39 research outputs found
Frequency Diversity in Mode-Division Multiplexing Systems
In the regime of strong mode coupling, the modal gains and losses and the
modal group delays of a multimode fiber are known to have well-defined
statistical properties. In mode-division multiplexing, mode-dependent gains and
losses are known to cause fluctuations in the channel capacity, so that the
capacity at finite outage probability can be substantially lower than the
average capacity. Mode-dependent gains and losses, when frequency-dependent,
have a coherence bandwidth that is inversely proportional to the modal group
delay spread. When mode-division-multiplexed signals occupy a bandwidth far
larger than the coherence bandwidth, the mode-dependent gains and losses are
averaged over frequency, causing the outage capacity to approach the average
capacity. The difference between the average and outage capacities is found to
be inversely proportional to the square-root of a diversity order that is given
approximately by the ratio of the signal bandwidth to the coherence bandwidth.Comment: 8 pages, 6 figure
Optical Space Division Multiplexing in Short Reach Multi-Mode Fiber Systems
The application of space division multiplexing to fiber-optic communications is a promising approach to further increase the channel capacity of optical waveguides. In this work, short reach and low-cost optical space division multiplexing systems with intensity modulation and direct detection (IM/DD) are in the focus of interest. Herein, different modes are utilized to generate spatial diversity in a multi-mode fiber. In such IM/DD systems, the process of square-law detection is inherently non-linear. In order to obtain an understanding of the channel characteristics, a system model is developed, which is able to show under which conditions the system can be considered linear in baseband. It is shown that linearity applies in scenarios with low mode cross-talk. This enables the use of linear multiple-input multiple-output (MIMO) signal processing strategies for equalization purposes. In conditions with high mode cross-talk, significant interference occurs, and the transmitted information cannot be extracted at the receiver. Furthermore, a method to determine the power coupling coefficients between mode groups is presented that does not require the excitation of individual modes, and hence it can be realized with inexpensive components. In addition, different optical components are analyzed with respect for their suitability in MIMO setups with IM/DD. The conventional approach with single-mode fiber to multi-mode fiber offset launches and optical couplers as well as a configuration that utilizes multi-segment detection are feasible options for a (2x2) setup. It is further shown that conventional photonic lanterns are not suited for MIMO with IM/DD due to their low mode orthogonality during the multiplexing process. In order to enable higher order MIMO configurations, devices for mode multiplexing and demultiplexing need to be developed, which exhibit a high mode orthogonality on one hand and are low-cost on the other hand
High Dimensional Modulation and MIMO Techniques for Access Networks
Exploration of advanced modulation formats and multiplexing techniques
for next generation optical access networks are of interest as promising
solutions for delivering multiple services to end-users. This thesis addresses
this from two different angles: high dimensionality carrierless amplitudephase
(CAP) and multiple-input multiple-output (MIMO) radio-over-fiber
(RoF) systems.
High dimensionality CAP modulation has been investigated in optical
fiber systems. In this project we conducted the first experimental demonstration
of 3 and 4 dimensional CAP with bit rates up to 10 Gb/s. These
results indicate the potentiality of supporting multiple users with converged
services. At the same time, orthogonal division multiple access
(ODMA) systems for multiple possible dimensions of CAP modulation has
been demonstrated for user and service allocation in wavelength division
multiplexing (WDM) optical access network.
2 x 2 MIMO RoF employing orthogonal frequency division multiplexing
(OFDM) with 5.6 GHz RoF signaling over all-vertical cavity surface
emitting lasers (VCSEL) WDM passive optical networks (PONs). We have
employed polarization division multiplexing (PDM) to further increase the
capacity per wavelength of the femto-cell network. Bit rate up to 1.59 Gbps
with fiber-wireless transmission over 1 m air distance is demonstrated.
The results presented in this thesis demonstrate the feasibility of high
dimensionality CAP in increasing the number of dimensions and their potentially
to be utilized for multiple service allocation to different users.
MIMO multiplexing techniques with OFDM provides the scalability in increasing
spectral effciency and bit rates for RoF systems.
High dimensional CAP and MIMO multiplexing techniques are two
promising solutions for supporting wired and hybrid wired-wireless access
networks
Advanced DSP Techniques for High-Capacity and Energy-Efficient Optical Fiber Communications
The rapid proliferation of the Internet has been driving communication networks closer and closer to their limits, while available bandwidth is disappearing due to an ever-increasing network load. Over the past decade, optical fiber communication technology has increased per fiber data rate from 10 Tb/s to exceeding 10 Pb/s. The major explosion came after the maturity of coherent detection and advanced digital signal processing (DSP). DSP has played a critical role in accommodating channel impairments mitigation, enabling advanced modulation formats for spectral efficiency transmission and realizing flexible bandwidth. This book aims to explore novel, advanced DSP techniques to enable multi-Tb/s/channel optical transmission to address pressing bandwidth and power-efficiency demands. It provides state-of-the-art advances and future perspectives of DSP as well
Ultra Wideband
Ultra wideband (UWB) has advanced and merged as a technology, and many more people are aware of the potential for this exciting technology. The current UWB field is changing rapidly with new techniques and ideas where several issues are involved in developing the systems. Among UWB system design, the UWB RF transceiver and UWB antenna are the key components. Recently, a considerable amount of researches has been devoted to the development of the UWB RF transceiver and antenna for its enabling high data transmission rates and low power consumption. Our book attempts to present current and emerging trends in-research and development of UWB systems as well as future expectations
Recommended from our members
Advances in local area optical data communication systems
This paper reviews optical fibre technology for local area optical communications systems. Technologies used in local systems include single and multimode fibre, single and multimode lasers, optical modulators, photodetectors, wavelength division multiplexing, multilevel modulation formats, electronic packet switching, electronic equalization and error correction. These methods have enabled the local area optical link data rate to increase from 0.1 Gb/s in 1990 to nearly a Tb/s in 2019. The challenges to increasing link data rates further, whilst reducing the transmitted power per bit, at reduced cost are discussed. Potential technical solutions and newly proposed methods which might address these challenges are highlighted