers for RF PAs with emphasis on the identification and adaptation subsystem. In particular, several dynamic model order reduction approaches based on feature extraction techniques are proposed. Thus, the minimum number of relevant DPD coefficients are dynamically selected and estimated in the DPD adaptation subsystem. The number of DPD coefficients is reduced, ensuring a well-conditioned LS estimation while demanding minimum hardware resources. The presented dynamic linearization approaches are evaluated and compared through experimental validation with an envelope tracking PA and a class-J PA The experimental results show similar linearization performance than the conventional LS solution but at lower computational cost.La eficiencia energetica y la linealidad de los amplificadores de potencia (PA) de radiofrecuencia (RF) son fundamentales en los sistemas de comunicacion inalambrica. El principal objetivo a alcanzar en el diserio de amplificadores de radiofrecuencia es lograr simultaneamente elevadas cifras de eficiencia y de linealidad. Sin embargo, estas cifras estan inherentemente en conflicto entre si, y se requieren soluciones a nivel de sistema basadas en tecnicas de linealizacion. La linealizacion mediante predistorsion digital (DPD) se ha convertido en la solucion mas utilizada para mitigar el compromise entre eficiencia y linealidad. La dimension del modelo del predistorsionador DPD depende de la complejidad del sistema, y aumenta significativamente en las arquitecturas de amplificacion de alta eficiencia cuando se consideran los actuales anchos de banda y las tecnologfas espectralmente eficientes. El exceso de parametrizacion puede conducir a una estimacion de los coeficientes DPD, mediante minimos cuadrados (LS), mal condicionada, lo cual generalmente se resuelve empleando tecnicas de regularizacion. Sin embargo, con el fin de reducir la complejidad computacional y evitar dichos problemas de mal acondicionamiento derivados de la sobreparametrizacion, se han dedicado varies esfuerzos para investigar tecnicas de reduccion de dimensionalidad que permitan reducir el orden del modelo del DPD. Esta tesis doctoral contribuye a aportar soluciones para la reduccion de la dimension de los linealizadores DPD para RF PA, centrandose en el subsistema de identificacion y adaptacion. En concrete, se proponen varies enfoques de reduccion de orden del modelo dinamico, basados en tecnicas de extraccion de caracteristicas. El numero minimo de coeficientes DPD relevantes se seleccionan y estiman dinamicamente en el subsistema de adaptacion del DPD, y de este modo la cantidad de coeficientes DPD se reduce, lo cual ademas garantiza una estimacion de LS bien condicionada al tiempo que exige menos recursos de hardware. Las propuestas de linealizacion dinamica presentados en esta tesis se evaluan y comparan mediante validacion experimental con un PA de seguimiento de envolvente y un PA tipo clase J. Los resultados experimentales muestran unos resultados de linealizacion de los PA similares a los obtenidos cuando se em plea la solucion LS convencional, pero con un coste computacional mas reducido.Postprint (published version
ワイヤレス通信のための先進的な信号処理技術を用いた非線形補償法の研究
The inherit nonlinearity in analogue front-ends of transmitters and receivers have had primary impact on the overall performance of the wireless communication systems, as it gives arise of substantial distortion when transmitting and processing signals with such circuits. Therefore, the nonlinear compensation (linearization) techniques become essential to suppress the distortion to an acceptable extent in order to ensure sufficient low bit error rate. Furthermore, the increasing demands on higher data rate and ubiquitous interoperability between various multi-coverage protocols are two of the most important features of the contemporary communication system. The former demand pushes the communication system to use wider bandwidth and the latter one brings up severe coexistence problems. Having fully considered the problems raised above, the work in this Ph.D. thesis carries out extensive researches on the nonlinear compensations utilizing advanced digital signal processing techniques. The motivation behind this is to push more processing tasks to the digital domain, as it can potentially cut down the bill of materials (BOM) costs paid for the off-chip devices and reduce practical implementation difficulties. The work here is carried out using three approaches: numerical analysis & computer simulations; experimental tests using commercial instruments; actual implementation with FPGA. The primary contributions for this thesis are summarized as the following three points: 1) An adaptive digital predistortion (DPD) with fast convergence rate and low complexity for multi-carrier GSM system is presented. Albeit a legacy system, the GSM, however, has a very strict requirement on the out-of-band emission, thus it represents a much more difficult hurdle for DPD application. It is successfully implemented in an FPGA without using any other auxiliary processor. A simplified multiplier-free NLMS algorithm, especially suitable for FPGA implementation, for fast adapting the LUT is proposed. Many design methodologies and practical implementation issues are discussed in details. Experimental results have shown that the DPD performed robustly when it is involved in the multichannel transmitter. 2) The next generation system (5G) will unquestionably use wider bandwidth to support higher throughput, which poses stringent needs for using high-speed data converters. Herein the analog-to-digital converter (ADC) tends to be the most expensive single device in the whole transmitter/receiver systems. Therefore, conventional DPD utilizing high-speed ADC becomes unaffordable, especially for small base stations (micro, pico and femto). A digital predistortion technique utilizing spectral extrapolation is proposed in this thesis, wherein with band-limited feedback signal, the requirement on ADC speed can be significantly released. Experimental results have validated the feasibility of the proposed technique for coping with band-limited feedback signal. It has been shown that adequate linearization performance can be achieved even if the acquisition bandwidth is less than the original signal bandwidth. The experimental results obtained by using LTE-Advanced signal of 320 MHz bandwidth are quite satisfactory, and to the authors’ knowledge, this is the first high-performance wideband DPD ever been reported. 3) To address the predicament that mobile operators do not have enough contiguous usable bandwidth, carrier aggregation (CA) technique is developed and imported into 4G LTE-Advanced. This pushes the utilization of concurrent dual-band transmitter/receiver, which reduces the hardware expense by using a single front-end. Compensation techniques for the respective concurrent dual-band transmitter and receiver front-ends are proposed to combat the inter-band modulation distortion, and simultaneously reduce the distortion for the both lower-side band and upper-side band signals.電気通信大学201
Nonlinear Interference Generation in Wideband and Disaggregated Optical Network Architectures
L'abstract è presente nell'allegato / the abstract is in the attachmen
Recommended from our members
Dual-Band and Broadband RF Power Amplifiers for Concurrent Signal Transmission
Broadband power amplifiers are becoming increasingly important for communications andradar phased array applications. Amplifying concurrent signals allows for increased data through- put with carrier aggregation and improved radar tracking performance, among other benefits. However, non-concurrent broadband amplifier design is limited in performance by fundamental matching limitations, and suffers further in the concurrent mode due to signal mixing.
To reduce the cost of phased arrays, a low-cost GaN-on-Si technology is first investigated on which broadband power amplifiers are designed and fabricated. Various passive structures are simulated to validate process stack-up simplifications, along with the design and characterization of a narrowband proof-of-concept X-band power amplifier. Fundamental limitations are summarized and utilized to develop a design procedure for multi-stage power amplifiers with increased gain for phased array applications. This procedure is confirmed with a fabricated matching network. These results are then used in dual-band and broadband power amplifiers designs, which are fabricated with commercially available GaAs and GaN technologies. Hybrid and MMIC implementations in both cover 2-18 GHz in aggregate.
The power amplifier characterization focuses on comparing each implementation in the non- concurrent and concurrent mode to understand the effect each power amplifier has on signal ampli- fication. A new broadband power amplifier architecture is developed to improve the performance of broadband power amplifier amplifying concurrent signals. Results indicate that a PA with this architecture can achieve similar power and efficiency as compared to a standard broadband PA, whereas linearity can be improved and/or simplified using this approach.</p
Nonlinear-Stability Analysis of Higher Order Δ–Σ Modulators for DC and Sinusoidal Inputs
Abstract—The present work that exists on predicting the stability of Δ–Σ modulators is confined to DC input signals and unity quantizer gains. This poses a limitation for numerous Δ–Σ modulator applications. The proposed research work gives the stability curves for DC, sine, and dual sinusoidal inputs for any value of the quantizer gain. The maximum stable input limits for third-, fourth-, and fifth-order Chebyshev-Type-II-based Δ–Σ modulators are established using the describing-function method for DC and sinusoidal inputs. Closed-form mathematical expressions for the gains of the quantizer for higher order Δ–Σ modulators whose inputs are two concurrent sinusoids are derived from first principles. The derived stability curves are shown to agree reasonably well with the simulation results for different types of input signals and amplitudes
Massive MIMO is a Reality -- What is Next? Five Promising Research Directions for Antenna Arrays
Massive MIMO (multiple-input multiple-output) is no longer a "wild" or
"promising" concept for future cellular networks - in 2018 it became a reality.
Base stations (BSs) with 64 fully digital transceiver chains were commercially
deployed in several countries, the key ingredients of Massive MIMO have made it
into the 5G standard, the signal processing methods required to achieve
unprecedented spectral efficiency have been developed, and the limitation due
to pilot contamination has been resolved. Even the development of fully digital
Massive MIMO arrays for mmWave frequencies - once viewed prohibitively
complicated and costly - is well underway. In a few years, Massive MIMO with
fully digital transceivers will be a mainstream feature at both sub-6 GHz and
mmWave frequencies. In this paper, we explain how the first chapter of the
Massive MIMO research saga has come to an end, while the story has just begun.
The coming wide-scale deployment of BSs with massive antenna arrays opens the
door to a brand new world where spatial processing capabilities are
omnipresent. In addition to mobile broadband services, the antennas can be used
for other communication applications, such as low-power machine-type or
ultra-reliable communications, as well as non-communication applications such
as radar, sensing and positioning. We outline five new Massive MIMO related
research directions: Extremely large aperture arrays, Holographic Massive MIMO,
Six-dimensional positioning, Large-scale MIMO radar, and Intelligent Massive
MIMO.Comment: 20 pages, 9 figures, submitted to Digital Signal Processin
Recommended from our members
Constrained pre-equalization accounting for multi-path fading emulated using large RC networks: applications to wireless and photonics communications
Multi-path propagation is modelled assuming a multi-layer RC network with randomly allocated resistors and capacitors to represent the transmission medium. Due to frequency-selective attenuation, the waveforms associated with each propagation path incur path-dependent distortion. A pre-equalization procedure that takes into account the capabilities of the transmission source as well as the transmission properties of the medium is developed. The problem is cast within a Mixed Integer Linear Programming optimization framework that uses the developed nominal RC network model, with the excitation waveform customized to optimize signal fidelity from the transmitter to the receiver. The objective is to match a Gaussian pulse input accounting for frequency regions where there would be pronounced fading. Simulations are carried out with different network realizations in order to evaluate the sensitivity of the solution with respect to changes in the transmission medium mimicking the multi-path propagation. The proposed approach is of relevance where equalization techniques are difficult to implement. Applications are discussed within the context of emergent communication modalities across the EM spectrum such as light percolation as well as emergent indoor communications assuming various modulation protocols or UWB schemes as well as within the context of space division multiplexing
Digital Signal Processing Techniques Applied to Radio over Fiber Systems
The dissertation aims to analyze different Radio over Fiber systems for the front-haul applications. Particularly, analog radio over fiber (A-RoF) are simplest and suffer from nonlinearities, therefore, mitigating such nonlinearities through digital predistortion are studied. In particular for the long haul A-RoF links, direct digital predistortion technique (DPDT) is proposed which can be applied to reduce the impairments of A-RoF systems due to the combined effects of frequency chirp of the laser source and chromatic dispersion of the optical channel. Then, indirect learning architecture (ILA) based structures namely memory polynomial (MP), generalized memory polynomial (GMP) and decomposed vector rotation (DVR) models are employed to perform adaptive digital predistortion with low complexities. Distributed feedback (DFB) laser and vertical capacity surface emitting lasers (VCSELs) in combination with single mode/multi-mode fibers have been linearized with different quadrature amplitude modulation (QAM) formats for single and multichannel cases. Finally, a feedback adaptive DPD compensation is proposed. Then, there is still a possibility to exploit the other realizations of RoF namely digital radio over fiber (D-RoF) system where signal is digitized and transmits the digitized bit streams via digital optical communication links. The proposed solution is robust and immune to nonlinearities up-to 70 km of link length. Lastly, in light of disadvantages coming from A-RoF and D-RoF, it is still possible to take only the advantages from both methods and implement a more recent form knows as Sigma Delta Radio over Fiber (S-DRoF) system. Second Order Sigma Delta Modulator and Multi-stAge-noise-SHaping (MASH) based Sigma Delta Modulator are proposed. The workbench has been evaluated for 20 MHz LTE signal with 256 QAM modulation. Finally, The 6x2 GSa/s sigma delta modulators are realized on FPGA to show a real time demonstration of S-DRoF system. The demonstration shows that S-DRoF is a competitive competitor for 5G sub-6GHz band applications
- …