6,270 research outputs found
A low-voltage CMOS multiplier for RF applications
This work is part of a project funded under the Fourth Italian-Maltese Financial Protocol.A low-voltage analog multiplier operating at 1.2 V is presented. The multiplier core consists of four MOS transistors operating in the saturation region. The circuit exploits the quadratic relation between current and voltage of the MOS transistor in saturation. The circuit was designed using standard 0.6 /spl mu/m CMOS technology. Simulation results indicate an IP3 of 4.9 dBm and a spur free dynamic range of 45 dB.peer-reviewe
A Compact Apparatus for Muon Lifetime Measurement and Time Dilation Demonstration in the Undergraduate Laboratory
We describe a compact apparatus that automatically measures the charge
averaged lifetime of atmospheric muons in plastic scintillator using low-cost,
low-power electronics and that measures the stopping rate of atmospheric muons
as a function of altitude to demonstrate relativistic time dilation. The
apparatus is designed for the advanced undergraduate physics laboratory and is
suitable for field measurements.Comment: 5 pages, 2 figure
Vertical III-V Nanowire Transistors for Low-Power Electronics
Power dissipation has been the major challenge in the downscaling of transistor technology. Metal-Oxide-Semiconductor Field-Effect Transistors (MOSFETs) have struggled to keep a low power consumption while still maintaining a high performance due to the low carrier mobilities of Si but also due to their inherent minimum inverse subthreshold slope (S ≥ 60 mV/dec) which is limited by thermionic emission. This thesis work studied the capabilities and limitations of III-V based vertical nanowire n-type Tunneling Field-Effect Transistor (TFET) and p-type MOSFET (PMOS). InAs/InGaAsSb/GaSb heterojunction was employed in the whole study. The main focus was to understand the influence of the device fabrication processes and the structural factors of the nanowires such as band alignment, composition and doping on the electrical performance of the TFET. Optimizations of the device processes including spacer technology improvement, Equivalent Oxide Thickness (EOT) downscaling, and gate underlap/overlap were explored utilizing structural characterizations. Systematic fine tuning of the band alignment of the tunnel junction resultedin achieving the best performing sub-40 mV/dec TFETs with S = 32 mV/decand ION = 4μA/μm for IOFF = 1 nA/μm at VDS = 0.3 V. The suitability of employing TFET for electronic applications at cryogenic temperatures has been explored utilizing experimental device data. The impact of the choice of heterostructure and dopant incorporation were investigated to identify the optimum operating temperature and voltage in different temperature regimes. A novel gate last process self-aligning the gate and drain contacts to the intrinsic and doped segments, respectively was developed for vertical InGaAsSb-GaAsSb core-shell nanowire transistors leading to the first sub-100 mV/dec PMOS with S = 75 mV/dec, significant ION/ IOFF = 104 and IMIN < 1 nA/μm at VDS = -0.5 V
Quantum Transport Simulation of III-V TFETs with Reduced-Order K.P Method
III-V tunneling field-effect transistors (TFETs) offer great potentials in
future low-power electronics application due to their steep subthreshold slope
and large "on" current. Their 3D quantum transport study using non-equilibrium
Green's function method is computationally very intensive, in particular when
combined with multiband approaches such as the eight-band K.P method. To reduce
the numerical cost, an efficient reduced-order method is developed in this
article and applied to study homojunction InAs and heterojunction GaSb-InAs
nanowire TFETs. Device performances are obtained for various channel widths,
channel lengths, crystal orientations, doping densities, source pocket lengths,
and strain conditions
Ultra-wide band energy harvesting for ultra-low power electronics applications
In this work, the feasibility of energy harvesting in the useful UWB band (i.e., 3.1-10.6 GHz) is analytically investigated. A typical UWB communications/EH chain in this band is modeled and analyzed, considering the spectral constraints imposed by the federal communications commission (FCC) to UWB signaling. Based on the developed model, accurate analytical expressions are derived for the average received powers of two common types of impulse radio UWB (IR-UWB) signaling waveforms. Numerical simulations on the system-level show excellent agreement with the obtained analytical expressions. Moreover, the DC power levels expected from spectrally constrained IR-UWB waveforms are extremely low (less than 0.3 microwatt) and, accordingly, provide useful guidelines for the design and development of ULP electronics applications in the sub-microwatt range
Synthesis and Optimization of Reversible Circuits - A Survey
Reversible logic circuits have been historically motivated by theoretical
research in low-power electronics as well as practical improvement of
bit-manipulation transforms in cryptography and computer graphics. Recently,
reversible circuits have attracted interest as components of quantum
algorithms, as well as in photonic and nano-computing technologies where some
switching devices offer no signal gain. Research in generating reversible logic
distinguishes between circuit synthesis, post-synthesis optimization, and
technology mapping. In this survey, we review algorithmic paradigms ---
search-based, cycle-based, transformation-based, and BDD-based --- as well as
specific algorithms for reversible synthesis, both exact and heuristic. We
conclude the survey by outlining key open challenges in synthesis of reversible
and quantum logic, as well as most common misconceptions.Comment: 34 pages, 15 figures, 2 table
The power of glove: Soft microbial fuel cell for low-power electronics
A novel, soft microbial fuel cell (MFC) has been constructed using the finger-piece of a standard laboratory natural rubber latex glove. The natural rubber serves as structural and proton exchange material whilst untreated carbon veil is used for the anode. A soft, conductive, synthetic latex cathode is developed that coats the outside of the glove. This inexpensive, lightweight reactor can without any external power supply, start up and energise a power management system (PMS), which steps-up the MFC output (0.06-0.17 V) to practical levels for operating electronic devices (>3 V). The MFC is able to operate for up to 4 days on just 2 mL of feedstock (synthetic tryptone yeast extract) without any cathode hydration. The MFC responds immediately to changes in fuel-type when the introduction of urine accelerates the cycling times (35 vs. 50 min for charge/discharge) of the MFC and PMS. Following starvation periods of up to 60 h at 0 mV the MFC is able to cold start the PMS simply with the addition of 2 mL fresh feedstock. These findings demonstrate that cheap MFCs can be developed as sole power sources and in conjunction with advancements in ultra-low power electronics, can practically operate small electrical devices.© 2013 Elsevier B.V. All rights reserved
- …