Efficient Micro-Mobility using Intra-domain Multicast-based Mechanisms (M&M)

One of the most important metrics in the design of IP mobility protocols is the handover performance. The current Mobile IP (MIP) standard has been shown to exhibit poor handover performance. Most other work attempts to modify MIP to slightly improve its efficiency, while others propose complex techniques to replace MIP. Rather than taking these approaches, we instead propose a new architecture for providing efficient and smooth handover, while being able to co-exist and inter-operate with other technologies. Specifically, we propose an intra-domain multicast-based mobility architecture, where a visiting mobile is assigned a multicast address to use while moving within a domain. Efficient handover is achieved using standard multicast join/prune mechanisms. Two approaches are proposed and contrasted. The first introduces the concept proxy-based mobility, while the other uses algorithmic mapping to obtain the multicast address of visiting mobiles. We show that the algorithmic mapping approach has several advantages over the proxy approach, and provide mechanisms to support it. Network simulation (using NS-2) is used to evaluate our scheme and compare it to other routing-based micro-mobility schemes - CIP and HAWAII. The proactive handover results show that both M&M and CIP shows low handoff delay and packet reordering depth as compared to HAWAII. The reason for M&M's comparable performance with CIP is that both use bi-cast in proactive handover. The M&M, however, handles multiple border routers in a domain, where CIP fails. We also provide a handover algorithm leveraging the proactive path setup capability of M&M, which is expected to outperform CIP in case of reactive handover.Comment: 12 pages, 11 figure

Performance Analysis of Multicast Mobility in a Hierarchical Mobile IP Proxy Environment

Mobility support in IPv6 networks is ready for release as an RFC, stimulating major discussions on improvements to meet real-time communication requirements. Sprawling hot spots of IP-only wireless networks at the same time await voice and videoconferencing as standard mobile Internet services, thereby adding the request for multicast support to real-time mobility. This paper briefly introduces current approaches for seamless multicast extensions to Mobile IPv6. Key issues of multicast mobility are discussed. Both analytically and in simulations comparisons are drawn between handover performance characteristics, dedicating special focus on the M-HMIPv6 approach.Comment: 11 pages, 7 figure

Mobile IP: state of the art report

Due to roaming, a mobile device may change its network attachment each time it moves to a new link. This might cause a disruption for the Internet data packets that have to reach the mobile node. Mobile IP is a protocol, developed by the Mobile IP Internet Engineering Task Force (IETF) working group, that is able to inform the network about this change in network attachment such that the Internet data packets will be delivered in a seamless way to the new point of attachment. This document presents current developments and research activities in the Mobile IP area

Multicast broadcast services support in OFDMA-based WiMAX systems [Advances in mobile multimedia]

Multimedia stream service provided by broadband wireless networks has emerged as an important technology and has attracted much attention. An all-IP network architecture with reliable high-throughput air interface makes orthogonal frequency division multiplexing access (OFDMA)-based mobile worldwide interoperability for microwave access (mobile WiMAX) a viable technology for wireless multimedia services, such as voice over IP (VoIP), mobile TV, and so on. One of the main features in a WiMAX MAC layer is that it can provide'differentiated services among different traffic categories with individual QoS requirements. In this article, we first give an overview of the key aspects of WiMAX and describe multimedia broadcast multicast service (MBMS) architecture of the 3GPP. Then, we propose a multicast and broadcast service (MBS) architecture for WiMAX that is based on MBMS. Moreover, we enhance the MBS architecture for mobile WiMAX to overcome the shortcoming of limited video broadcast performance over the baseline MBS model. We also give examples to demonstrate that the proposed architecture can support better mobility and offer higher power efficiency

Roaming Real-Time Applications - Mobility Services in IPv6 Networks

Emerging mobility standards within the next generation Internet Protocol, IPv6, promise to continuously operate devices roaming between IP networks. Associated with the paradigm of ubiquitous computing and communication, network technology is on the spot to deliver voice and videoconferencing as a standard internet solution. However, current roaming procedures are too slow, to remain seamless for real-time applications. Multicast mobility still waits for a convincing design. This paper investigates the temporal behaviour of mobile IPv6 with dedicated focus on topological impacts. Extending the hierarchical mobile IPv6 approach we suggest protocol improvements for a continuous handover, which may serve bidirectional multicast communication, as well. Along this line a multicast mobility concept is introduced as a service for clients and sources, as they are of dedicated importance in multipoint conferencing applications. The mechanisms introduced do not rely on assumptions of any specific multicast routing protocol in use.Comment: 15 pages, 5 figure

Efficient algorithm for mobile multicast using anycast group

The authors present a novel and efficient multicast algorithm that aims to reduce delay and communication cost for the registration between mobile nodes and mobility agents and solicitation for foreign agent services based on the mobile IP. The protocol applies anycast group technology to support multicast transmissions for both mobile nodes and home/foreign agents. Mobile hosts use anycast tunnelling to connect to the nearest available home/foreign agent where an agent is able to forward the multicast messages by selecting an anycast route to a multicast router so as to reduce the end-to-end delay. The performance analysis and experiments demonstrated that the proposed algorithm is able to enhance the performance over existing remote subscription and bidirectional tunnelling approaches regardless of the locations of mobile nodes/hosts<br /

FastM: Design and Evaluation of a Fast Mobility Mechanism for Wireless Mesh Networks

Although there is a large volume of work in the literature in terms of mobility approaches for Wireless Mesh Networks, usually these approaches introduce high latency in the handover process and do not support realtime services and applications. Moreover, mobility is decoupled from routing, which leads to inefficiency to both mobility and routing approaches with respect to mobility. In this paper we present a new extension to proactive routing protocols using a fast mobility extension, FastM, with the purpose of increasing handover performance in Wireless Mesh Networks. With this new extension, a new concept is created to integrate information between neighbor wireless mesh routers, managing locations of clients associated to wireless mesh routers in a certain neighborhood, and avoiding packet loss during handover. The proposed mobility approach is able to optimize the handover process without imposing any modifications to the current IEE 802.11 MAC protocol and use unmodified clients. Results show the improved efficiency of the proposed scheme: metrics such as disconnection time, throughput, packet loss and control overhead are largely improved when compared to previous approaches. Moreover, these conclusions apply to mobility scenarios, although mobility decreases the performance of the handover approach, as expected

Handover Mechanisms in ATM-based Mobile Systems

This paper presents two handover mechanisms that can be used in the access part of an ATM-based mobile system. The first handover mechanism, which is called ¿handover synchronised switching¿ is relatively simple and does not use any ATM multicasting or resynchronisation in the network. It assumes that there is sufficient time available such that all data and history information of the old path can be transferred to the mobile terminal (MT) before the actual handover to the new path takes place. It is possible that the time between a handover decision and the actual handover is too short to end the transmission on the old path gracefully (e.g., ending the interleaving matrix, ending transcoder functions, emptying intermediate buffers). A possible solution to this problem is given by the second handover mechanism, where multicast connections to all possible target radio systems (RAS) are used in the core network. This mechanism is called ¿handover with multicast support